P(C)10NG-xxxxE/Z2:1(H30)LF PMB-SERIES Rev.12-2008 2 Watt 2:1 Wide Input Reg. Single and Dual Output 1 - 3 kV DC I/O Isolation SIP8 case On/Off Control (optional) Contin. Short Circuit Protection Mainzer Straße 151–153 D-55299 Nackenheim Tel. +49 6135 7026-0 Fax: +49 6135 931070 www.peak-electronics.de [email protected] The PMB 2Watt series is a family of cost effective 2W single and dual output DC/DC converters with an optional control Pin (SIP). These converters are encapsulated in an ultra miniature SIP8 or DIP16 plastic or metal case. High performance features: continuous / long time short circuit protection with automatic restart and tight line / load regulation, high efficiency operation and output voltage accuracy of ±2% maximum. All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified Input Specifications Voltage Range Input Filter Input Reflected Ripple Current¹ 2:1 Wide Input (see table) Capacitor 35 mA pk-pk Output Specifications Voltage Accuracy Short Circuit Protection Line Regulation Load Regulation (25% - 100%) Ripple and Noise (20Mhz bandwidth) Temperature Coefficient ± 2% Indefinite (Automatic Recovery) ± 0.5% ± 1% 80 mV pk-pk ± 0.02% / °C General Specifications I/O Isolation Voltage (3 sec.) I/O Isolation Capacity I/O Isolation Resistance Switching Frequency Humidity Reliability Calculated MTBF (MIL-HDBK-217F) 1000 VDC (3000 VDC optional)* 60 pF 1000 M Ohm 100 - 650 kHz 95% rel H > 2.732 Mhrs Physical Specifications Case Material Potting Material Weight Non Conductive Black Plastic (UL94V-0 rated) Epoxy (UL94V-0 rated) ~ 4.5g, typ. Environment Specifications Operating Temperature Maximum Case Temperature Storage Temperature Cooling RoHS Conform -40 to +85°C (ambient) 100°C -40 to +125°C Free Air Convection Soldering 260°C, max. (1.5mm from case 10s.) PMB-Series – P(C)10NG-xxxxE/Z2:1(H30)LF – Single / Dual Output – SIP8 - Plastic Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 1/4 Selection Guide Single Output A) ) ) m A) d (m ad ( (mA ad (mA a o ) d o L a L C ll Lo n. D F)² C) Lo t Mi t Fu d (u (VD e (V Full No ) n n a g t t e e e o a n n % r r g t y( rre rre lta or L Vol C ur Cur ienc t Vo t Cu put Cu acit put put pu t In p u Inpu In O ut O ut O ut Effic C ap Order # SINGLE OUTPUT P10NG-053R3E2:1LF P10NG-0505E2:1LF P10NG-0509E2:1LF P10NG-0512E2:1LF P10NG-0515E2:1LF P10NG-0524E2:1LF P10NG-123R3E2:1LF P10NG-1205E2:1LF P10NG-1209E2:1LF P10NG-1212E2:1LF P10NG-1215E2:1LF P10NG-1224E2:1LF P10NG-243R3E2:1LF P10NG-2405E2:1LF P10NG-2409E2:1LF P10NG-2412E2:1LF P10NG-2415E2:1LF P10NG-2424E2:1LF P10NG-483R3E2:1LF P10NG-4805E2:1LF P10NG-4809E2:1LF P10NG-4812E2:1LF P10NG-4815E2:1LF P10NG-4824E2:1LF 4.5-9 4.5-9 4.5-9 4.5-9 4.5-9 4.5-9 9-18 9-18 9-18 9-18 9-18 9-18 18-36 18-36 18-36 18-36 18-36 18-36 36-72 36-72 36-72 36-72 36-72 36-72 15 15 30 30 30 60 15 15 15 15 15 15 8 8 8 8 8 8 6 6 6 6 6 6 492 571 555 555 547 533 205 216 213 208 213 208 98 108 104 104 104 104 48 56 53 53 53 52 3.3 5 9 12 15 24 3.3 5 9 12 15 24 3.3 5 9 12 15 24 3.3 5 9 12 15 24 125 100 56 42 33 21 125 100 56 42 33 21 125 100 56 42 33 21 125 100 56 42 33 21 500 400 222 167 133 83 500 400 222 167 133 83 500 400 222 167 133 83 500 400 222 167 133 83 67 70 72 72 73 75 67 77 78 80 78 80 70 77 80 80 80 80 71 74 78 78 78 80 3300 3300 470 470 470 220 3300 3300 470 470 470 220 3300 3300 470 470 470 220 3300 3300 470 470 470 220 If you need other