Oscilent Corporation RF SAW Filter | 862-RF1220.0M-B Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 862-RF1220.0M-B 3.0 x 3.0 SMD Wireless Jan. 01, 2007 . TYPE : Wireless, Balanced RF SAW Filter PART NUMBER : 862-RF1220.0M-B .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Condition Minimum Typical Maximum Units - - 1220.0 - MHz 1206.0~ 1234.0 MHz - 4.0 5.7 dB 300.0~ 1118.0 MHz 40 59 - 1118.0~ 1146.0 MHz 45 60 - 1300.0~2000.0MHz 45 59 - 1206.0~ 1234.0 MHz - 1.9 3.5 dBp-p Source Impedence (balanced ended)* - - 200 - ohm Load Impendance (balanced ended)* - - 200 - ohm 1206.0~ 1234.0 MHz - 15 - nsp-p Maximum DC Voltage - - - 3 V Maximum Input Power - - - 0 dBm Operating Temperature - -30 - +85 ºC Stop Band Attenuation: Amplitude Ripple Group Delay Ripple dB * With Matching Network ns . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A In B In C Ground D Ground E Out F Out G Ground H Ground Oscilent Corporation RF SAW Filter | 862-RF1220.0M-B Load Impedance = 200 ohms Source Impedance = 200 ohms WIDEBAND Page 2 of 3 Oscilent Corporation RF SAW Filter | 862-RF1220.0M-B Page 3 of 3 SMITH CHART Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 862-RF1220.0M-B