Oscilent Corporation IF SAW Filter | 813-SL140.0M-28 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 813-SL140.0M-28 13.3 x 6.5 SMD Base Station & Repeater Apr 18, 2007 . TYPE : 140.0 MHz Bandpass Filter Low Loss PART NUMBER : 813-SL140.0M-28 .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency - 140.0 - MHz Insertion Loss at Fo - 14.5 16.0 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Bandwidth at -1.0 dB 27.5 28.0 - MHz Bandwidth at -3.0 dB 28.5 29.0 - MHz Bandwidth at -40.0 dB - 32.8 33.5 MHz - Relative Attenuation: Lower Sidelobe 45 50 - dB Upper Sidelobe 45 50 - dB Amplitude Ripple within +/-13.0 MHz - 0.45 1.0 dBp-p Group Delay Variation (+/-13.0 MHz) - 50 80 nsec Absolute Delay at Fo - 0.91 - µsec Temperature Coefficient - -94 - ppm/°C IN/OUT Return Loss @ Fo - - - dB *With Matching Network (Reference Testing Environment Circuit as shown) Modifiy Impedance Values as necessary. . PACKAGE OUTLINE (mm) TEST FIXTURE Oscilent Corporation IF SAW Filter | 813-SL140.0M-28 Page 2 of 2 PIN Description IN-11,OUT-5,GROUND-1,2,3,4,6,7,8,9,10,12 FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 813-SL140.0M-28