Tyco / Electronics Raychem Circuit Protection 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 Fax: 800-227-4866 PRODUCT: miniSMDC014 PolySwitch® PTC Devices Overcurrent Protection Device DOCUMENT: SCD 24025 PCN: 941493 REV LETTER: L REV DATE: SEPTEMBER 12, 2001 PAGE NO.: 1 OF 1 Specification Status: RELEASED Maximum Electrical Rating Voltage: 60V DC Current: 10A Notes: 1. All terminations are tin/lead plated. 2. Devices can be wave soldered. 3. Drawing not to scale Marking: Manufacturer's Mark 14 Part Identification TABLE I. DIMENSIONS: A MIN 4.37 B MAX 4.73 MIN 0.635 C MAX 0.890 MIN 3.07 MAX 3.41 D MIN 0.30 E MIN 0.25 MAX mm 0.50 : in: (0.172) (0.186) (0.025) (0.035) (0.121) (0.134) (0.012) (0.010) (0.020) TABLE II. PERFORMANCE RATINGS: CURRENT RATINGS** AMPERES AT - 40°C HOLD 0.23 AMPERES AT 20°C HOLD 0.140 AMPERES AT 60°C HOLD 0.090 TIME TO TIME TO TRIP ** TRIP ** @ 1.5A @ 8.0A SECONDS SECONDS AT 20°C AT 20°C 0.150 0.008 RESISTANCE VALUES POWER DISSIPATION OHMS AT 20°C MIN MAX* 1.50 6.00 WATTS AT 20°C MAX 0.75 * Maximum resistance is measured 1 hour after reflow. **Values Specified were determined using PCB’s with 0.030”X1.5 ounce copper traces. Reference Documents: Precedence: Effectivity: CAUTION: PS300, E. N. SMD1.0x This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame.