RPT-E3 - Gamewell

RPT-E3
Description
Network Repeater
The ARCNET Repeater Module (RPT-E3) is an optional
component of the E3 Series® and S3 Series fire alarm control panels. It allows the following remotable E3 Series and
S3 Series sub-assemblies to connect to the Broadband
network from the remote locations:
• ILI-MB-E3/ILI95-E3 Series
• S3 Series, SLP (Smart Loop Panel)
• ANX-SR/ANX-MR-UTP/ANX-MR-FO
• NGA
The RPT-E3 comes standard with network connections
using unshielded, twisted-pair, copper wire. The following
optional fiber-optic network connections using add-on
modules are available.
• FML-E3 multi-mode fiber module (optional)
• FSL-E3 single-mode fiber module (optional)
Installation
The RPT-E3 is adaptable for an installation in the standard
E3 Series and S3 Series cabinets. Typically, the RPT-E3
module is mounted on standoffs on the top of the right side
of the ILI-MB-E3/ILI95-MB-E3/ANX modules and SLP
motherboard.
For instructions on the installation of the RPT-E3, refer to
the following documents:
• E3 Series® Expandable Emergency Evacuation
Installation/Operation Manual, P/N: 9000-0574
• RPT-E3-UTP Installation Instructions, P/N: 9000-0580
• S3 Series UL Listing Document, P/N: LS10005-051GF-E
Specifications
Operating Voltage:
24 VDC FWR
Operating Current:
0.016 amp
Alarm Current:
0.017 amp
Operating Temperature: 32° to 120° F (0° to 49° C)
Relative Humidity:
0 to 93%, non-condensing at
90° F (32° C)
Wiring Specifications:
Copper Wire:
16 to 18 AWG twisted-pair,
unshielded
Up to 3,000 ft. (914.4 m) between
each node.
Fiber-Optic Cable:
Up to 200 microns (optimized for
(FML-E3 only)
62.5/125 microns).
Up to 8 dB loss between nodes.
Fiber-Optic Cable:
Optimized for 9/125 micrometer
(FSL-E3 only)
cable) @ 1310 nm.
Up to 30dB loss between nodes.
RPT-E3-UTP
Features
• Listed under UL® Standard 864, 9th Edition.
• Provides the capability for networked E3 Series and S3
Series sub-assemblies to connect in Styles 4 or 7
configurations.
• Standard with unshielded, twisted-pair copper wire
network connection.
• Add-on fiber-optic modules allow the network connection through single or multi-mode fiber-optic cables.
• 625K baud ARCNET Repeater.
Ordering Information
Part Number Description
RPT-E3-UTP Network Repeater, unshielded, twisted-pair
FML-E3
FSL-E3
®
E3 Series is a registered trademark of Honeywell International Inc.
®
UL is a registered trademark of Underwriters Laboratories Inc.
Multi-mode fiber-optic module for
RPT-E3-UTP (one channel)
Single-mode fiber-optic module for
RPT-E3-UTP (one channel)
SIGNALING
FM
MEA
Approved
City of
Chicago
City of
FDNY:
Approved Denver
Approved
1
S1869 3025415 COA #6077 7165-1703:0125 Class
Class2
APPROVED
High Rise
GAMEWELL-FCI
12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118
Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.
www.gamewell-fci.com
9020-0609 Rev. L page 1 of 1
©2013 by Honeywell International Inc. All rights reserved.