Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles Series G A General Specifications Electrical Capacity (Resistive Load) Logic Level: 0.4VA maximum @ 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V) Note: Find additional explanation of operating range in Supplement section. Other Ratings Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Nominal Operating Force: Angle of Throw: Indicators Touch Tilt Tactiles Slides Rotaries Materials & Finishes Actuator: Case: Sealing Rings: Movable Contacts: Stationary Contacts: Base: Power Terminals: Lamp Terminals: Environmental Data Operating Temperature Range: Humidity: Vibration: Shock: 80 milliohms maximum 500 megohms minimum @ 500V DC 500V AC minimum for 1 minute minimum 100,000 operations minimum 100,000 operations minimum 10,000 operations minimum @ 0.1A @ 28V AC/DC 1.30N 28° Polyamide Glass fiber reinforced polyamide Nitrile butadiene rubber Phosphor bronze with gold plating Phosphor bronze with gold plating Glass fiber reinforced polyamide Phosphor bronze with gold plating Phosphor bronze with gold plating –25°C through +55°C (–13°F through +131°F) 90 ~ 95% humidity for 240 hours @ 40°C (104°F) 10 ~ 500Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) PCB Processing Soldering: Wave Soldering recommended. See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. Cleaning: Automated cleaning. See Cleaning specifications in Supplement section. Standards & Certifications The G Series toggles have not been tested for UL recognition or CSA certification. These switches are designed for use in a low-voltage, low-current, logic-level circuit. When used as intended in a logic-level circuit, the results do not produce hazardous energy. Supplement Accessories Fully Illuminated Ultra-Miniature Toggles A38 www.nkk.com A Rockers Distinctive Characteristics Toggles Series G Fully Illuminated Ultra-Miniature Toggles Pushbuttons Fully illuminated toggle for highly visible status indication with LED in red, green, or amber for single color and red/green for bicolor. Programmable Illuminated PB Ultra-miniature size allows high density mounting, and extremely light weight makes these switches ideal for handheld equipment. Keylocks Totally sealed body construction prevents contact contamination and allows time- and money-saving automated soldering and cleaning. Rotaries Molded-in, epoxy sealed terminals lock out flux, solvents, and other contaminants. Tactiles Slides Award-winning STC contact mechanism with benefits unavailable in conventional mechanisms: smooth, positive detent actuation, increased contact stability, and unparalleled logic-level reliability. (Additional STC details in Terms & Acronyms; see Supplement section.) Indicators Touch Tilt .100” x .100” (2.54mm x 2.54mm) terminal spacing conforms to standard PC board grid spacing. Round terminals facilitate easier throughhole mounting on PC boards. Supplement Accessories Actual Size www.nkk.com A39 TYPICAL SWITCH ORDERING EXAMPLE G Pushbuttons Programmable Illuminated PB 2 2 SPDT ON ON J 3 ON OFF C LEDS PC Terminals Actuator NONE Clear ON Single Color P Straight H Right Angle C Red V Vertical D Amber F Green Combines with bicolor LED only ON-NONE-ON only Bicolor CF SPDT ON-NONE-ON Circuit DESCRIPTION