Raychem Circuit Protection 308 Constitution Drive Menlo Park, CA 94025-1164 800-227-4856 FAX 800-227-4866 PRODUCT: miniSMDC150 RAYCHEM DOCUMENT: SCD 24264 PCN: 439545 REV LETTER: F REV DATE: OCTOBER 25, 2000 PAGE NO.: 1 OF 1 PolySwitch® PTC Devices Overcurrent Protection Device Specification Status: RELEASED Maximum Electrical Rating D Voltage: 6V DC Short Circuit Current: 100A Notes: 1. All terminations are tin/lead plated. 2. Devices can be wave soldered. 3. Drawing not to scale E C Marking D E Marking: Manufacturer's Mark 15 Part Identification TABLE I. DIMENSIONS: A B C D E MIN MAX MIN MAX MIN MAX MIN MIN MAX mm: 4.37 4.73 3.07 3.41 0.28 0.48 0.25 0.20 0.50 in: (0.172) (0.186) (0.121) (0.134) (0.011) (0.019) (0.010) (0.008) (0.020) TABLE II. PERFORMANCE RATINGS: IHOLD ** HOLD CURRENT AT TEMPERATURE** TIME TO RATED TRIP ** CURRENT @ 8.0A AMPERES AMPERES AMPERES AMPERES SECONDS AT 20°C AT - 40°C AT 20°C AT 55°C AT 20°C HOLD HOLD HOLD HOLD MAX 1.5 2.30 1.50 1.00 0.5 RESISTANCE VALUES OHMS AT 20°C MIN MAX* 0.040 0.110 **TRIPPED-STATE POWER DISSIPATION WATTS AT 20°C MAX 0.8 * Maximum resistance is measured 1 hour after reflow. **Values Specified were determined using PCB’s with 0.030”X1.5 ounce copper traces. Reference Documents: Precedence: Effectivity: CAUTION: PS300, E. N. SMD1.0x This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame.