5XRGB-F2-F Features: ◆ CMOS Technology ◆ Designed for bonding with LED chip ◆ Blinking Frequency: 15s/Cycle ◆ Frequency tolerance : ±20% ◆ With both sink and source output drivers Package Dimensions: Part No. 5XRGB-F2-F Chip Material Lens Color Source Color AlGaInP Water Clear Water Clear Water Clea Red InGaN InGaN Green Blue Notes: 1.All dimensions are in millimeters (inches). 2.Tolerance is ±0.25mm (.010”)unless otherwise noted. 3.Protruded resin under flange is 1.5mm(.059”)max. 4.Lead spacing is measured where the leads emerge from the package. 5.Specifications are subject to change without notice. Part No. 5XRGB-F2-F Spec No. S/N-050909125 Page 1 of 3 Version: 1.0 5XRGB-F2-F Absolute Maximum Ratings at Ta=25℃ Light color：Red、Green、 Blue Color z Reverse current：100 μA z Peak current（duty＝0.1,1KHz）：100 mA z Operating/Storage temperature range：-30℃~ +85℃ z Derating linear from 25℃：0.4 mA/℃ z Lead soldering temperature range：260℃ for 5 second Electrical Optical Characteristics at Ta=25℃ RED COLOR： Parameter Test Condition IF＝20 mA Symbol Min Typ. Max Unit Forward voltage VF 2.00 2.25 Luminous intensity IV 800 Peak emission wavelength λp 620 630 640 nm Half intensity angle △Θ 40 deg Symbol Min Typ. Forward voltage VF 3.3 Luminous intensity IV 2000 Peak emission wavelength λp 515 520 530 nm Half intensity angle △Θ 30 deg Symbol Min Typ. Forward voltage VF 3.3 Luminous intensity IV 1000 V 1500 mcd IF＝20 mA GREEN COLOR： Parameter Test Condition IF＝20 mA Max Unit 4 V 4000 mcd IF＝20 mA BLUE COLOR： Parameter Peak emission wavelength λp Half intensity angle △Θ Symbol VDD Max Unit 4 V 2000 mcd Test Condition IF＝20 mA IF＝20 mA 460 475 nm 30 deg Min 3.3 Typ. 3.5 Max Unit 4.0 V Direct Current Characteristics Parameter Operating voltage Remarks Driver Current Iol 50 mA @VDS=1.2V Power Consumption Po 225 mW VDD=3.5V Ftet 1.5 Hz External±30% Flash Frequency *All specs and applications shown above subject to change without prior notice. (以上电路及规格仅供参考，本公司可进行修正) Part No. 5XRGB-F2-F Spec No. S/N-050909125 Page 2 of 3 Version: 1.0 Application diagram and Dimensions Application Diagram Dimensions Note: Unit:mm Output Sketch Map *All specs and applications shown above subject to change without prior notice. (以上电路及规格仅供参考，本公司可进行修正) Notes: 1. Luminous intensity is measured with a light sensor and filter combination that approximates the CIE eye-response curve. 2. θ1/2 is the off-axis angle at which the luminous intensity is half the axial luminous intensity. 3. The dominant wavelength (λP) is derived from the CIE chromaticity diagram and represents the single wavelength which defines the color of the device. Part No. 5XRGB-F2-F Spec No. S/N-050909125 Page 3 of 3 Version: 1.0