FOR TYPICAL ORDERING EXAMPLE Clear Toggle, Red LED G12JHC Red/Green ON-NONE-ON & ON-OFF-ON Right Angle PC Terminals POLES & CIRCUITS Toggle Position Up Pole Throw Model SPDT Center Connected Terminals Down Up Center Down Schematics Note: Terminal numbers are not actually on the switch. LED circuit is isolated and requires an external power source. Slot Slot G12 ON NONE ON 2-3 NONE 2-1 G13 ON OFF ON 2-3 OPEN 2-1 (4) Red 2 (COM) 3 (5) 1 (5) (6) Single Color (6) Green Bicolor ACTUATOR 28° (1.7) Dia .067 Tilt Clear Toggle (3.8) .150 (4.0) Dia .157 LED COLORS & SPECIFICATIONS Touch Indicators Accessories H Combines with single color or bicolor LEDs J Supplement J Circuits Pole 1 Keylocks Rotaries 1 Tactiles Slides Fully Illuminated Ultra-Miniature Toggles A Rockers Toggles Series G Single Color LEDs are an integral part of the switch and not available separately. The electrical specifications shown are determined at a basic temperature of 25°C. Colors Bicolor C D F CF Red Amber Green Red/Green Forward Peak Current I FM 25mA 25mA 25mA 25mA/25mA If the source voltage exceeds the rated voltage, a ballast resistor is required. Continuous Forward Current IF 20mA 20mA 20mA 20mA/20mA Forward Voltage VF 2.0V 2.1V 2.1V 2.0V/2.1V The resistor value can be calculated by using the formula in the Supplement; see Supplement Index. Reverse Peak Voltage VRM 4V 4V 4V 4V/4V Current Reduction Rate Above 25°C ∆I F Ambient Temperature Range A40 www.nkk.com 0.33mA/°C –25° ~ +55°C A (2.54) Typ .100 (0.5) Typ .020 (4.5) .177 (2.54) Typ .100 (7.0) .276 (4.5) .177 (2.54) Typ .100 (0.4) Dia Typ .016 (7.0) .276 Pushbuttons (2.6) .102 (4.5) .177 TYPICAL SWITCH DIMENSIONS (0.4) Dia Typ .016 (2.54) .100 4 5 1 2 28° 6 3 Slot (4.5) .177 (3.8) .150 (1.6) .063 (7.0) .276 (7.0) .276 4 1 5 2 6 3 (2.54) Typ .100 Keylocks (4.0) Dia .157 (0.6) Dia Typ .024 (2.54) Typ .100 (2.6) .102 (2.54) .100 5 & 6 are LED terminals; 4 is a support pin on single color models & an LED terminal on bicolor models. G12JPC Right Angle PC Slides Rotaries (1.7) Dia .067 Straight PC (1.7) Dia .067 (4.0) Dia .157 3 2 (0.4) .016 1 (4.9) .193 (2.6) .102 (0.4) Dia Typ .016 (5.08) .200 (7.8) .307 (3.8) .150 (5.08) .200 (1.6) .063 (10.22) .402 6 5 2 3 4 5 6 (0.6) Dia Typ .024 4 (0.5) .020 (2.54) .100 (2.54) Typ .100 1 (2.54) .100 (5.08) .200 (0.4) Dia Typ .016 (2.54) Typ .100 Tilt Slot Tactiles 28° (7.0) .276 5 & 6 are LED terminals; 4 is a support pin on single color models & an LED terminal on bicolor models. (0.4) .016 (4.0) Dia .157 28° 1 2 4 5 3 6 (7.4) .292 (0.6) Dia Typ .024 (2.6) .102 Slot (0.4) Dia Typ .016 (2.54) .100 (5.3) .209 (1.6) .063 (3.8) .150 (1.0) .039 (5.08) .200 (12.76) .502 (0.5) Typ .020 (2.54) Typ .100 (2.54) .100 Vertical PC 4 1 5 2 6 3 (2.54) Typ .100 (5.08) .200 Accessories (1.7) Dia .067 Indicators G12JHD (0.4) Dia Typ .016 (2.54) .100 (4.5) .177 5 & 6 are LED terminals; 4 is a support pin on single color models & an LED terminal on bicolor models. www.nkk.com Touch (7.0) .276 Vertical (0.5) Typ .020 (0.4) Dia Typ .016 (2.54) Typ .100 (2.54) Typ .100 (2.54) Typ .100 (0.4) Dia Typ .016 V Right Angle Programmable Illuminated PB H Straight G12JVCF A41 Supplement P Rockers PC TERMINALS Toggles Series G Fully Illuminated Ultra-Miniature Toggles