PolySwitch® PTC Devices 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 www.circuitprotection.com PRODUCT: LR4-1300SSF DOCUMENT: SCD 25627 PCN: F65944 REV LETTER: D REV DATE: JUNE 16, 2007 PAGE NO.: 1 OF 1 Overcurrent Protection Device Raychem Circuit Protection Products Specification Status: Released Maximum Electrical Rating Operating Voltage: Interrupt Current: 20Vdc 100A Chip Size : 9.5 X 50mm Leads: Nickel 1/2H 0.3mm nominal thickness Solder: Lead-free Tape: Polyester (White) 51.5 mm nominal width Marking: (Color: Green) Manufacturer's Mark EX3 ∗ Dimension values on the drawing are for reference only. Part Identification Lot Identification TABLE I. DIMENSIONS: A B MIN MAX MIN MAX mm: 61.5 66.5 9.4 10.0 in*: (2.42) (2.62) (0.37) (0.39) *Rounded off approximation C MIN 0.9 (0.04) D MAX 1.3 (0.05) MIN 5.0 (0.20) E MAX 7.5 (0.30) MIN 5.0 (0.20) F MAX 7.5 (0.30) MIN 5.9 (0.23) MAX 6.1 (0.24) TABLE II. PERFORMANCE RATINGS: As measured in Mueller Kelvin Clips model BU-75K. I HOLD AMPS 20°C HOLD 13.0 CURRENT TRIP LIMITS AMPS AT 0°C HOLD 14.5 AMPS AT 20°C AMPS AT 60°C TIME TO TRIP AMPS AT 70°C TRIP HOLD TRIP HOLD TRIP HOLD TRIP 23.5 13.0 21.2 9.5 15.7 8.6 14.4 Agency Recognitions: Reference Documents: Precedence: Effectivity: CAUTION: REFERENCE RESISTANCE ONE-HOUR POST-TRIP RESISTANCE SECONDS OHMS OHMS AT 20°C, AT 20°C AT 20°C 65.0A MIN MAX MIN MAX MIN MAX --5 0.0035 0.0065 0.0035 0.0090 TRIPPEDSTATE POWER DISSIPATION WATTS AT 20°C, 20V MAX 4.5 UL, TUV, CSA PS300 This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. Materials Information: ROHS Compliant © 2005, 2007 Tyco Electronics Corporation. ELV Compliant All rights reserved. Pb-Free