Oscilent Corporation IF SAW Filter | 813-SL140.0M-07 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 813-SL140.0M-07 13.3 x 6.5 SMD Base Station & Repeater Apr 18, 2007 . TYPE : 140.0 MHz Bandpass Filter Low Loss Narrow Bandwidth PART NUMBER : 813-SL140.0M-07 .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units MHz 139.85 140.0 140.15 Insertion Loss at Fo - 12.0 13.5 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Bandwidth at -1.0 dB 6.5 6.7 - MHz Bandwidth at -3.0 dB 7.4 7.6 - MHz Bandwidth at -40.0 dB - 10.4 10.6 MHz Bandwidth at -45.0 dB - 10.8 11.0 MHz Center Frequency - - - - Lower Sidelobe 45 48 - dB Upper Sidelobe Relative Attenuation: 45 50 - dB Amplitude Ripple - 0.4 1.0 dBp-p Group Delay Variation - 60 100 nsec Absolute Delay at Fo - 0.96 - µsec Temperature Coefficient - -94 - ppm/°C *With Matching Network (Reference Testing Environment Circuit as shown) Modifiy Impedance Values as necessary. . PACKAGE OUTLINE (mm) TEST FIXTURE Oscilent Corporation IF SAW Filter | 813-SL140.0M-07 Page 2 of 2 PIN Description IN-11, OUT-5, GROUND-1,2,3,4,6,7,8,9,10,12 FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 813-SL140.0M-07