CONTEMPRA 3/IME - SERIES ASSEMBLY INSTRUCTIONS FOR 3 PNT DOOR LATCH AND HINGE BUL10121 REV. A PAGE 1 OF 2 ASSEMBLY INSTRUCTIONS: A) Note: Doors (item 1) can be mounted on front and rear of rack B) Mount door hook (item 2) and hinge body (item 3) as per instructions on page 2. 4 C) Position door so that the matting part of hinge barrel on door aligns with the hinge barrels on the body. Slip hinge pins (item 4) thru barrels and secure with a light tap from hammer. D) Pull and rotate L handle on door to open posistion then close and check latching mechanism alignment with door hooks. Adjust door hooks if necessary. Solid door left hand hinge 1 3 Window door left hand hinge Rack Frame 2 Door hook 3 places see PAGE 2 for details ITEM No. 1 2 3 4 PARTS LIST DESCRIPTION SOLID OR WINDOW DOOR DOOR HOOK HINGE BODY HINGE PIN TOOL BOX 1/4 Slotted Head Screw Driver Hammer QTY 1 3 3 3 L handle C/W 3 point latching mechanism installed HAMMOND MANUFACTURING TM ELECTRONICS GROUP visit our website @ www.hammondmfg.com CONTEMPRA 3/IME - SERIES ASSEMBLY INSTRUCTIONS FOR 3 PNT DOOR LATCH AND HINGE BUL10121 REV. A PAGE 2 OF 2 ASSEMBLY INSTRUCTIONS: A) Mount door hook (item 2) to right of rack frame as shown. Mount thru outside slots in frame using M6 screws, and hex nuts (item 6 & 7). B) Mount hinge body (item 3) to left of rack frame as shown. Mount thru inside slots in frame using M6 screws (item 6), and tapped mounting plate (item 5). Gasket betweein MTG plate and rack frame. C) Doors are mounted using hinge pins provided. See PAGE 1 for details. Rack Frame 5 Mount hinge body using inside slots on corner post see STEP B 3 Gasket is between rack frame and tapped plate see STEP B 6 7 2 PARTS LIST ITEM No. DESCRIPTION SOLID OR WINDOW DOOR 1 DOOR HOOK 2 HINGE BODY 3 HINGE PIN (SHOWN ON PAGE 1) 4 TAPPED MOUNTING PLATE WITH GASKET 5 M6-1 X 12 mm FLAT HD SCREW 6 M6-1 HEX NUT 7 TOOL BOX 1/4 Slotted Head Screw Driver Hammer 10 mm Socket Wrench QTY 1 3 3 3 3 12 6 6 Mount door hook using ouside slots on rack frame see STEP A