MA-COM AT-226

Digital Attenuator, 4 Bit, Single Control, 15 dB 0.5 - 2.0 GHz
AT-226
AT-226
Digital Attenuator, 4 Bit, Single Control, 15 dB
0.5 - 2.0 GHz
Features
•
•
•
•
TSSOP-16
Single Control CMOS logic for each bit
Attenuation: 1 dB steps to 15 dB
Low DC Power Consumtion: 50 uW
Low Cost Plastic TSSOP - 16 Package
PIN 16
.037
.033
0,95
0,85
.256
.246
6,5
6,25
Description
The M/A-COM AT-226 is a 4 bit, 1 dB step GaAs MMIC digital
attenuator in a low cost TSSOP-16 surface mount plastic package.
The AT-226 is ideally suited for use where high accuracy, very
low power consumption and low intermodulation products are
required. Typical applications include radio, cellular, wireless
LANs, GPS equipment and other gain/level control circuits.
.177
.169
4,5
4,29
PIN 1
.169
BSC
4,5
.201
.193
5,11
4,9
The AT-226 is fabricated using mature 1 micron GaAs MESFET
process. The process features full chip passivation for increased
performance and reliability.
PIN Configuration
1,2
Functional Schematic
Vs
RF1 GND GND GND GND GND GND RF2
P IN 1 6
Pin No.
1,2,7,8
3
4
5
6
9
10,11,12,13,14,15
16
Truth Table
8
4
2
1
P IN 1
GND GND VC1
VC2 VC3
VC4
GND GND
1. Required external blocking caps shown
2. VS can be applied at RF1 or RF2 using a 10KΩ or greater pull-up
resistor.
VC1
1
1
1
1
0
0
VC2
1
1
1
0
1
0
Function
GND
VC1
VC2
VC3
VC4
RF2
GND
RF1
Description
RF Ground
Control 1
Control 2
Control 3
Control 4
RF in/out
RF Ground
RF in/out
1, 2, 3
VC3
1
1
0
1
1
0
VC4
1
0
1
1
1
0
Attenuation (dB)
Reference I.L.
1
2
4
8
15
1. Logic 0 = 0 + 0.2 V
2. Logic 1 = +5 V @ 30 µA max. current total
3. VS = +5 V
V3.00
M/A-COM Division of AMP Incorporated 3 North America: Tel. (800) 366-2266, Fax (800) 618-8883 3 Asia/Pacific: Tel.+85 2 2111 8088, Fax +85 2 2111 8087
3 Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020
www.macom.com
AMP and Connecting at a Higher Level are trademarks.
Specifications subject to change without notice.
Digital Attenuator, 4 Bit, Single Control, 15 dB 0.5 - 2.0 GHz
AT-226
Electrical Specifications at TA = +25°C
Parameter
Reference Insertion Loss
Test Conditions
0.5 - 1.0 GHz
1.0 - 2.0 GHz
0.5 - 1.0 GHz
1.0-2.0 GHz
0.5 - 2.0 GHz
Attenuation Accuracy
VSWR
Trise,Tfall
Ton, Toff
P1dB
IP2
Input Power
Measured Relative to Input Power
Two Tone input up to 5dBm, 5MHz
Spacing
Measured Relative to Input Power
Two Tone input up to 5dBm, 5MHz
Spacing
IP3
Units
dB
dB
Min.
Typ.
1.3
1.0
Max.
1.6
1.3
±(0.25 dB + 5% of Attenuation setting in dB) dB
±(0.4 dB + 5% of Attenuation setting in dB) dB
>0.5 GHz
>0.5GHz
µs
µs
dBm
dBm
1.3:1
2.5
1.0
24
80
>0.5GHz
dBm
47
1.8:1
Typical Performance Curves
16
Relative Attenuation
12
10
IL(dB)
ATTENUATION (dB)
14
8
6
4
2
0
0.5
1
1.5
2
2.5
2.0
1.8
1.6
1.4
1.2
1.0
0.8
0.6
0.4
0.2
0.0
Insertion Loss
+85°C
-40°C
+25°C
0.5
3
1
1.5
2
FREQUENCY (GHz)
FREQUENCY (GHz)
15dB
TWC* for all states
2, 4dB
0.5
1
3
1
Input VSWR
VSWR
VSWR
1
2
1.9
1.8
1.7
1.6
1.5
1.4
1.3
1.2
1.1
1
2.5
1.5
2
2.5
FREQUENCY (GHz)
1. TWC = Typical worst case over all states
3
2
1.9
1.8
1.7
1.6
1.5
1.4
1.3
1.2
1.1
1
Output VSWR
TWC* for all states
15dB
2, 4dB
0.5
1
1.5
2
FREQUENCY (GHz)
2.5
3
1. TWC = Typical worst case over all states
V3.00
M/A-COM Division of AMP Incorporated 3 North America: Tel. (800) 366-2266, Fax (800) 618-8883 3 Asia/Pacific: Tel.+85 2 2111 8088, Fax +85 2 2111 8087
3 Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020
www.macom.com
AMP and Connecting at a Higher Level are trademarks.
Specifications subject to change without notice.
Digital Attenuator, 4 Bit, Single Control, 15 dB 0.5 - 2.0 GHz
AT-226
0.15
0.1
0.05
0
-0.05
-0.1
-0.15
-0.2
-0.25
Delta ATT +25°C to -40°C
8dB
4dB
2dB
1dB
Attenuation Accuracy vs Frequency
0.4
0.2
0
1dB
2dB
4dB
8dB
15dB
-0.4
-0.6
1
1.5
2
FREQUENCY (GHz)
2.5
3
0.5
1
1.5
2
2.5
3
FREQUENCY (GHz)
Delta ATT +25°C to+85°C
Absolute Maximum Ratings
0.2
DELTA (dB)
0.6
-0.2
15dB
0.5
0.25
DEVIATION FROM NOMINAL
ATTENUATION (dB)
DELTA (dB)
Typical Performance Curves (Cont’d)
Parameter
15dB
0.15
1
Maximum Ratings
Maximum Input Power
0.1
1dB
0.05
0
8dB
-0.05
-0.1
0.5
1
1.5
2
+27 dBm
500 - 2000 MHz
+34 dBm
Control Voltage
2dB
4dB
50 MHz
2.5
FREQUENCY (GHz)
3
+8 V, -1.0 V
Operating Temperature
-40°C to +85°C
Storage Temperature
-65°C to +150ºC
1. Exceeding these limits may cause permanent damage.
V3.00
M/A-COM Division of AMP Incorporated 3 North America: Tel. (800) 366-2266, Fax (800) 618-8883 3 Asia/Pacific: Tel.+85 2 2111 8088, Fax +85 2 2111 8087
3 Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020
www.macom.com
AMP and Connecting at a Higher Level are trademarks.
Specifications subject to change without notice.
Digital Attenuator, 4 Bit, Single Control, 15 dB 0.5 - 2.0 GHz
AT-226
V3.00
M/A-COM Division of AMP Incorporated 3 North America: Tel. (800) 366-2266, Fax (800) 618-8883 3 Asia/Pacific: Tel.+85 2 2111 8088, Fax +85 2 2111 8087
3 Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020
www.macom.com
AMP and Connecting at a Higher Level are trademarks.
Specifications subject to change without notice.