specifications, please enquire. *OPTIONS: Control On/Off 3 kV I/O Isolation For Optional control Pin please add “C” between P and 10 (for example: PC10NG-2424E2:1LF) For optional 3kV DC I/O Isolation, please add “H30” before LF! (P10NG-2424E2:1H30LF for 3kV) PMB-Series – P(C)10NG-xxxxE/Z2:1(H30)LF – Single / Dual Output – SIP8 - Plastic Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 2/4 Selection Guide Dual Output ) A) ) (m A d (m mA) ad (mA d ( a a o ) d o in . L Loa ull L uF)² VDC l l Lo DC) ) nt M nt F ad ( ge ( t N o re n t F u e (V e e o a n % r r g t L ( r r l e a r u u r o t r y r l o V C C t Vo ienc t Cu put Cu acit put put pu t In p u Inpu In O ut O ut O ut Effic C ap Order # DUAL OUTPUT P10NG-053R3Z2:1LF P10NG-0505Z2:1LF P10NG-0509Z2:1LF P10NG-0512Z2:1LF P10NG-0515Z2:1LF P10NG-0524Z2:1LF P10NG-123R3Z2:1LF P10NG-1205Z2:1LF P10NG-1209Z2:1LF P10NG-1212Z2:1LF P10NG-1215Z2:1LF P10NG-1224Z2:1LF P10NG-243R3Z2:1LF P10NG-2405Z2:1LF P10NG-2409Z2:1LF P10NG-2412Z2:1LF P10NG-2415Z2:1LF P10NG-2424Z2:1LF P10NG-483R3Z2:1LF P10NG-4805Z2:1LF P10NG-4809Z2:1LF P10NG-4812Z2:1LF P10NG-4815Z2:1LF P10NG-4824Z2:1LF 4.5-9 4.5-9 4.5-9 4.5-9 4.5-9 4.5-9 9-18 9-18 9-18 9-18 9-18 9-18 18-36 18-36 18-36 18-36 18-36 18-36 36-72 36-72 36-72 36-72 36-72 36-72 20 20 20 25 25 60 15 15 15 15 15 30 8 8 8 8 8 20 6 6 6 6 6 12 471 571 540 533 533 563 188 222 210 208 210 219 94 106 105 104 104 106 47 56 53 53 52 55 ± 3.3 ± 5.0 ± 9.0 ± 12.0 ± 15.0 ± 24.0 ± 3.3 ± 5.0 ± 9.0 ± 12.0 ± 15.0 ± 24.0 ± 3.3 ± 5.0 ± 9.0 ± 12.0 ± 15.0 ± 24.0 ± 3.3 ± 5.0 ± 9.0 ± 12.0 ± 15.0 ± 24.0 ± 63 ± 50 ± 28 ± 21 ± 17 ± 10 ± 63 ± 50 ± 28 ± 21 ± 17 ± 10 ± 63 ± 50 ± 28 ± 21 ± 17 ± 10 ± 63 ± 50 ± 28 ± 21 ± 17 ± 10 ± 250 ± 200 ± 111 ± 83 ± 67 ± 42 ± 250 ± 200 ± 111 ± 83 ± 67 ± 42 ± 250 ± 200 ± 111 ± 83 ± 67 ± 42 ± 250 ± 200 ± 111 ± 83 ± 67 ± 42 70 70 74 75 75 71 73 75 79 80 79 76 73 78 79 80 80 78 73 74 79 79 80 75 ± 1000 ± 1000 ± 220 ± 220 ± 220 ± 100 ± 1000 ± 1000 ± 220 ± 220 ± 220 ± 100 ± 1000 ± 1000 ± 220 ± 220 ± 220 ± 100 ± 1000 ± 1000 ± 220 ± 220 ± 220 ± 100 If you need other specifications, please enquire. *OPTIONS: Control On/Off 3 kV I/O Isolation For Optional control Pin please add “C” between P and 10 (for example: PC10NG-2424Z2:1LF) For optional 3kV DC I/O Isolation, please add “H30” before LF! (P10NG-2424Z2:1H30LF for 3kV) PMB-Series – P(C)10NG-xxxxE/Z2:1(H30)LF – Single / Dual Output – SIP8 - Plastic Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 3/4 0.50 (0.02) 3.05 (0.12) 11.10 (0.44) 3,50 (0.14) 0.25 (0.01) Package / Pinning / Derating PIN CONNECTIONS # SINGLE DUAL SINGLE "C" 1 - Vin - Vin - Vin 2 +Vin +Vin +Vin 3 Omitted N.C. Ctrl. 5 Omitted N.C. N.C. 6 +Vout +Vout +Vout 7 - Vout - Vout - Vout 8 N.C. Common N.C. DUAL "C" - Vin +Vin Ctrl. N.C. +Vout - Vout Common (Same pinning for 3kv I/O isolation) App Notes: ¹ = Measured Input reflected ripple current with a simulated source inductance of 12uH ² = Tested by nominal Vin and constant resistive load. - Operation under no-load conditions will not damage these devices, but they will not observe the listed specifications. MCU (Master Control Unit) The MCU Pin Voltage is referenced to –Vin (Pin1) ON: 0 – 0.8 VDC / open / short circuit Pin1 and Pin3 OFF: 5 VDC OFF idle current: 5mA, typ. PMB-Series – P(C)10NG-xxxxE/Z2:1(H30)LF – Single / Dual Output – SIP8 - Plastic Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 4/4