Tyco / Electronics PRODUCT: nanoSMDC075F PolySwitch® PTC Devices Raychem Circuit Protection 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 Fax: 800-227-4866 Overcurrent Protection Device DOCUMENT: SCD 25128 PCN: E65718 REV LETTER: H REV DATE: MAY 11, 2006 PAGE NO.: 1 OF 1 Specification Status: Released Maximum Electrical Rating Voltage: 6.0VDC MAX Short Circuit Current: 100A Notes: 1. All terminations are tin plated. 2. Drawing not to scale Marking: TABLE I. DIMENSIONS: mm: in: A B C D E MIN MAX MIN MAX MIN MAX MIN MAX MIN 3.00 3.40 0.28 0.48 1.37 1.80 0.25 0.75 0.076 (0.118) (0.134) (0.011) (0.019) (0.054) (0.071) (0.010) (0.030) (0.003) TABL II. PERFORMANCE RATINGS: CURRENT RATINGS** TIME TO TRIP** RESISTANCE VALUES AMPERES AMPERES AMPERES AT 0°C AT 25°C AT 60°C HOLD TRIP HOLD TRIP HOLD TRIP 0.92 1.87 0.75 1.50 0.58 1.14 SECONDS AT 25°C, 8.0A MAX 0.1 OHMS AT 25°C MIN MAX* 0.12 0.40 TRIPPED-STATE POWER DISSIPATION** WATTS AT 25°C, 6.0V MAX 0.8 *Maximum resistance is measured 1 hour after reflow. ** Values specified were determined using PCB’s with 0.030”X1.5 ounce copper traces. Agency Recognitions: Reference Documents: Precedence: Effectivity: CAUTION: UL, CSA, TÜV PS300 This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. Materials Information ROHS Compliant ELV Compliant © 2006 Tyco Electronics Corporation. All rights reserved. Pb-Free