AZ765 on tin ue d ! SPST SUBMINIATURE POWER RELAY FEATURES • • • • • Small footprint Low cost Epoxy sealed version available 10 Amp switching UL, CUR File E43203 CONTACTS GENERAL DATA Arrangement SPST (1 Form A) SPDT (1 Form C) Ratings Resistive load: Max. switched power: 280 W or 1200 VA Max. switched current: 10 A Max. switched voltage: 150* VDC or 400 VAC Life Expectancy Mechanical Electrical Minimum operations 1 x 107 1 x 105 at 10 A 120 VAC Res. Operate Time (typical) 8 ms at nominal coil voltage Release Time (typical) 5 ms at nominal coil voltage (with no coil suppression) *Note: If switching voltage is greater than 30 VDC, special precautions must be taken. Please contact the factory. Rated Load UL, CUR Material Resistance COIL Insulation Resistance 1000 megohms min. at 20°C 500 VDC 50% RH Dropout Greater than 5% of nominal coil voltage Ambient Temperature Operating Storage At nominal coil voltage -40°C (-40°F) to 65°C (149°F) -40°C (-40°F) to 105°C (221°F) Vibration 0.040" (1.5 mm) DA at 10–50 Hz Shock 10 g operating, 100 g damage Enclosure P.B.T. polyester Terminals Tinned copper alloy, P. C. Max. Solder Temp. 270°C (518°F) Max. Solder Time 5 seconds Silver cadmium oxide < 50 milliohms initially (24 V, 1 A voltage drop method) sc Power 10 A at 120 VAC 10 A at 28 VDC Dielectric Strength 2500 Vrms coil to contact (at sea level for 1 min.) 1000 Vrms between open contacts At Pickup Voltage (typical) 253 mW Max. Continuous Dissipation 1.1 W at 20°C (68°F) ambient Max. Solvent Temp. 80°C (176°F) Temperature Rise 42°C (76°F) at nominal coil voltage Max. Immersion Time 30 seconds Max. 105°C (221°F) Weight 6 grams Temperature Di NOTES 1. All values at 20°C (68°F). 2. Relay may pull in with less than “Must Operate” value. 3. Specifications subject to change without notice. ZETTLER electronics GmbH Junkersstrasse 3, D-82178 Puchheim, Germany Tel. +49 89 800 97 0 Fax +49 89 800 97 200 [email protected] www.ZETTLERelectronics.com 2003-06-30 ! AZ765 on tin ue d RELAY ORDERING DATA COIL SPECIFICATIONS Nominal Coil VDC 3 5 6 9 12 18 24 ORDER NUMBER* Must Operate VDC 2.25 Max. Continuous VDC 6.0 Coil Resistance Ohm ± 10% 20 1 Form A 1 Form C AZ765–1A–3D AZ765–1C–3D 3.75 9.9 55 AZ765–1A–5D AZ765–1C–5D 4.5 12.0 80 AZ765–1A–6D AZ765–1C–6D 6.75 18.0 180 AZ765–1A–9D AZ765–1C–9D AZ765–1C–12D 9.0 24.0 320 AZ765–1A–12D 13.5 36.0 720 AZ765–1A–18D AZ765–1C–18D 18.0 48.0 1,280 AZ765–1A–24D AZ765–1C–24D *Add suffix “E” for epoxy sealed version. MECHANICAL DATA PC BOARD LAYOUT .717 [18.2] .402 [10.2] .585 [14.85] .058 [1.48] .500 [12.7] .300 [7.6] .494 [12.55] FORM A .150 [3.8] .012 TYP. [0.3] .051 [1.3] .300 [7.6] 4 x ø.051 [ø1.3] 2 x .018 SQR. [0.45] .055 [1.4] .055 [1.4] .100 [2.54] 5 x ø.051 [ø1.3] FORM C VIEWED TOWARD TERMINALS WIRING DIAGRAM 5 4 5 4 sc .039 TYP. [1.0] 1 3 FORM A 1 2 3 FORM C VIEWED TOWARD TERMINALS Di Dimensions in inches with metric equivalents in parentheses. Tolerance: ± .010" ZETTLER electronics GmbH Junkersstrasse 3, D-82178 Puchheim, Germany Tel. +49 89 800 97 0 Fax +49 89 800 97 200 [email protected] www.ZETTLERelectronics.com 2003-06-30