RF SAW Filter Part Number Package Application Last Modified 802-RF861.0M-A 3.0 x 3.0 SMD iDEN Rx Mar. 2, 2007 . TYPE : iDEN, RF-Rx SAW Filter PART NUMBER : 802-RF861.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Attenuation: Source Impedence (single ended)* Condition Minimum Typical Maximum Units - - 861.0 - MHz 851.0~ 871.0 MHz - 2.5 3.5 dB DC~ 806.0 MHz 27 49 - 806.0~ 825.0 MHz 37 50 - 896.0~ 902.0MHz 28 34 - 905.825~ 924.825 MHz 27 39 - dB 906.0~ 979.0 MHz 37 53 - 1070.0~ 1089.0 MHz 47 51 - 1089.0~ 3000.0 MHz 27 32 - - - 50 - ohm ohm - - 50 - VSWR 851.0~ 871.0 MHz - 1.6 2.0 dB Amplitude Ripple 851.0~ 871.0 MHz - 0.6 1.5 dBp-p Maximum DC Voltage - - - 5 V Maximum Input Power - - - 15 dBm Operating Temperature - -30 - +70 ºC Load Impendance (single ended)* * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: 802-RF861.0M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map