C8051F019 25 MIPS, 16 kB Flash, 10-Bit ADC, 48-Pin Mixed-Signal MCU Analog Peripherals High-Speed 8051 µC Core - 10-Bit ADC - ±1 LSB INL; no missing codes Programmable throughput up to 100 ksps 8 external inputs; programmable as single-ended or differential Data-dependent windowed interrupt generator Built-in temperature sensor (±3 °C) - Memory - Two Comparators - 16 programmable hysteresis values Configurable to generate interrupts or reset - On-Chip JTAG Debug & Boundary Scan - 1280 bytes data RAM 16 kB Flash; in system programmamble in 512-byte sectors (512 bytes are reserved) Digital Peripherals Internal Voltage Reference VDD Monitor/Brown-out Detector - Pipelined instruction architecture; executes 70% of instructions in 1 or 2 system clocks Up to 25 MIPS throughput with 25 MHz system clock Expanded interrupt handler On-chip debug circuitry facilitates full speed, non-intrusive in-system debug (no emulator required) Provides breakpoints, single stepping, watchpoints, stack monitor Inspect/modify memory and registers Superior performance to emulation systems using ICE-chips, target pods, and sockets IEEE1149.1 compliant boundary scan - 16 port I/O; all are 5 V tolerant Hardware SMBus™ (I2C™ compatible), SPI™, and UART serial ports available concurrently Programmable 16-bit counter/timer array with five capture/compare modules 4 general-purpose 16-bit counter/timers Dedicated watchdog timer; bidirectional reset Clock Sources - Internal programmable oscillator: 2–16 MHz External oscillator: Crystal, RC, C, or Clock Can switch between clock sources on-the-fly Supply Voltage: 2.8 to 3.6 V - Typical operating current: 12.5 mA at 25 MHz Multiple power saving sleep and shutdown modes 48-Pin TQFP Temperature Range: –40 to +85 °C VDD VDD DGND DGND DGND DGND AV+ AV+ AGND AGND Digital Power UART SMBus SPI Bus Analog Power TCK TMS TDI TDO JTAG Logic 5-Chnl PCA Boundary Scan Debug HW Reset RST VDD Monitor External Oscillator Circuit XTAL1 XTAL2 WDT System Clock Internal Oscillator VREF AIN0.0 AIN0.1 AIN0.2 AIN0.3 AIN0.4 AIN0.5 AIN0.6 AIN0.7 CP0+ CP0CP1+ CP1- 8 0 5 1 C o r e 16 kB FLASH Timers 0,1,2 256 Byte RAM Timer 3 1024 Byte XRAM Port 0 Latch Port 1 Latch Port 2 Latch SFR Bus Port 3 Latch C R O S S B A R S W I T C H P 0 D r v P 1 D r v P0.0 P0.1 P0.2 P0.3 P0.4 P0.5 P0.6 P0.7 P1.0 P1.1 P1.2 P1.3 P1.4 P1.5 P1.6 P1.7 P 2 D r v P 3 D r v VREF ADC 100 ksps (10-Bit) A M U X NC NC TEMP SENSOR CP0 CP1 Precision Mixed Signal Copyright © 2004 by Silicon Laboratories 6.15.2004 C8051F019 25 MIPS, 16 kB Flash, 10-Bit ADC, 48-Pin Mixed-Signal MCU Selected Electrical Specifications (TA = –40 to +85 C°, VDD = 2.8 V unless otherwise specified) PARAMETER CONDITIONS GLOBAL CHARACTERISTICS Supply Voltage Supply Current Clock = 25 MHz (CPU active) Clock = 1 MHz Clock = 32 kHz Supply Current Oscillator not running (shutdown) Clock Frequency Range A/D CONVERTER Resolution Integral Nonlinearity Differential Nonlinearity Guaranteed Monotonic Signal-to-Noise Plus Distortion Throughput Rate Input Voltage Range COMPARATORS Supply Current (each comparator) Response Time (CP+) – (CP-) = 100 mV MIN 2.8 MAX UNITS 3.6 V mA mA µA µA 25 MHz ±1 ±1 bits LSB LSB dB 100 VREF ksps V 12.5 0.5 20 10 DC 59 10 ±½ ±½ 61 0 1.5 4 µA µs C8051F005DK Development Kit Package Information D TYP MIN NOM MAX (mm) (mm) (mm) D1 A E1 E - A1 0.05 - 1.20 - 0.15 A2 0.95 1.00 1.05 b 48 PIN 1 IDENTIFIER A2 1 0.17 0.22 0.27 D - 9.00 - D1 - 7.00 - e - 0.50 - E - 9.00 - E1 - 7.00 - e A b Precision Mixed Signal A1 Copyright © 2004 by Silicon Laboratories 6.15.2004 Silicon Laboratories and Silicon Labs are trademarks of Silicon Laboratories Inc. Other products or brandnames mentioned herein are trademarks or registered trademarks of their respective holders