Bluetooth Module - Part Code LM-072 Class 1 BC04 Features Đ Đ Đ Đ Đ Đ Đ Đ Đ Đ Đ Đ Bluetooth Ver. 2.0+EDR certification Transmit Power up to +18dBm(class1) Low current consumption: Hold, Sniff, Park, Deep sleep mode 3.0V to 3.6V operation Full Bluetooth Data rate over UART and USB Support up to 7 ACL links and 3 SCO links Enhanced Data Rate(EDR) compliant for both 2Mbps and 3Mbps modulation modes Interface: USB, UART&PCM( for voice codec) SPP,HSP/HFP,HID,DUN firmware are available Support for 802.11 Co Existence RoHS Compliant Small outline: 28.2 X 15.0 X 2.8 mm Application Đ Đ Đ Đ Đ Đ Đ Access point Domestics and Industrial applications Personal Digital Assistants(PDA) Serial Adapter GPS, POS, Barcode Reader Digital camera, Printer& Cellular phone Cordless handset LM-072 Page Number : 1 of 6 0121 270 6232 | www.lm-technologies.com | [email protected] Electrical Characteristics Absolute Maximum Ratings Parameter Storage Temperature Supply Voltage(VDD) Supply Voltage(P VCC ) Other Pin Voltage Recommended Operating Conditions Parameter Temperature Supply Voltage for UART Supply Voltage for USB General Electrical Specification Parameter Carrier Frequency RF Output Power RX sensitivity Load Impedance Inpu t Low Voltage Input High Voltage Output Low Voltage Output High Voltage Average Current Consumption Min. -40 2.7 3.0 Vss -0.4 Max. +150 3.6 3.3 VDD+0.4 Unit Đ DCV DCV DCV Min. -20 3.0 3.0 Max. +75 3.6 3.6 Unit Đ DCV DCV Description Measured in 50ohm No abnormal Oscillation RESET,UART,GPIO,PCM RESET,UART,GPIO,PCM UART,GPIO,PCM UART,GPIO,PCM Receive DM1 Min. 2.402 15 - Typ. -0.30 0.7VDD VDD -0.4 114 16.5 -88 Max. 2.480 18 -86 5:1 0.80 VDD+0.3 0.40 - Unit GHz dBm dBm DCV DCV DCV DCV mA Radio Characteristics - Basic Data Rate Transmitter , VDD = 3.3V Temperature =+20°C RF transmit power Initial carrier frequency tolerance -20dB bandwidth for modulated carrier Carrier Frequency slot pa cket DH1) Carrier Frequency packet DH5) Drift (single Drift (five slot Drift Rate RF power control range LM-072 Page Number : 2 of 6 Fre quency (GHz) 2.402 2.441 2.480 2.402 2.441 2.480 2.402 2.441 2.480 2.402 2.441 2.480 2.402 2.441 2.480 2.402 2.441 2.480 Min . Typ . 15 15 15 16 16.5 16.5 16.5 12 10 9 890 870 820 ±10 ±10 ±10 ±10 ±10 ±10 ±7 ±7 ±7 25 Max . 18 18 18 25 25 25 1000 1000 1000 ±20 ±20 ±20 ±20 ±20 ±20 ±14 ±14 ±14 - Bluetooth Specification -6 to +20 ±75 <1000 <25 <40 <20 >16 Unit dBm dBm dBm kHz kHz kHz kHz kHz kHz kHz kHz kHz kHz kHz kHz kHz/50µs kHz/50µs kHz/50µs dB 0121 270 6232 | www.lm-technologies.com | [email protected] Đ f1avg “Maximum Modulation ” Đ f2maz “Minimum Modulation ” Adjacent Adjacent Adjacent Adjacent channel channel channel channel transmit transmit transmit transmit power power power power F F F F 2.402 2.441 2.480 2.402 2.441 2.480 =F 0±2MHz =F 0±3MHz >F 0 +3MHz <F 0 -3MHz 145 145 145 115 115 115 - Receiver, VDD =3.3V Temperature =+20°C Fre quency (GHz) 2.402 2.441 2.480 2.402 2.441 2.480 2.402 2.441 2.480 Sensitivity at 0.1% BER (S ingle slot