Part Number: www.SunLED.com ZFAMG10A SURFACE MOUNT DISPLAY Features z0.4 INCH CHARACTER HEIGHT. zLOW CURRENT OPERATION. zHIGH CONTRAST AND LIGHT OUTPUT. zCATEGORIZED FOR LUMINOUS INTENSITY. zMECHANICALLY RUGGED. zGRAY FACE,WHITE SEGMENT. zPACKAGE : 400PCS / REEL. zMOISTURE SENSITIVITY LEVEL : LEVEL 4. zRoHS COMPLIANT. Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ± 0.25(0.01") unless otherwise noted. Operating Characteristics (TA=25°C) 3. Specifications are subject to change without notice. 4.The gap between the reflector and PCB shall not exceed 0.25mm. Absolute Maximum Ratings (TA=25°C) MG (GaP) Unit Reverse Voltage VR 5 V Forward Current IF 25 mA Forward Current (Peak) 1/10 Duty Cycle 0.1ms Pulse Width iFS 140 mA Power Dissipation PT 62.5 mW Operating Temperature TA -40 ~ +85 Tstg -40 ~ +85 Storage Temperature Part Number ZFAMG10A Emitting Color Green Published Date : MAR 03,2008 Emitting Material GaP °C Luminous Intensity (IF=10mA) ucd min. typ. 1900 7490 Drawing No : SDSA5411 MG (GaP) Unit Forward Voltage (Typ.) (IF=10mA) VF 2.0 V Forward Voltage (Max.) (IF=10mA) VF 2.5 V Reverse Current (Max.) (VR=5V) IR 10 uA Wavelength of Peak Emission (Typ.) (IF=10mA) λP 565 nm Wavelength of Dominant Emission (Typ.) (IF=10mA) λD 568 nm Spectral Line Full Width At Half-Maximum (Typ.) (IF=10mA) Δλ 30 nm Capacitance (VF=0V, f=1MHz) C 15 pF Wavelength nm λP Description 565 Common Anode. Rt. Hand Decimal V2 Checked : Shin Chi P.1/4 Part Number: www.SunLED.com ZFAMG10A SURFACE MOUNT DISPLAY MG Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity / luminous flux or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity / Luminous Flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. Published Date : MAR 03,2008 Drawing No : SDSA5411 V2 Checked : Shin Chi P.2/4 Part Number: www.SunLED.com ZFAMG10A SURFACE MOUNT DISPLAY Recommended Soldering Pattern (Units : mm;Tolerance:± 0.15) Tape Specification (Units : mm) Published Date : MAR 03,2008 Drawing No : SDSA5411 V2 Checked : Shin Chi P.3/4 Part Number: www.SunLED.com SURFACE MOUNT DISPLAY PACKING & LABEL SPECIFICATIONS Published Date : MAR 03,2008 ZFAMG10A Drawing No : SDSA5411 ZFAMG10A V2 Checked : Shin Chi P.4/4