P8SG-xxxxE/Z(H30)MLF PM5-SERIES Rev.11-2008 1.5 Watt Regulated DIP24 Metal Case 1 - 3 kV DC I/O Isolation Single and Dual Output Continuous Short Circuit Prot. Full SMD Technology Mainzer Straße 151–153 D-55299 Nackenheim Tel. +49 6135 7026-0 Fax: +49 6135 931070 www.peak-electronics.de [email protected] The PM5 series P8SG-xxxxE/Z(H30)MLF is a family of cost effective 1.5 W single and dual output DC/DC converters. These converters are encapsulated in an ultra miniature DIP24 metal case. High performance features: 1000VDC, optional up to 3000VDC input/output isolation, high efficiency operation, output voltage accuracy of ±2% maximum, input range of ±10% tolerance and low output ripple and noise. All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified Input Specifications Voltage Range Input Filter Input Reflected Ripple Current¹ ± 10% Pi Type 35 mA pk-pk Output Specifications Voltage Accuracy Short Circuit Protection Line Regulation Load Regulation (0% - 100%) Ripple and Noise (20Mhz bandwidth) Temperature Coefficient ± 2% Indefinite (automatic recovery) ± 0.5% ± 0.5% (3.3Vout Models: ± 1.5%) 75 mV pk-pk ± 0.02% / °C General Specifications Efficiency I/O Isolation Voltage (3 sec.) I/O Isolation Capacity I/O Isolation Resistance Switching Frequency (typical) Humidity Reliability Calculated MTBF (MIL-HDBK-217F) See Table 1000 VDC (up to 3000 VDC optional)* 60 pF, typ. 1000 M Ohm 40 kHz (Single out); 350 kHz (Dual out) 95% rel H > 3.072 Mhrs Physical Specifications Case Material Potting Material Weight Nickel Coated Copper Epoxy (UL94V-0 rated) ~ 15g, typ. Environment Specifications Operating Temperature Maximum Case Temperature Storage Temperature Cooling RoHS Conform -40 to +85°C (ambient) 100°C -40 to +125°C Free Air Convection Soldering 260°C, max. (1.5mm from case 10s.) PM5-Series – P8SG-xxxxE/Z(H30)MLF – Single and Dual Output – DIP24 - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 1/3 Selection Guide Single/Dual Output ) ) mA) (mA ad (mA ad ( ) d o L a C ) o L F)² D C Lo ull d (u (VD e (V F u ll No nt F ) a t g t e e o n a n r % g t L r ( l e e rr y rr lta or Vo Cu t Vo t Cu put Cu ienc acit put put In p u In p u In O ut O ut Effic Cap Order # SINGLE OUTPUT P8SG-053R3EMLF P8SG-0505EMLF P8SG-0509EMLF P8SG-0512EMLF P8SG-0515EMLF P8SG-0524EMLF P8SG-123R3EMLF P8SG-1205EMLF P8SG-1209EMLF P8SG-1212EMLF P8SG-1215EMLF P8SG-1224EMLF P8SG-243R3EMLF P8SG-2405EMLF P8SG-2409EMLF P8SG-2412EMLF P8SG-2415EMLF P8SG-2424EMLF DUAL OUTPUT P8SG-053R3ZMLF P8SG-0505ZMLF P8SG-0509ZMLF P8SG-0512ZMLF P8SG-0515ZMLF P8SG-0524ZMLF P8SG-123R3ZMLF P8SG-1205ZMLF P8SG-1209ZMLF P8SG-1212ZMLF P8SG-1215ZMLF P8SG-1224ZMLF P8SG-243R3ZMLF P8SG-2405ZMLF P8SG-2409ZMLF P8SG-2412ZMLF P8SG-2415ZMLF P8SG-2424ZMLF 5 5 5 5 5 5 12 12 12 12 12 12 24 24 24 24 24 24 50 50 50 50 50 50 40 40 40 40 40 40 35 35 35 35 35 35 517 454 468 441 441 461 203 189 186 178 195 201 103 100 97 93 94 94 3.3 5 9 12 15 24 3.3 5 9 12 15 24 3.3 5 9 12 15 24 400 300 167 125 100 62 400 300 167 125 100 62 400 300 167 125 100 62 51 66 64 68 68 65 54 66 67 70 64 62 53 62 64 67 66 66 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 220 5 5 5 5 5 5 12 12 12 12 12 12 24 24 24 24 24 24 50 50 50 50 50 50 35 35 35 35 35 35 15 15 15 15 15 15 440 461 447 428 447 454 171 183 178 166 173 176 83 89 85 80 83 84 ± 3.3 ±5 ±9 ± 12 ± 15 ± 24 ± 3.3 ±5 ±9 ± 12 ± 15 ± 24 ± 3.3 ±5 ±9 ± 12 ± 15 ± 24 ± 200 ± 150 ± 83 ± 63 ± 50 ± 31 ± 200 ± 150 ± 83 ± 63 ± 50 ± 31 ± 200 ± 150 ± 83 ± 63 ± 50 ± 31 60 65 67 70 67 66 64 68 70 75 72 71 66 70 73 78 75 74 ± 1000 ± 1000 ± 470 ± 470 ± 470 ± 220 ± 1000 ± 1000 ± 470 ± 470 ± 470 ± 220 ± 1000 ± 1000 ± 470 ± 470 ± 470 ± 220 If you need other specifications, please enquire. * For optional 3kV DC I/O Isolation, please add “H30” before MLF! Example: P8SG-1205ZH30MLF for 3kV PM5-Series – P8SG-xxxxE/Z(H30)MLF – Single and Dual Output – DIP24 - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 2/3 Package / Pinning / Derating 27.94 (1.10) 15.24 (0.60) 1 All dimensions are typical in millimeters (inches). - Pin diameter: 0.5 +/-0.05 (0.02 +/-0.002) - Pin pitch tolerance: +/-0.35 (+/-0.014) - Case tolerance +/-0.5 (+/-0.02) Standard Drawing For exact pinning please see connection table! Specification may change without notice. 12 Bottom View 24 13 2.54 (0.10) DIP24 – METAL CASE 2.00 (0.08) 10.20 (0.40) 20.30 (0.80) PEAK Modelcode Datecode 31.80 (1.25) 3.05 (0.12) # 1 2 3 10 11 12 13 14 15 22 23 24 SINGLE +Vin N.C. N.C. - Vout +Vout - Vin - Vin +Vout - Vout N.C. N.C. +Vin PIN CONNECTIONS SINGLE 3KV DUAL +Vin +Vin - Vout +Vin Common Omitted Common Omitted +Vout Omitted - Vin - Vout - Vin +Vout +Vout Omitted Common Omitted Common Omitted - Vout - Vin +Vin - Vin DUAL 3KV +Vin +Vin Omitted Common Common Omitted - Vout Omitted + Vout Omitted - Vin - Vin App Notes: ¹ = Measured Input reflected ripple current with a simulated source inductance of 12uH. ² = Tested by minimal Vin and constant resistive load. PM5-Series – P8SG-xxxxE/Z(H30)MLF – Single and Dual Output – DIP24 - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 3/3