869 MHz SAW Filter 12.5 MHz Bandwidth Part Number: SF0869BA02630S DESCRIPTION • • • 869 MHz SAW bandpass filter with a 12.5 MHz typical 3dB bandwidth. 3.8 x 3.8 mm ceramic SMP. RoHS compliant. TYPICAL PERFORMANCE Spectrum Microwave 324 Clark Street, Worcester, MA 01606, USA • Phone 1-508-852-5400 • Fax 1-508-852-8456 www.SpectrumMicrowave.com DSSF0869BA02630S Rev A 6-Apr-2010 ECN 36650 Page 1 of 3 869 MHz SAW Filter 12.5 MHz Bandwidth Part Number: SF0869BA02630S SPECIFICATION Parameter Min Typ Max Units - 869 - MHz - 2.6 4.5 dB - Amplitude Ripple (Fc+/-1 MHz) Absolute Attenuation (referenced to 0 dB) 0.4 1.5 dB p-p Attenuation (825 to 828 MHz) 40 47 - dB Attenuation (846 to 849 MHz) 35 40 - dB Attenuation (889 to 892 MHz) 30 36 - dB Attenuation (910 to 913 MHz) Source/Load Impedance Ambient Temperature 40 48 50 25 - dB ohms ˚C Center Frequency, Fc 1 Insertion Loss (Fc+/-1 MHz) Notes: - - 1. Defined as the average of the lower and upper 3 dB frequencies. MAXIMUM RATINGS Parameter Storage Temperature Range Operating Temperature Range Input Power Level DC Voltage Min Max -30 -10 - 85 60 0 10 Units ˚C ˚C dBm V MATCHING CIRCUIT B E Input 50 Ω Single-ended Output 50 Ω Single-ended All other pads GND GND Note: External matching components are not required. Spectrum Microwave 324 Clark Street, Worcester, MA 01606, USA • Phone 1-508-852-5400 • Fax 1-508-852-8456 www.SpectrumMicrowave.com DSSF0869BA02630S Rev A 6-Apr-2010 ECN 36650 Page 2 of 3 869 MHz SAW Filter 12.5 MHz Bandwidth Part Number: SF0869BA02630S PACKAGE OUTLINE Units: mm Tolerances are typically ± 0.15 mm except where indicated. Pad Configuration: Input: B Output: E To be grounded: all other pads MARKING SUGGESTED FOOTPRINT ISO 9001 Registered All specifications are believed to be accurate and reliable. However, Spectrum Microwave reserves the right to make changes without notice. © 2010 All rights reserved. Spectrum Microwave 324 Clark Street, Worcester, MA 01606, USA • Phone 1-508-852-5400 • Fax 1-508-852-8456 www.SpectrumMicrowave.com DSSF0869BA02630S Rev A 6-Apr-2010 ECN 36650 Page 3 of 3