GaAs IC SPDT Switch With Integral Driver Non-Reflective DC–6 GHz AK006M2-93 Features ■ Integral Driver ±5 V Supply Voltages -93 0.160 0.140 ■ High Isolation, Non-Reflective ■ Broadband DC–6 GHz 0.100 ■ Small Low Cost “Chip on Board” Package 0.060 Description 0.020 0.000 0.140 0.056 0.000 The AK006M2-93 is an IC FET SPDT switch in a low cost “chip on board” package. It features non-reflective matching at each output, broadband performance, with integral driver. This switch can be used in many analog and digital wireless communication systems. Top View Electrical Specifications at 25°C Parameter1 Insertion Frequency6 Loss2 DC–1.0 DC–2.0 DC–4.0 DC–6.0 GHz GHz GHz GHz Isolation DC–1.0 DC–2.0 DC–4.0 DC–6.0 GHz GHz GHz GHz VSWR (I/O) DC–1.0 DC–2.0 DC–4.0 DC–6.0 GHz GHz GHz GHz Min. 48 42 36 26 Typ. Max. Unit 0.7 1.0 1.4 1.8 0.8 1.2 1.6 2.0 dB dB dB dB 52 48 37 30 dB dB dB dB 1.3:1 1.4:1 1.6:1 1.8:1 1.4:1 1.6:1 1.8:1 2.0:1 Typ. Max. Unit 10 20 30 20 40 40 ns ns mV Operating Characteristics at 25°C Parameter Switching Characteristics Condition Frequency Min. Rise, Fall (10/90% or 90/10% RF) On, Off (50% CTL to 90/10% RF) Video Feedthru3 Input Power for 1 dB Compression Intermodulation Intercept Point (IP3) For Two-tone Input Power 13 dBm Control Voltages VLow VHigh Supply Voltages4,5 +5 V @ 1 mA Typ. -5 V @ 4 mA Typ. 1. All measurements made in a 50 Ω system, unless otherwise specified. 2. Insertion loss changes by 0.003 dB/°C. 3. Video feedthru measured with 1 ns risetime pulse and 500 MHz bandwidth. 4. The supply voltage and ground must be connected before TTL voltage is applied. To avoid voltage sequencing refer to the Application Note section, “Driver Protection Circuit.” 0.5–6 GHz 0.001 GHz 20 12 23 15 dBm dBm 0.5–6 GHz 0.001 GHz 34 22 37 26 dBm dBm 0 4 0.5 5.5 V V +4.75 -4.75 +5.25 -5.25 V V 5. Current increases from 4 mA to 5 mA @ 85°C. 6. DC = 300 kHz. Alpha Industries, Inc. [781] 935-5150 • Fax [617] 824-4579 • Email [email protected] • www.alphaind.com Specifications subject to change without notice. 2/00A Powered by ICminer.com Electronic-Library Service CopyRight 2003 1 GaAs IC SPDT Switch With Integral Driver Non-Reflective DC–6 GHz AK006M2-93 Typical Performance Data 70 60 2.0 Isolation (dB) Insertion Loss (dB) 2.5 1.5 1.0 50 40 30 20 0.5 10 0.0 0 1 2 3 4 5 0 6 0 1 2 3 4 5 Frequency (GHz) Frequency (GHz) Insertion Loss vs. Frequency Isolation vs. Frequency Truth Table 6 Absolute Maximum Ratings VCTRL J1–J2 J1–J3 1 Insertion Loss Isolation 0 Isolation Insertion Loss Characteristic Value RF Input Power (RF In) 0.5 W > 500 MHz 0.1 W @ 50 MHz Bias Voltage (VB) +7.0 V, -7.0 V Control Voltage (VC) Pin Out +5 V J1 J2 50 VCTRL -5 V -40°C to +90°C Storage Temperature (TST) -65°C to +150°C Thermal Resistance (ΘJC) 30°C/W GND -93 GND 50 -0.2 V, +7.0 V Operating Temperature (TOP) 0.160 0.150 J3 0.140 0.130 0.112 0.110 0.090 0.070 0.050 0.048 0.030 0.020 Glass 0.140 0.121 0.102 0.038 0.020 0.000 0.010 0.000 Pt/Pd/Au Bottom View The “chip on board” package is a ceramic leadless chip carrier with a ceramic lid, which allows for automatic pick and place. The external terminals and backside ground plane are Pt/Pd/Au, which is highly leach resistant and very tolerant to variations in solder conditions. The glass fingers between contacts prevent the possibility of shorted terminals. The recommended solder attachment is a SN6337 (Pb/SN). 2 Alpha Industries, Inc. [781] 935-5150 • Fax [617] 824-4579 • Email [email protected] • www.alphaind.com Specifications subject to change without notice. 2/00A Powered by ICminer.com Electronic-Library Service CopyRight 2003