packets) Sensitivity at 0.1% BER (Multi slot packets) Maximum received signal 0.1% BER level at Min . -20 -20 -20 - C/I co-channel Adjacent channel selectivity C/I F=F 0 +1 MHz Adjacent channel selectivity C/I F=F 0 - 1MHz Adjacent channel selectivity C/I F=F 0 +2 MHz Adjacent channel selectivity C/I F=F 0 - 2MHz Adjacent channel selectivity C/I F >= F 0 +3 MHz Adjacent channel selectivity C/I F <= F 0 -5 MHz Adjacent channel selectivity C/I F =F image F 0 =2441 MHz Maximum level of intermodulation interference (n=5) 165 165 165 150 150 150 -35 -45 -50 -50 170 170 170 -20 -40 -40 -40 Typ . Max . -88 -88 -88 -88 -88 -88 -10 -10 -10 6 -4 -4 -38 -23 -45 -44 -22 -86 -86 -86 -86 -86 -86 11 - -30 140<Đ f1avg <175 >115 <- 20 <- 40 <- 40 <- 40 Bluetooth Specification kHz kHz kHz kHz kHz kHz dB m dB m dB m dB m <11 <0 <0 <- 30 <- 20 <- 40 <- 40 <- 9 U nit dBm dBm dBm dBm dBm dBm dBm dBm dBm dB dB dB dB dB dB dB dB >-39 dBm <- 70 <- 70 >- 20 Radio Characteristics – Enhance d Data Rate Transmitter , VDD =3.3V Temperature =+20°C Maximum RF transmit power Relative transmit power π /4 DQPSK Maximum carrier frequency π /4 DQPSK Maximum carrier frequency π /4 DQPSK Maximum carrier frequency 8 DPSK Maximum carrier frequency LM-072 Page Number : 3 of 6 (note) Fre quency (GHz) 2.402 2.441 2.480 stability w 0 stability w i stability | w stability w 0 + wi | Min . Typ . Max . Bluetooth Specification - 6 6 7 -1.6 2 - -4 to +1 <±10 for all blocks dBm dBm dBm dB kHz - 6 - <±75 for all packets kHz - 8 - <±75 for all block s kHz - 2 - <±10 for all blocks kHz -6 to +20 Unit 0 0121 270 6232 | www.lm-technologies.com | [email protected] 8 DPSK Maximum carrier frequency stability w i 8 DPSK Maximum carrier frequency stability | w 0 + wi | RMS DVEM π /4 DQPSK Modulation Accuracy 99% DEVM Peak DEVM 8 DPSK RMS DVEM Modulation Accuracy 99% DEVM Peak DEVM F >F 0 +3 MHz F<F0 -3 MHz F=F0 -3 MHz F=F0 -2 MHz In-band spurious emissions F=F0 -1 MHz F=F0 +1 MHz F=F0 +2 MHz F=F0 +3 MHz EDR Differential Phase Enc oding - 6 - <±75 for all packets kHz - 8 - <±75 for all blocks kHz - 7 13 19 7 13 17 <-50 <-50 -46 -34 -35 -35 -31 -33 No Errors - <20 <30 <35 <13 <20 <25 <-40 <-40 <-40 <-20 <-26 <-26 <-20 <-40 > 99 % % % % % % dBm dBm dBm dBm dBm dBm dBm dBm % Receiver, VDD =3.3V Temperature =+20°C Modulation Sensitivity at 0.1% BER Maximum received signal at 0.1% BER level C/I co-channel at 0.1% BER Adjacent channel selectivity C/I F=F0 +1 MHz Adjacent channel selectivity C/I F=F0 -1 MHz Adjacent channel selectivity C/I F=F0 +2MHz Adjacent channel selectivity C/I F=F0 -2 MHz Adjacent channel selectivity C/I F=F0 +3MHz Adjacent channel selectivity C/I F=F0 -5 MHz F 0 =2405, 2441, 2477MHz Adjacent channel selectivity C F =F image /I π 8 π 8 π 8 π 8 π 8 π 8 π 8 π 8 π 8 /4 DQPSK DPSK /4 DQPSK DPSK /4 DQPSK DPSK /4 DQPSK DPSK /4 DQPSK DPSK /4 DQPSK DPSK /4 DQPSK DPSK /4 DQPSK DPSK /4 DQPSK DPSK Min . Typ . - -87 -78 -8 -10 10 19 -10 -5 -11 -5 -40 -40 -23 -20 -45 -45 -45 -45 π /4 DQPSK 8 DPSK Max . - -20 -15 