rdrw series

ASSEMBLY INSTRUCTIONS FOR
DRAWER UNIT
RDRW SERIES
BUL10088
REV. G
PAGE 1 OF 1
2
1
5
A Not Included
3
Pull lever to
separate slide
7
4
6
Install screws
loose until drawer
body is re-installed
then tighten.
6
Install screws
loose until drawer
body is re-installed
then tighten.
DETAIL B
ASSEMBLY INSTRUCTIONS:
DETAIL A
READ BEFORE ATTEMPTING TO INSTALL!
A) Separate drawer body (item 1) from shroud (item 2) by pulling levers on
inner slide section attached to drawer body.
B) Mount shroud (item 2) to cabinet rai ls at desired height using (4) 10-32
pan head screws (item 6).
Do Not Tighten 10-32 Screws at this p oint. (See detail A)
ITEM No.
1
2
3
4
5
6
7
PARTS LIST
DESCRIPTION
DRAWER BODY
SHROUD
BALL BEARING SLIDE
REAR RAIL BRACKETS
MOUNTING RAIL (NOT INCLUDED)
10-32 SCREW
8-32 KEP NUT
TOOL BOX
Phillips
Screw Driver
Tape
Measure
QTY
1
1
2
2
4
8
4
C) Mount rear rail brackets (item 4) to shroud by placing the brackets over
both studs located in the upper rear corners. Slide brackets to suit set depth
between the cabinet rails and then fasten in place using (2) 8-32 KEP nuts
(item 7) as shown.
Secure rear rail bracket to mounting rail using 10-32 pan head screws.
Do Not Tighten 10-32 Screws at this point. (See detail B)
D) Install drawer by lining up both halves of the slides and then pushing the
drawer into the closed position.
Do Not Force or cause the drawer to twist when closing.
E) Tighten 10-32 screws (item 6) once drawer body is installed.
HAMMOND
MANUFACTURING
TM
ELECTRONICS GROUP
visit our website @ www.hammondmfg.com