RoHS Compliant GaAs SPDT Switch DC - 3.0 GHz MASWSS0166 V2 Features Functional Schematic • • • • • • • • Positive Control Voltage Low Insertion Loss: 0.3 dB @ 900 MHz Low Current Consumption: <15 µA @ +2.5 V Positive or Negative 2.5 to 8 V Control Lead-Free SOT-363 Package 100% Matte Tin Plating over Copper Halogen-Free “Green” Mold Compound 260°C Reflow Compatible RoHS* Compliant Version of SW-437 Description M/A-COM’s MASWSS0166 is a GaAs monolithic switch in a lead-free SOT-363 surface mount plastic package. The MASWSS0166 is ideally suited for applications where very low power consumption, low insertion loss, very small size and low cost are required. Functional Schematic Negative Control Voltage Typical applications are dual band systems that require switching between small signal components such as filter banks, single band LNA’s and converters. The MASWSS0166 can be used in applications up to 0.25 Watts in systems such as cellular, PCS, DCS1800, GSM, CDMA, W-CDMA and other analog/digital wireless communications systems. The MASWSS0166 is fabricated using a mature 0.5 micron GaAs PHEMT process. The process features full passivation for increased performance and reliability. Absolute Maximum Ratings Pin Configuration Pin No. Function Description 1 RF1 RF in/out 2 GND RF Ground 3 RF2 RF in/out 4 V2 V Control 2 5 RFC RF Common 6 V1 V Control 1 1,2 Parameter Absolute Maximum Input Power (0.5-3.0 GHz) 3 V Control 5 V Control +30 dBm +33 dBm Operating Voltage +8.5 Volts Operating Temperature -40°C to +85°C Storage Temperature -65°C to +150°C 1. Exceeding any one or combination of these limits may cause permanent damage to this device. 2. M/A-COM does not recommend sustained operation near these survivability limits. Ordering Information Part Number Package MASWSS0166 Bulk Packaging MASWSS0166TR-3000 3000 piece reel MASWSS0166SMB Sample Test Board Note: Reference Application Note M513 for reel size information. * Restrictions on Hazardous Substances, European Union Directive 2002/95/EC. 1 M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/A-COM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/A-COM assume any liability whatsoever arising out of the use or application of any product(s) or information. • North America Tel: 800.366.2266 / Fax: 978.366.2266 • Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300 • Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298 Visit www.macom.com for additional data sheets and product information. RoHS Compliant GaAs SPDT Switch DC - 3.0 GHz MASWSS0166 V2 Electrical Specifications: TA = 25°C, Vc = 0 V / -2.5 V, Z0 = 50Ω3 Parameter Test Conditions Units Min. Typ. Max. Insertion Loss DC - 1 GHz 1 - 2 GHz 2 - 3 GHz dB dB dB — — — 0.3 0.4 0.55 0.4 0.5 0.7 Isolation DC - 1 GHz 1 - 2 GHz 2 - 3 GHz dB dB dB 19 13 10 21 15 12 — — — VSWR DC - 3 GHz Ratio — 1.2:1 — P1dB 500 MHz - 3 GHz, Vc = 2.7 V dBm — 24 — P1dB 500 MHz - 3 GHz, Vc = 5 V dBm — 27 — Input IP2 2-Tone, 900 MHz, 5 MHz spacing, Vc = 2.7 V dBm — 81 — Input IP3 2-Tone 900 MHz, 5 MHz spacing, Vc = 2.7V dBm — 55 — Trise, Tfall Ton, Toff Transients 10% to 90% RF, 90% to 10% RF 50% Control to 90% RF, 50% Control to 10% RF In-Band nS nS mV — — — 10 20 10 — — — Control Current Vc = 2.5 V µA — 4 15 3. For positive voltage control, external DC blocking capacitors are required on all RF ports. Lead-Free SOT-363 Plastic Package† Truth Table 4,5 V1 V2 RFC-RF1 RFC-RF2 0 1 On Off 1 0 Off On 4. Differential voltage, V(state 1) - V(state 0), must be +2.5 V minimum and must not exceed 8 V. 5. 0 = -8 V to 0 V, 1 = -5.5 V to 8 V Handling Procedures Please observe the following precautions to avoid damage: Static Sensitivity † Reference Application Note M538 for lead-free solder reflow recommendations. 2 M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/A-COM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/A-COM assume any liability whatsoever arising out of the use or application of any product(s) or information. Gallium Arsenide Integrated Circuits are sensitive to electrostatic discharge (ESD) and can be damaged by static electricity. Proper ESD control techniques should be used when handling these devices. • North America Tel: 800.366.2266 / Fax: 978.366.2266 • Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300 • Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298 Visit www.macom.com for additional data sheets and product information. RoHS Compliant GaAs SPDT Switch DC - 3.0 GHz MASWSS0166 V2 Typical Performance Curves Insertion Loss (Negative Voltage Control) Insertion Loss (Positive Voltage Control) 1.0 1.0 0.8 -40°C +25°C +85°C 0.6 0.6 0.4 0.4 0.2 0.2 0.0 0.0 0.5 -40°C +25°C +85°C 0.8 1.0 1.5 2.0 2.5 3.0 0.0 0.0 0.5 1.0 1.5 2.0 2.5 3.0 2.5 3.0 Frequency (GHz) Frequency (GHz) VSWR Isolation 40 1.5 35 Negative Control Positive Control 1.4 30 1.3 25 1.2 20 1.1 15 10 0.0 0.5 1.0 1.5 2.0 2.5 3.0 Frequency (GHz) 3 M/A-COM Inc. and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. M/A-COM makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does M/A-COM assume any liability whatsoever arising out of the use or application of any product(s) or information. 1.0 0.0 0.5 1.0 1.5 2.0 Frequency (GHz) • North America Tel: 800.366.2266 / Fax: 978.366.2266 • Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300 • Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298 Visit www.macom.com for additional data sheets and product information.