Bluetooth Specification <-70 <-70 >-20 >-20 <+13 <+21 <0 <+5 <0 <+5 <-30 <-25 <-20 <-13 <-40 <-33 <-40 <-33 <-7 <0 Unit dBm dBm dBm dBm dB dB dB dB dB dB dB dB dB dB dB dB dB dB dB dB Note : Measurement made using a POWER_TABLE entery of TX_PRE 80, INT PA63, EXT PA255. This ensures that the Bluetooth requirements for ACP and those defined by the FCC and ETSI are satisfied over temp erature rang of the operating -5Đ to +45Đ . Although the design is capable of generating in excess of +18dBm, regulatory compliance over the full temperature range of -5Đ to +45Đ will not be satisfied if the transmit power approaches this value. LM-072 Page Number : 4 of 6 0121 270 6232 | www.lm-technologies.com | [email protected] Pin No. Pin Name Pin Type Description Common ground Power Amp. Power Supply(3.3V) Programmable I/O terminal , 32KHz sleep clock input Programmable I/O terminal Programmable I/O terminal , RX Enable Programmable I/O terminal , TX Enable Programmable I/O terminal , USB_PULL_UP , CLK_REQ_OUT Programmable I/O terminal , USB_WAK E_UP , CLK_REQ_IN Programmable I/O terminal , USB_ON , BT_Priority/Ch_Clk output for co-existence signalling Common ground Programmable I/O terminal , USB_DETACH , BT_Active output for co existence signalling Programmable I/O terminal , CLK_REQ , WLAN_Active/Ch_Data input for for co-existence signalling Programmable I/O terminal Programmable I/O terminal Programmable I/O terminal Reset input of module, Active low reset Module power supply input Common ground Common ground USB data plus USB da ta minus Synchronous data sync Synchronous data input Synchronous data output Synchronous data clock UART data input UART data output UART request to send(active low) Common ground UART clear to send(active low) Serial Peripheral Interface data input Chip select for Synchronous Serial Interface(active low) Serial Peripheral Interface clock Serial Peripheral Interface data output Programmable I/O terminal Programmable I/O terminal Antenna interface Common ground 1 2 3 4 5 6 7 8 9 GND P VCC AIO(0) AIO(1) P IO(0) PIO(1) PIO(2) PIO(3) PIO(4) GND Power Bi -directional Bi -directional Bi -directional Bi -directional Bi -directional Bi -directional Bi -directional 10 11 GND PIO(5) GND Bi -directional 12 PIO(6) Bi -directional 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 PIO(7) PIO(8) PIO(9) RESET V CC GND GND USB_DP USB_DN PCM_SYNC PCM_IN PCM_OUT PCM_CLK UART_RX UART_TX UART_RTS GND UART_CTS SPI_MOSI SPI_CSB SPI_CLK SPI_MISO PIO(11) PIO(10) RF_IO GND Bi -directional Bi -directional Bi -directi onal CMOS input Power GND GND Bi -directional Bi -directional Bi -directional CMOS input CMOS output Bi -directional CMOS input CMOS output CMOS output GND CMOS input CMOS input CMOS input CMOS input CMOS output Bi -directional Bi -directional Analogue GND Part Number LM072 Page Number : 5 of 6 0121 270 6232 | www.lm-technologies.com | [email protected] Part Number LM072 Page Number : 6 of 6 0121 270 6232 | www.lm-technologies.com | [email protected]