AXIOMTEK RBOX610-FL

rBOX610
Robust Din-rail Fanless Embedded System
with RISC-based (iMX-287) Processor 4 COM,
2 CAN Bus and DIO
NEW
LED indicators (power, alarm,
ready/active, COM, wireless)
Wireless
(3G/GPRS)
RISC-based Module
(iMX-287) Processor
Features
● Fanless design
● RISC-based module (iMX-287) processor
● 128MB DDR2 SDRAM onboard
● 1 eMMC 4 GB onboard
● 1 SDHC socket for storage expansion (easy to access)
● 4 COM ports
● 2 CAN bus
● RTC battery function
● LED indicators
● SNMP V1/V2c
● Wide range DC power input (12 - 48V) with terminal block
● Ready-to-run embedded Linux operating system
● Wide temperature operation of -40°C ~ +70°C
Console port
4 COM
DIO (4-In/4-Out)
2 CANBus
Front view
Power DC-In
SDHC slot
SIM sot
Din-rail kit
EN60950-1
Isolation
Extended
Temperature
IP40
UL508
Fanless
Low Power
Rear view
Easy-to-access interface
Introduction
rBOX610 cost-effective din-rail fanless embedded system utilizes the low power
RISC-based module (iMX-287) processor and is designed to withstand temperatures
ranging from -40°C to +70°C for using in extreme operating environment and industrial
automation applications.
rBOX610 features 4 RS-232/422/485 serial ports, dual LANs, 4 digital input channels,
4 digital output channels, 2 CAN bus and 1 eMMC onboard 4 GB & 1 x SDHC socket
for storage expansion (easy to access) in a compact, IP40 protected, industrial-strength
robust case. Two power paths input minimize the risk of data loss in the event of a single
power failure. Its vertical din-rail form factor makes it easy to install the system in a
small cabinet. Due to the RISC-based architecture, rBOX610 will not generate a lot of
heat while being operated. The ready-to-run rBOX610 is specially designed for remote
control/monitoring management applications like unmanned control room, industrial
machine, automatic parking lot, traffic cabinet and more.
System I/O Outlet
USB
CAN
DIO
Hardware Specifications
Standard Color
Construction
CPU
System Board
System Memory
System I/O Outlet
Sliver-Black
Extruded aluminum and heavy-duty steel, IP40
iMX-287, ARM9 16-bit RISC CPU, 454 MHz
Q7M100
1 x DDR2 128 MB SDRAM onboard
Serial Port
4 x RS-232/422/485 (COM 1 ~ 4)
COM 1~3 with TX/RX/RTS/CTS signals
RS-232/422/485 interface select by
software
LAN
2 x 10/100Mbps Ethernet
Magnetic isolation protection 1.5KV
Console Port
RTC
Power Input
Alarm Contact
321
1 x USB 2.0
USB power distribution control by
software
2 CAN 2.0 B (Phoenix connector, nonisolation)
Meets ISO 11898 standard
Software control termination resistor
120 ohm can high speed up to 1Mbit/s
for transmit/receive
1 x DIO (4-IN/4-OUT)
DI :
Input channels : 4, source type
Input voltage : 0 to 30VDCDigital input
levels for dry contacts :
-Logic level 0: close to GND
-Logic level 1: open
Digital input levels for wet contacts :
-Logic level 0: +10V to +24V (DI to COM-)
-Logic level 1: +3V max.
DO :
Output channels : 4, sink type
Output current: Max. 200 mA per
channel
On-state voltage : 24VDC nominal, open
collector to 30V
Optical isolation protection 2 KV
DB9 connector
For user setting with debug
Battery onboard
Provides power for the internal real time
clock & calendar
Ideal for vibration environment &
reduces maintenance efforts
2 power paths with terminal block
One relay output with current
0.5A@30VDC
* All specifications and photos are subject to change without notice.
Hardware Specifications
Software Specifications
System I/O Outlet
OS: Linux
Watchdog Timer
LEDs
Storage
Installation
Power Supply
Operating Temperature
Storage Temperature
Humidity
Vibration Endurance
Weight (net/gross)
Dimensions
EOS Support
Certification
Wireless
1 x Mini Card (supports USB interface on
3G/GPRS)
1 x SIM socket by outside access and is
easy plug/pull
WDT 1: one step is 1 sec, 255 levels
System
Power, Alarm, Ready/Active, COM (TX,
RX), Wireless
Alarm
DC PWR1 or PWR2 is lost
1 x eMMC 4 GB onboard (for boot disk)
Supports 1 x SDHC Card (easy-to-access, for store only.)
Din-rail
Wall mount
2 power paths
Power Input Range 12-48VDC
Power Protection DC Version:
OVP (Over voltage protection)
UVP (Under voltage protection)
Reverse protection
-40°C ~ +70°C (-40°F ~ +158°F)
-45°C ~ +85°C (-49°F ~ +185°F)
5% ~ 95%
5G @ 10-150Hz, amplitude 0.35ms
TBD
55 mm (2.16") (W) x 155 mm (6.10") (D) x 110 mm (4.33") (H)
Linux (Pre-installed)
FCC Part 18
Heavy Industrial CE
Ordering Information
Standard
rBOX610-FL
Robust Din-rail fanless embedded system with Q7-RISC
Module (iMX-287), 4 COM, 2 CAN & DIO
(-40°C ~ +70°C)
Support protocol types
Support software types
Setting configuration
Remote Manager
Serial Port Redirector for
windown
HW’s lib
Optional
Wall mount kit
Wireless (3G/GPS or WiFi) module for rBOX series
Dimensions
* All specifications and photos are subject to change without notice.
© 2013 Axiomtek Co., Ltd. All rights reserved.
a x i o m te k . c o m
Host OS/ Development OS : Ubuntu 10.04 LTS
Toolchain/ Cross compiler : Freescale LTIB
Kernel : 2.6.35.3 (with Freescale and Axiomtek hardware
modified patch)
ICMP.
TCP/IP,
UDP,DHCP,Telnet,SNMP,HTTP,HTTPS,SSL,SMTP,ARP,
NTP,DNS,PPP,PPPOE,FTP.TFTP
Serial Server:
Support TCP Server/TCP Client/UDP/Pair/VC
Support IP filter
Support 32 TCP connections
Support QOS
Modbus gateway:
Support Modbus TCP/Modbus RTU/Modbus ASCII
Support IP filter
Support 32 connections
Support TCP for multiple com port
Support QOS
SNMP:
Support V1/V2C/V3
Support SNMP Private MIB
Support read/write
http /https:
Support SSL
Support Import/export
Support FW update
Remote Log
Email
SNMP
Support Trap
XP/2003 32-64/Win7 32-64/Vista 32-64/2008 32-64
Real com(visual com)
Centralized management
Import/Export for real com
Wifi:
Support detecting signal strength
Support setting AP connection
Support setting web,wpa,wpa2
Support Search AP
DI/DO:
Support Read-DI/write DO
CAN:
Support Open/write /read/Close
3G:
Support setting number connection
Support User name/password
Support detecting signal strength
GPS:
Support detecting signal strength
Support satellite positioning
Watch Dog Timer:
Support setting enable
Support setting clean
Support setting timer
COM:
Support setting RS-232/422/485
Default Reading:
Support default reading for MAC, IP, Model
Overview
Embedded
Systems
Embedded
Systems for
Transportation
Embedded
Field
Controllers
Embedded
MicroBoxes
Industrial
Barebone
Systems
Industrial
Chassis
Backplanes
Power
Supplies
Peripherals &
Accessories
322