GaAs Matched SP4T Switch 0.02-2 GHz Features FP-26 0.625 ± 0.020 (15.88 ± 0.5) • Internal CMOS Decoder/Driver • Low Power Consumption • Fast Switching Speed, 60 ns Typ • Very High Intercept Points .015 ± .003 x .010 ± .003 Thk. 20 Places (0.38 ± 0.08 x 0.25 ± 0.08) Guaranteed Specifications1 (From -55°C to +85°C) Frequency Range Insertion Loss RF1 RF RF4 0.625 ± 0.020 (15.88 ± 0.5) Pin #1 0.02 – 2.0 GHz 0.02 – 2.0 GHz 0.02 – 1.0 GHz 0.02 – 0.5 GHz 2.8 dB Max 2.4 dB Max 1.8 dB Max VSWR Common, RF1 – RF4 On 2.0:1 Max 1.6:1 Max 1.5:1 Max 1.5:1 Max 1.4:1 Max 0.2 – 2.0 GHz 0.2 – 1.0 GHz 0.2 – 0.5 GHz 0.1 – 0.2 GHz 0.02 – 0.1 GHz Isolation SW-369 RF1 - RF4 Off 2.0:1 Max 1.6:1 Max 1.5:1 Max 1.7:1 Max Not Specified 0.02 – 2.0 GHz 0.02 – 1.0 GHz 0.02 – 0.5 GHz 40 dB Min 45 dB Min 50 dB Min Operating Characteristics Impedance RF2 PIN #11 0.050 TYP (1.27) 0.088 (2.24) RF3 0.270 (6.86) Min Typ. 0.450 (11.43) REF 0.070 (1.78) Bottom of case is AC ground. Dimensions in ( ) are in mm. Unless Otherwise Noted: .xxx = ± 0.010 (.xx = ± 0.25) .xx = ± 0.02 (.x = ± 0.5) 50 Ohms Nominal Switching Characteristics Trise,Tfall (10% to 90% RF) Ton, Toff (50% CTL to 90/10% RF) Transients (in band) 8 ns Typ 60 ns Typ 50 mV Typ Input Power for 1 dB Compression 0.5 – 2.0 GHz 0.05 GHz +23 dBm Typ +17 dBm Typ Intermodulation Intercept Point (for two-tone input power up to +5 dBm) Intercept Points IP2 IP3 0.5 – 2.0 GHz +72 +44 dBm Typ 0.05 GHz +50 +40 dBm Typ Bias Power +5 VDC @ Ordering Information Model No. Package SW-369 PIN Flatpack Functional Schematic (Top View) 2 mA Max Control Voltages Vin Low (0) 0.0 to 1.5 V @ 1 µA Max Vin High (1) 3.5 to 5.0 V @ 1 µA Max 1. All specifications apply with 50 ohm impedance to all RF ports with 0 and +5 Vdc control voltages. 2. Contact the factory for standard or custom screening requirements. RF1 RF2 +5V CMOS2 CMOS1 RF COMMON RF3 RF4 Specifications Subject to Change Without Notice. M/A-COM Inc. 0.150 (3.81) Max ■ 1011 Pawtucket Boulevard, Lowell, MA 01853 USA V2.0 ■ Telephone: 800-366-2266 GaAs Matched SP4T Switch SW-369 Absolute Maximum Ratings Typical Performance INSERTION vs.VS FREQUENCY INSERTIONLOSS LOSS FREQUENCY Absolute Maximum1 Max. Input Power 0.05 GHz 0.5 – 2.0 GHz2 Bias Voltage Control Voltage +27 dBm +34 dBm -0.5 to +7V -0.5 to Vcc +0.5V Operating Temperature Storage Temperature -55°C to +125°C -65°C to +150°C 2.5 INSERTION LOSS (dB) Parameter 2.0 1.5 1.0 0.5 0.0 0.02 1. Operation of this device above any one of these parameters may cause permanent damage. 2. When the RF input power is applied to the terminated port, the absolute maximum is +30 dBm. 0.5 1.0 1.5 2.0 1.0 1.5 FREQUENCY (GHz) 2.0 FREQUENCY (GHz) ISOLATIONvs.VSFREQUENCY FREQUENCY ISOLATION 80 Pin No. Description Pin No. Description 1 RF1 11 RF2 2 GND 12 GND 3 GND 13 GND 4 GND 14 +5VDC 5 RF Common 15 CMOS 2 6 GND 16 CMOS 1 7 GND 17 N/C 8 GND 18 GND 9 GND 19 GND 10 RF4 20 RF3 ISOLATION (dB) Pin Configuration 70 60 50 40 30 0.02 0.5 VSWRvs. VS FREQUENCY FREQUENCY VSWR 2.0 Truth Table 1.8 ON STATE Condition of Switch "1" = Logic High (CMOS) RF Common to Each RF Port CMOS 1 CMOS 2 RF1 RF2 RF3 RF4 0 1 0 1 0 0 1 1 ON OFF OFF OFF OFF ON OFF OFF OFF OFF ON OFF OFF OFF OFF ON VSWR Control Inputs 1.6 1.4 OFF STATE 1.2 1.0 0.02 0.5 1.0 1.5 FREQUENCY (GHz) Specifications Subject to Change Without Notice. M/A-COM Inc. ■ 1011 Pawtucket Boulevard, Lowell, MA 01853 USA 2.0 V2.0 ■ Telephone: 800-366-2266