DC-AC INVERTER UNIT PS-M06D05S5-NJ1L-108 (S) (6,5 W DUAL OUTPUTS) (PRELIMINARY INFORMATION) DESCRIPTION : This low profile DC to AC Inverter is developed for dual lamps. Optimized for Sharp: LQ104V1DG61 APPLICABLE LCD: 6.4 to 12 inches double lamp type Lamp Voltage 466 Vrms Lamp Current 6.0 mArms Lamp Start Up Voltage 1500 Vrms (Vin : 5 Vdc) FEATURES : Remote ON/OFF Ext. PWM-Dimming Function RoHS complain (S) TEMPERATURE & HUMDITY : Operating Temperature Range Storage Temperature Range Humidity DIMENSIONS : 5 ± 0.5 122,5 ± 0.5 30,5 ± 0.5 82 ± 0.3 (2) PS-M06D05-NJ1L 29/01/2004 MADE IN GERMANY CN1 1 15 ± 0.3 22,5 ± 0.5 -30°C ~ +70°C -40°C ~ +85°C 95 %RH max CN2 CAUTION HIGH VOLTAGE CN3 1 1 10.0MAX 3 2 - Ø2.5 ± 0.2 2 Unit : mm Weight :20 (g) typ. 1 High Voltage generation area 60mm Note: Please use plastic screw in case of a non-insulating mounting base! Components No. 1 2 Part Discription PCB Connector CN1 Qty. 1 1 Material UL94V-0 (FR-4 or CEM-3) S5B-PH-SM3 Note t=1.6m m JST or equal 3 Connector CN2 + CN3 2 SM02(8.0)B-BHS JST or equal Input side CN1: Pin No. CN 1-1 CN 1-2 CN 1-3 CN 1-4 Symbols Vin GND Ext. PWM N.C. CN 1-5 Vrm t Output side CN2 + CN3: Ratings 5 Vdc Pin No. CN 2-1 CN 2-2 Symbols VHIGH1 N.C. Ratings 466Vrm s (6.0m Arm s ) - 0 ~ 5 Vdc (L activ) CN 2-3 VLOW 0Vdc 0 / 5 Vdc (H activ) Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specification are subject to change without notice. Address: Dörnet 8 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (1) Version 1.0, 26th October 2006 DC-AC INVERTER UNIT PS-M06D05S5-NJ1L-108 (S) (6,5 W DUAL OUTPUTS) (PRELIMINARY INFORMATION) ELECTRICAL CHARACTERISTICS : Parameters Symbols Output Current Output Current Input Current Frequency Open Circuit Voltage Iout Iout Iin F Vopen Note 1 : Note 2: Note 3: Vin (V) 5±0.05 5±0.5 5±0.5 5±0.5 4.75 Conditions Vrmt Tu (°C) (V) 5±0.25 -30 ~ +70 5±0.25 -30 ~ +70 5±0.25 -30 ~ +70 5±0.25 -30 ~ +70 5±0.25 -30 ~ +70 Specification Min. Typ. Max. 5.2 5.0 50 1.500 6.0 6.0 1.6 60 - 6.8 7.0 2.5 70 - Unit Note m Arm s m Arm s Adc kHz Vrm s Dut y Cycle 100 % Please keep minimum of 2mm clearance (all directions) between inverter high voltage area as marked on mechanical drawing and any conductors. Remote ON/OFF (CN1-5) has priority and can not be used in combination with External PWM Dimming (CN1-3). When 'Ext.PWM' (CN1-3) is used 'Vrmt' (CN1-5) should not be connected. The external PWM frequency should be in a range of 100 ~ 500 Hz. For other frequency please request. The optimum is 250 Hz. Here you will normally not get a interference to the vertical sync. frequency. TEST CIRCUIT : SW 1 Operation of unit a Operation b Non operation EXTERNAL PWM-DIMMING ( Remote ON / OFF Detailed Circuit Diagram ): Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specification are subject to change without notice. Address: Dörnet 8 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (2) Version 1.0, 26th October 2006