Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: [email protected] Web: http://www.frontierusa.com 3A FAST RECOVERY PLASTIC RECTIFIER BYW95AP THRU BYW96EP FEATURES z FAST RECOVERY TIMES z UL 94V-0 FLAME RETARDANT EPOXY MOLDING COMPOUND z LOW COST z HIGH SURGE CURRENT CAPABILITY z DIFFUSED JUNCTION 1.0(25.4) MIN .052(1.3) .048(1.2) .375(9.5) .335(8.5) MECHANICAL DATA z CASE: TRANSFER MOLDED, DO201AD, DIMENSIONS IN INCHES AND (MILLIMETERS) z TERMINAL: SOLDERABLE PER MIL-STD-202,METHOD 208 z POLARITY: CATHODE INDICATED BY COLOR BAND z WEIGHT: 1.2 GRAMS .220(5.6) .197(5.0) 1.0(25.4) MIN MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS RATINGS AT 25°C AMBIENT TEMPERATURE UNLESS OTHERWISE SPECIFIED SINGLE PHASE, HALF WAVE, 60 HZ, RESISTIVE OR INDUCTIVE LOAD. FOR CAPACITIVE LOAD, DERATE CURRENT BY 20% RATINGS MAXIMUM RECURRENT PEAK REVERSE VOLTAGE MAXIMUM RMS VOLTAGE MAXIMUM DC BLOCKING VOLTAGE MAXIMUM AVERAGE FORWARD RECTIFIED CURRENT 0.375”(9.5mm) LEAD LENGTH AT TA=55°C PEAK FORWARD SURGE CURRENT, 8.3ms SINGLE HALF SINE-WAVE SUPERIMPOSED ON RATED LOAD TYPICAL JUNCTION CAPACITANCE (NOTE 1) SYMBOL BYW95AP VRRM VRMS VDC BYW95BP BYW95CP BYW96DP BYW96EP UNITS 400 280 400 600 420 600 800 560 800 1000 700 1000 V V V 200 140 200 IO 3.0 A IFSM 100 A CJ 28 PF TYPICAL THERMAL RESISTANCE (NOTE 2) Rθja 20 ℃/W STORAGE TEMPERATURE RANGE TSTG - 55 TO + 150 ℃ OPERATING TEMPERATURE RANGE TOP - 55 TO + 150 ℃ ELECTRICAL CHARACTERISTICS (AT TA =25°C UNLESS OTHERWISE NOTED) CHARACTERISTICS SYMBOL BYW95AP BYW95BP BYW95CP BYW96DP BYW96EP UNITS MAXIMUM FORWARD VOLTAGE AT IO DC VF 1.5 V MAXIMUM REVERSE CURRENT AT 25℃ IR 10 μA MAXIMUM REVERSE CURRENT AT 100℃ IR MAXIMUM REVERSE RECOVERY TIME (NOTE 2) TRR 150 NOTE: 1. MEASURED AT 1 MHZ AND APPLIED REVERSE VOLTAGE 0F 4.0 VOLTS μA 100 250 300 2. BOTH LEADS ATTACHED TO HEAT SINK 63.5×63.5×1t(mm) COPPER PLATE AT LEAD LENGTH 5mm 3. REVERSE RECOVERY TEST CONDITIONS: IF=0.5A, IR=1.0A, IRR=0.25A BYW95AP THRU BYW96EP Page: 1 nS RATINGS AND CHARACTERISTIC CURVE BYW95AP THRU BYW96EP FIG. 1-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC 10Ω NO INDUCTIVE 50Ω NO INDUCTIVE Trr +0.5A (-) D.U.T. (+) 25 Vdc (approx) (-) PULSE GENERATOR ( NOTE 2 ) 0 -0.25A 1Ω NON INDUCTIVE OSCILLOSCOPE ( NOTE 1 ) (+) -1.0A NOTE: 1. RISE TIME=7ns MAX. INPUT IMPEDANCE=1 MOhms 22PF 2. RISE TIME =10ns MAX. SOURCE IMPEDANCE=50OHMS 1cm SET TIME BASE FOR 10/20 ns/cm Fig. 3-MAXIMUM FORWARD SURGE NUMBER OF CYCLES 3.0 SINGLE PHASE HALF WAVE 60Hz RESISTIVE OR INDUCTIVE LOAD 2.0 1.0 0 0 20 40 PEAK FORWARD SURGE CURRENT AMPERES Io-AVERAGE RECTIFIED CURRENT (A) Fig. 2-MAXIMUM CURRENT DERATING CURVE 200 8.3ms Single Half Sine-Wave (JEDEC Method) 100 50 10 1 60 80 100 120 140 160 180 200 TA-AMBIENT TEMPERATURE (OC) NUMBER OF CYCLES AT 60HZ FIG. 5-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS INSTANTANEOUS FORWARD CURRENT AMPERES INSTANTANEOUS REVERSE CURRENT, MICROAMPERES FIG. 4-TYPICAL REVERSE CHARACTERISTICS 10 Tj=100oC 1.0 Tj=50oC 0.1 Tj=25oC 0.01 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE, % BYW95AP THRU BYW96EP 10 100 10 1.0 0.1 Tj=25oC PULSE WIDTH =300us 1% DUTY CYCLE 0.01 0.4 0.6 0.8 1.0 1.2 1.4 1.6 1.8 INSTANTANEOUS FORWARD VOLTAGE, VOLTS Page: 2 100