HARTMAN Aerospace Power Products Phase Rotation Sensor Features: • Controls External Relay • Epoxy Encapsulated • 115 VAC, 400 Hz, 3Ø Operation • 1 Amp • High Reliability • Meets many requirements of MIL-R-6106 • Light Weight Construction E-326 1 Amp, 115 VAC CONTACTOR CONFIGURATION Notes: Dimensions for this product are expressed in inches. Multiply values by 25.4 for millimeters. PRODUCT SPECIFICATIONS Construction Operating Voltage and Frequency Max. Input Voltage Range for Normal Operation Operation Normal Load Environmental: Temperature Operating Vibration Acceleration Weight Epoxy Encapsulated Continuous Duty, 115V, 3 Phase, L to N, 400 Hz 115 ±20V The phase rotation sensor will apply a DC potential of +28V to any external relay coil or load when the phase rotation is A-B-C and shall remove the +28V signal when phase rotation is other than A-B-C. 1 Amp Continuous 5 Amps Intermittent (.020 Second Maximum) -55°C to +71°C .060 DA 5 to 55 Hz 55 - 200 Hz Log Constant 4.5 Oz. For factory-direct application assistance, contact the HARTMAN product team at (419) 521-9500, Fax (419) 526-2749. © 2004 by Tyco Electronics Corporation. All Rights Reserved. HARTMAN and TYCO are trademarks. Catalog (web doc only) Revised 5-04 www.tycoelectronics.com Dimensions are in inches and millimeters unless otherwise specified. Values in brackets are metric equivalents. Dimensions are shown for reference purposes only. Specifications subject to change. USA: 1-800-522-6752 Canada: 1-905-470-4425 Mexico: 01-800-733-8926 C. America: 52-55-5-729-0425 South America: 55-11-3611-1514 Hong Kong: 852-2735-1628 Japan: 81-44-844-8013 UK: 44-141-810-8967