10 Segment Light Bar Package Dimensions: Internal Circuit Diagram: 703-0188: All dimensions are in mm Tolerance: ±0.25mm The slope angle of any PIN may be ±5° max Absolute Maximum Ratings at Ta=25°C Parameter Symbol Rating Unit Power Dissipation - Pre Segment Pd 78 mW Pulse Current (1/10 Duty Cycle, 0.1ms Pulse Width) - Per Chip Ifp 100 mA Forward Current - Per Chip If 30 mA Reverse (Leakage) Current - Per Chip Ir 100 μA Reverse Voltage - Per Chip Vr 5 V Operating Temperature Range Topr. -25 to +85 °C Storage Temperature Range Tstg. -40 to +100 °C Soldering Temperature Tsol. Dip Soldering: 260°C for 5sec. Hand Soldering: 350°C for 3 sec. www.element14.com www.farnell.com www.newark.com Page <1> 28/06/12 V1.0 10 Segment Light Bar Electrical & Optical Characteristics: Parameter Symbol Condition Min. Typ. Max. Unit Luminous Intensity - Per Segment Iv If=10mA / Dot 1.7 3.4 Forward Voltage Vf If=20mA / Dot 2.1 Peak Wavelength λp If=20mA / Dot 567 nm Dominant Wavelength λd If=20mA / Dot 572 nm Reverse Current - Per Chip (Leakage Current - Per Chip) Ir Vr=5V Spectrum Line Halfwidth Δλ If=20mA / Dot Response Time T mcd 2.6 100 V μA 30 deg 250 nm Note: Customer’s special requirements are also welcome. Typical Electrical & Optical Characteristics Curves: (25°C Ambient temperature unless otherwise noted) www.element14.com www.farnell.com www.newark.com Page <2> 28/06/12 V1.0 10 Segment Light Bar Part Number Table LED Chip Face Colour Material Emitting Colour Surface Segments AlGaInP / GaAs Green Grey White Part Number 703-0188 Important Notice : This data sheet and its contents (the “Information”) belong to the members of the Premier Farnell group of companies (the “Group”) or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012. www.element14.com www.farnell.com www.newark.com Page <3> 28/06/12 V1.0