LBBA12W Part Number: T-1 3/4 (5mm) SOLID STATE LAMP www.SunLED.com PRELIMINARY SPEC Features z LOW POWER CONSUMPTION. z POPULAR T-1 3/4 DIAMETER PACKAGE. z GENERAL PURPOSE LEADS. z RELIABLE AND RUGGED. z LONG LIFE - SOLID STATE RELIABILITY. z AVAILABLE ON TAPE AND REEL. z RoHS COMPLIANT. ATTENTION OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ± 0.25(0.01") unless otherwise noted. 3.Specifications are subject to change without notice. ZAbsolute Maximum Ratings (TA=25°C) Operating Characteristics (TA=25°C) BBA (InGaN) Unit BBA (InGaN) Unit Forward Voltage (Typ.) (IF=20mA) VF 3.2 V Reverse Voltage VR 5 V Forward Current IF 30 mA Forward Voltage (Max.) (IF=20mA) VF 4.0 V Forward Current (peak) 1/10 Duty Cycle 0.1ms Pulse Width iFS 100 mA Reverse Current (Max.) (VR=5V) IR 10 uA Power Dissipation PT 120 mW λP 468 nm Operating Temperature TA -40 ~ +85 Wavelength Of Peak Emission (Typ.) (IF=20mA) Tstg -40 ~ +85 Wavelength Of Dominant Emission (Typ.) (IF=20mA) λD 470 nm Δλ 21 nm C 100 pF Storage Temperature Electrostatic Diacharge Threshold (HBM) °C 1000 V Lead Solder Temperature [2mm Below Package Base] 260°C For 3 Seconds Spectral Line Full Width At Half-Maximum (Typ.) (IF=20mA) Lead Solder Temperature [5mm Below Package Base] 260°C For 5 Seconds Capacitance (Typ.) (VF=0V, f=1MHz) Part Number LBBA12W Emitting Color Blue Published Date : MAR 26, 2008 Emitting Material InGaN Luminous Intensity (IF=20mA) mcd Lens-color Water Clear Drawing No : SDSA4800 V4 min. typ. 280 995 Wavelength nm λP Viewing Angle 2 θ 1/2 468 16° Checked : B.L.LIU P.1/4 Part Number: LBBA12W T-1 3/4 (5mm) SOLID STATE LAMP www.SunLED.com BBA Published Date : MAR 26, 2008 Drawing No : SDSA4800 V4 Checked : B.L.LIU P.2/4 Part Number: LBBA12W T-1 3/4 (5mm) SOLID STATE LAMP www.SunLED.com Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity / luminous flux or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity / luminous flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. Published Date : MAR 26, 2008 Drawing No : SDSA4800 V4 Checked : B.L.LIU P.3/4 Part Number: T-1 3/4 (5mm) SOLID STATE LAMP www.SunLED.com PACKING & LABEL SPECIFICATIONS Published Date : MAR 26, 2008 LBBA12W Drawing No : SDSA4800 LBBA12W V4 Checked : B.L.LIU P.4/4