MMBT4354 MMBT4354 PNP General Purpose Amplifier • This device is deisgned for use as general purpose amplifiers and switch requiring collector currents to 500mA. • Sourced from process 67. • TN4033A for characteristics. 3 2 SOT-23 1 Mark: 79 1. Base 2. Emitter 3. Collector Absolute Maximum Ratings* Ta=25°C unless otherwise noted Symbol VCEO Collector-Emitter Voltage Parameter Value -60 VCBO Collector-Base Voltage -60 V VEBO Emitter-Base Voltage -5.0 V IC Collector Current -800 mA TJ, TSTG Operating and Storage Junction Temperature Range - 55 ~ 150 °C - Continuous Units V * These ratings are limiting values above which the serviceability of any semiconductor device may be impaired. NOTES: 1) These ratings are based on a maximum junction temperature of 150 degrees C. 2) These are steady state limits. The factory should be consulted on applications involving pulsed or low duty cycle operations Electrical Characteristics Ta=25°C unless otherwise noted Symbol Off Characteristics Parameter Test Condition Min. Max. Units V(BR)CEO Collector-Emitter Sustaining Voltage * IC = -1.0mA, IB = 0 -60 V V(BR)CBO Collector-Base Breakdown Voltage IC = -10µA, IE = 0 -60 V V(BR)EBO Emitter-Base Breakdown Voltage IE = -10µA, IC = 0 -5.0 ICBO Collector Cut-off Current VCB = -50V, IE = 0 -50 nA IEBO Emitter Cut-off Current VEB = -5.0V, VCE = 0 -10 µA V On Characteristics * hFE DC Current Gain VCE = -5V, IC = -0.1mA VCE = -5V, IC = -1.0mA VCE = -5V, IC = -10mA VCE = -5V, IC = -100mA VCE = -5V, IC = -500mA 25 40 50 40 30 500 VCE(sat) Collector-Emitter Saturation Voltage IC = -150mA, IB = -15mA IC = -500mA, IB = -50mA -0.15 -0.50 V V VBE(sat) Base-Emitter Saturation Voltage IC = -150mA, IB = -15mA IC = -500mA, IB = -50mA -0.9 -1.1 V V VBE(on) Base-Emitter On Voltage VCE = -0.5V, IC = -500mA -1.1 V Small Signal Characteristics hfe Small Signal Current Gain IC = -50mA, VCE = -10V, f = 100MHz NF Noise Figure VCE = -10V, IC = -100µA RS = 1.0kΩ, f = 1.0KHz, BW = 1.0Hz 1.0 5.0 2.0 dB Switching Characteristics ton Turn-On Time toff Turn-Off Time IC = -500mA, VCC = -30V IB1 = IB2 = -50mA 100 ns 400 ns * Pulse Test: Pulse Width ≤ 300µs, Duty Cycle ≤ 1.0% ©2003 Fairchild Semiconductor Corporation Rev. A, October 2003 Symbol PD Parameter Total Device Dissipation Derate above 25°C RθJC Thermal Resistance, Junction to Case RθJA Thermal Resistance, Junction to Ambient Max. 350 2.8 Units mW mW/°C °C/W 357 °C/W * Device mounted on FR-4PCB 1.6” × 1.6” × 0.06”. ©2003 Fairchild Semiconductor Corporation Rev. A, October 2003 MMBT4354 Thermal Characteristics Ta=25°C unless otherwise noted MMBT4354 Package Dimensions ±0.10 ±0.10 2.40 0.40 ±0.03 1.30 0.45~0.60 0.20 MIN SOT-23 0.03~0.10 0.38 REF 0.40 ±0.03 +0.05 0.12 –0.023 0.96~1.14 0.97REF 2.90 ±0.10 0.95 ±0.03 0.95 ±0.03 1.90 ±0.03 0.508REF Dimensions in Millimeters ©2003 Fairchild Semiconductor Corporation Rev. A, October 2003 TRADEMARKS The following are registered and unregistered trademarks Fairchild Semiconductor owns or is authorized to use and is not intended to be an exhaustive list of all such trademarks. ACEx™ FACT Quiet Series™ ActiveArray™ FAST® FASTr™ Bottomless™ FRFET™ CoolFET™ CROSSVOLT™ GlobalOptoisolator™ GTO™ DOME™ HiSeC™ EcoSPARK™ I2C™ E2CMOS™ EnSigna™ ImpliedDisconnect™ FACT™ ISOPLANAR™ Across the board. Around the world.™ The Power Franchise™ Programmable Active Droop™ LittleFET™ MICROCOUPLER™ MicroFET™ MicroPak™ MICROWIRE™ MSX™ MSXPro™ OCX™ OCXPro™ OPTOLOGIC® OPTOPLANAR™ PACMAN™ POP™ Power247™ PowerTrench® QFET® QS™ QT Optoelectronics™ Quiet Series™ RapidConfigure™ RapidConnect™ SILENT SWITCHER® SMART START™ SPM™ Stealth™ SuperSOT™-3 SuperSOT™-6 SuperSOT™-8 SyncFET™ TinyLogic® TINYOPTO™ TruTranslation™ UHC™ UltraFET® VCX™ DISCLAIMER FAIRCHILD SEMICONDUCTOR RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. FAIRCHILD DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. LIFE SUPPORT POLICY FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 1. Life support devices or systems are devices or systems 2. A critical component is any component of a life support which, (a) are intended for surgical implant into the body, device or system whose failure to perform can be or (b) support or sustain life, or (c) whose failure to perform reasonably expected to cause the failure of the life support when properly used in accordance with instructions for use device or system, or to affect its safety or effectiveness. provided in the labeling, can be reasonably expected to result in significant injury to the user. PRODUCT STATUS DEFINITIONS Definition of Terms Datasheet Identification Product Status Definition Advance Information Formative or In Design This datasheet contains the design specifications for product development. Specifications may change in any manner without notice. Preliminary First Production This datasheet contains preliminary data, and supplementary data will be published at a later date. Fairchild Semiconductor reserves the right to make changes at any time without notice in order to improve design. No Identification Needed Full Production This datasheet contains final specifications. Fairchild Semiconductor reserves the right to make changes at any time without notice in order to improve design. Obsolete Not In Production This datasheet contains specifications on a product that has been discontinued by Fairchild semiconductor. The datasheet is printed for reference information only. ©2003 Fairchild Semiconductor Corporation Rev. I5