rBOX610 Robust Din-rail Fanless Embedded System with RISC-based (iMX-287) Processor 4 COM, 2 CAN Bus and DIO LED indicators (power, alarm, ready/active, COM, wireless) Wireless (3G/GPRS) Features ● Fanless design ● RISC-based module (iMX-287) processor ● 128MB DDR2 SDRAM onboard ● 4GB eMMC onboard ● Completed Industrial AP development software (Serial server, Modbus gateway, SNMP, Remote manager) ● Wide range DC power input (12 - 48V) with terminal block ● Ready-to-run embedded Linux operating system ● Wide temperature operation of -40°C ~ +70°C RISC-based Module (iMX-287) Processor Console port 4 COM DIO (4-In/4-Out) 2 CANBus Power DC-In Front view SDHC slot SIM sot Din-rail kit Fanless Low Power Rear view Freescale i.MX287 EN60950 Isolation Ext. Temp IP40 Easy-to-access interface UL508 Introduction The rBOX610 cost-effective din-rail fanless embedded system utilizes the low power RISC-based module (iMX-287) processor and is designed to withstand temperatures ranging from -40°C to +70°C for using in extreme operating environment and industrial automation applications. The rBOX610 features 4 RS-232/422/485 serial ports, dual LANs, 4 digital input channels, 4 digital output channels, 2 CAN bus and 1 eMMC onboard 4 GB & 1 x SDHC socket for storage expansion (easy to access) in a compact, IP40 protected, industrial-strength robust case. Two power paths input minimize the risk of data loss in the event of a single power failure. Its vertical din-rail form factor makes it easy to install the system in a small cabinet. Due to the RISC-based architecture, rBOX610 will not generate a lot of heat while being operated. The ready-to-run the rBOX610 is specially designed for remote control/monitoring management applications like unmanned control room, industrial machine, automatic parking lot, traffic cabinet and more. System I/O Outlet USB CAN DIO Hardware Specifications Standard Color Construction CPU System Board System Memory System I/O Outlet Sliver-Black Extruded aluminum and heavy-duty steel, IP40 i.MX287, ARM926EJ-S™ processor, 454MHz Q7M100 1 x DDR2 128 MB SDRAM onboard Serial Port 4 x RS-232/422/485 (COM 1 ~ 4) COM 1~3 with TX/RX/RTS/CTS signals RS-232/422/485 interface select by software LAN 2 x 10/100Mbps Ethernet Magnetic isolation protection 1.5KV Console Port RTC Alarm Contact 355 1 x USB 2.0 USB power distribution control by software 2 CAN 2.0 B (Phoenix connector, nonisolation) Meets ISO 11898 standard Software control termination resistor 120 ohm can high speed up to 1Mbit/s for transmit/receive 1 x DIO (4-IN/4-OUT) DI : Input channels : 4, source type Input voltage : 0 to 30VDCDigital input levels for dry contacts : -Logic level 0: close to GND -Logic level 1: open Digital input levels for wet contacts : -Logic level 0: +10V to +24V (DI to COM-) -Logic level 1: +3V max. DO : Output channels : 4, sink type Output current: Max. 200 mA per channel On-state voltage : 24VDC nominal, open collector to 30V Optical isolation protection 2 KV DB9 connector For user setting with debug Battery onboard Provides power for the internal real time clock & calendar Ideal for vibration environment & reduces maintenance efforts One relay output with current 0.5A@30VDC * All specifications and photos are subject to change without notice. Hardware Specifications Software Specifications System I/O Outlet OS: Linux Watchdog Timer LEDs Storage Installation Power Supply Operating Temperature Storage Temperature Humidity Vibration Endurance Weight (net/gross) Dimensions EOS Support Certification Wireless 1 x Mini Card (supports USB interface on 3G/GPRS) 1 x SIM socket by outside access and is easy plug/pull WDT 1: one step is 1 sec, 255 levels System Power, Alarm, Ready/Active, COM (TX, RX), Wireless Alarm DC PWR1 or PWR2 is lost 1 x eMMC 4 GB onboard (for boot disk) Supports 1 x SDHC Card (easy-to-access, for store only.) Din-rail Wall mount Power Input 2 power paths with terminal block Power Input Range 12-48VDC Power Input Rating 12-48VDC, 0.68-0.19A Power Protection DC Version: OVP (Over voltage protection) UVP (Under voltage protection) Reverse protection -40°C ~ +70°C (-40°F ~ +158°F) -45°C ~ +85°C (-49°F ~ +185°F) 5% ~ 95% 5G @ 10-150Hz, amplitude 0.35ms 1.0 kg (2.2 lb)/1.50 kg (3.3 lb) 55 mm (2.16") (W) x 155 mm (6.10") (D) x 110 mm (4.33") (H) Linux (Pre-installed) FCC Part 18 Heavy Industrial CE Ordering Information Standard rBOX610-FL-DC Robust din-rail fanless embedded system with Q7-RISC module (iMX-287), 4 COM, 2 CAN and DIO (-40°C ~ +70°C) Support protocol types Support software types Setting configuration Remote Manager Serial Port Redirector for windown HW’s lib Optional Wall mount kit Wireless (3G/GPS or Wi-Fi) module for rBOX series Dimensions Host OS/ Development OS : Ubuntu 10.04 LTS Toolchain/ Cross compiler : Freescale LTIB Kernel : 2.6.35.3 (with Freescale and Axiomtek hardware modified patch) ICMP. TCP/IP, UDP,DHCP,Telnet,SNMP,HTTP,HTTPS,SSL,SMTP,ARP, NTP,DNS,PPP,PPPOE,FTP.TFTP Serial Server: Supports TCP Server/TCP Client/UDP/Pair/VC Supports IP filter Supports 32 TCP connections Supports QOS Modbus gateway: Supports Modbus TCP/Modbus RTU/Modbus ASCII Supports IP filter Supports 32 connections Supports TCP for multiple com port Supports QOS SNMP: Supports V1/V2C/V3 Supports SNMP Private MIB Supports read/write http /https: Supports SSL Supports Import/export Supports FW update Remote Log Email SNMP Supports Trap XP/2003 32-64/Win7 32-64/Vista 32-64/2008 32-64 Real com (visual com) Centralized management Import/Export for real com DI/DO: Supports Read-DI/write DO CAN: Supports Open/write /read/Close 3G: Supports setting number connection Supports User name/password Supports detecting signal strength GPS: Supports detecting signal strength Supports satellite positioning Watch Dog Timer: Supports setting enable Supports setting clean Supports setting timer COM: Supports setting RS-232/422/485 Default Reading: Supports default reading for MAC, IP, Model Overview Embedded Systems Embedded Systems for Transportation 3 Embedded Field Controllers Industrial Firewall Digital Signage Solutions Embedded MicroBoxes Industrial Barebone Systems Industrial Chassis Backplanes Power Supplies Peripherals & Accessories * All specifications and photos are subject to change without notice. a x i o m te k . c o m © 2016 Axiomtek Co., Ltd. All rights reserved. 356