Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: [email protected] Web: http://www.frontierusa.com 1A FAST RECOVERY PLASTIC RECTIFIER FR10-005 THRU FR10-10 FEATURES z FAST RECOVERY TIMES z UL 94V0 FLAME RETARDANT EPOXY MOLDING COMPOUND z DIFFUSED JUNCTION z LOW COST z HIGH SURGE CURRENT CAPABILITY 1.0(25.4) MIN .034(0.9) .028(0.7) .205(5.2) .166(4.2) .107(2.7) .080(2.0) MECHANICAL DATA z CASE: TRANSFER MOLDED, DO41, DIMENSIONS IN INCHES AND (MILLIMETERS) z LEADS: SOLDERABLE PER MIL-STD-202, METHOD 208 z POLARITY: CATHODE INDICATED BY COLOR BAND z WEIGHT: 0.34 GRAMS 1.0(25.4) MIN MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS RATINGS AT 25°C AMBIENT TEMPERATURE UNLESS OTHERWISE SPECIFIED SINGLE PHASE, HALF WAVE, 60 HZ, RESISTIVE OR INDUCTIVE LOAD. FOR CAPACITIVE LOAD, DERATE CURRENT BY 20% RATINGS SYMBOL FR10-005 FR10-01 FR10-02 FR10-04 FR10-06 FR10-08 FR10-10 UNITS MAXIMUM RECURRENT PEAK REVERSE VOLTAGE MAXIMUM RMS VOLTAGE MAXIMUM DC BLOCKING VOLTAGE MAXIMUM AVERAGE FORWARD RECTIFIED CURRENT 0.375”(9.5mm) LEAD LENGTH AT TA=55°C PEAK FORWARD SURGE CURRENT, 8.3ms SINGLE HALF SINE-WAVE SUPERIMPOSED ON RATED LOAD TYPICAL JUNCTION CAPACITANCE (NOTE 1) VRRM VRMS VDC 50 35 50 100 70 100 200 140 200 400 280 400 600 420 600 800 560 800 1000 700 1000 V V V CJ 15 PF TYPICAL THERMAL RESISTANCE (NOTE 2) Rθja 50 ℃/W STORAGE TEMPERATURE RANGE TSTG - 55 TO + 150 ℃ OPERATING TEMPERATURE RANGE TOP - 55 TO + 150 ℃ IO 1.0 A IFSM 30 A ELECTRICAL CHARACTERISTICS (AT TA =25°C UNLESS OTHERWISE NOTED) CHARACTERISTICS SYMBOL FR10-005 FR10-01 FR10-02 FR10-04 FR10-06 FR10-08 FR10-10 UNITS MAXIMUM FORWARD VOLTAGE AT IO DC VF 1.3 V MAXIMUM REVERSE CURRENT AT 25℃ IR 5 μA MAXIMUM REVERSE CURRENT AT100℃ IR 50 μA MAXIMUM REVERSE RECOVERY TIME (NOTE 3) TRR 150 NOTE: 1. MEASURED AT 1 MHZ AND APPLIED REVERSE VOLTAGE 0F 4.0 VOLTS 2. BOTH LEADS ATTACHED TO HEAT SINK 20x20x1t(mm) COPPER PLATE AT LEAD LENGTH 5mm 3. REVERSE RECOVERY TEST CONDITIONS: IF=0.5A, IR=1.0A, IRR=0.25A FR10-005 THRU FR10-10 250 Page: 1 500 nS RATINGS AND CHARACTERISTIC CURVE FR10-005 THRU FR10-10 FIG. 1-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC 50Ω NO INDUCTIVE 10Ω NO INDUCTIVE Trr +0.5A (-) D.U.T. (+) 25 Vdc (approx) (-) PULSE GENERATOR ( NOTE 2 ) 1Ω NON INDUCTIVE 0 -0.25A OSCILLOSCOPE ( NOTE 1 ) (+) -1.0A NOTE: 1. RISE TIME=7ns MAX. INPUT IMPEDANCE=1 MOhms 22PF 2. RISE TIME =10ns MAX. SOURCE IMPEDANCE=50 OHMS 1cm SET TIME BASE FOR 10/20 ns/cm RESISTIVE OR INDUCTIVE LOAD 0.375”(9.5mm) LEAD LENGTH 1.0 0.8 I(pk) I(AV) π Fig. 5-MAXIMUM FORWARD SURGE NUMBER OF CYCLES = CAPACITIVE LOAD 0.4 I(pk) 0.2 I(AV) 0 0 5 = 10 20 20 40 60 80 100 120 140 160 180 200 TA-AMBIENT TEMPERATURE (OC) FIG. 3-TYPICAL JUNCTION CAPACITANCE 20 CAPACITANCE, pF Tj=25oC 10 1 10 100 REVERSE VOLTAGE, VOLTS FIG. 4-TYPICAL REVERSE CHARACTERISTICS 100 10 30 TA=75oC 8.3ms SINGLE HALF SINE-WAVE JEDEC METHOD 20 10 1.0 CYCLE 0 1 TJ=100oC 1 TJ=25oC 3 1 Tj=25oC PULSE WIDTH =300us 1% DUTY CYCLE .3 .1 .03 .01 40 60 80 0.6 0.8 1.0 1.2 1.4 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE FR10-005 THRU FR10-10 1.6 1.8 INSTANTANEOUS FORWARD VOLTAGE, (V) .01 20 100 20 10 0.4 0.1 0 10 NUMBER OF CYCLES AT 60 HZ FIG. 6-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS f = 1 MHz Vsig = 50 mVp-p 1 INSTANTANEOUS REVERSE CURRENT, MICRO AMPERES(uA) PEAK FORWARD SURGE CURRENT AMPERES 0.6 INSTANTANEOUS FORWARD CURRENT, IF(A) Io-AVERAGE RECTIFIED CURRENT (A) Fig. 2-MAXIMUM CURRENT DERATING CURVE Page: 2