P10SG-xxxxE/Z(H30)MLF PM5-SERIES Rev.11-2008 2 Watt Regulated DIP24 Metal Case 1 - 3 kV DC I/O Isolation Single and Dual Output Continuous Short Circuit Prot. Full SMD Technology Mainzer Straße 151–153 D-55299 Nackenheim Tel. +49 6135 7026-0 Fax: +49 6135 931070 www.peak-electronics.de [email protected] The PM5 series P10SG-xxxxE/Z(H30)LF is a family of cost effective 2 W single and dual output DC/DC converters. These converters are encapsulated in an ultra miniature DIP24 metal case. High performance features: 1000VDC, optional up to 3000VDC input/output isolation, high efficiency operation, output voltage accuracy of ±2% maximum, input range of ±10% tolerance and low output ripple and noise. All specifications typical at Ta=25°C, nominal input voltage and full load unless otherwise specified Input Specifications Voltage Range Input Filter Input Reflected Ripple Current¹ ± 10% Pi Type 35 mA pk-pk Output Specifications Voltage Accuracy Short Circuit Protection Line Regulation Load Regulation (0% - 100%) Ripple and Noise (20Mhz bandwidth) Temperature Coefficient ± 2% Indefinite (automatic recovery) ± 0.5% ± 0.5% (3.3Vout Models: ± 1.5%) 75 mV pk-pk ± 0.02% / °C General Specifications Efficiency I/O Isolation Voltage (3 sec.) I/O Isolation Capacity I/O Isolation Resistance Switching Frequency (typical) Humidity Reliability Calculated MTBF (MIL-HDBK-217F) See Table 1000 VDC (up to 3000 VDC optional)* 60 pF, typ. 1000 M Ohm 40 kHz (Single out); 300 kHz (Dual out) 95% rel H > 3.072 Mhrs Physical Specifications Case Material Potting Material Weight Nickel Coated Copper Epoxy (UL94V-0 rated) ~ 15g, typ. Environment Specifications Operating Temperature Maximum Case Temperature Storage Temperature Cooling RoHS Conform -40 to +85°C (ambient) 100°C -40 to +125°C Free Air Convection Soldering 260°C, max. (1.5mm from case 10s.) PM5-Series – P10SG-xxxxE/Z(H30)MLF – Single and Dual Output – DIP24 - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 1/3 Selection Guide Single/Dual Output Order # SINGLE OUTPUT P10SG-053R3EMLF P10SG-0505EMLF P10SG-0509EMLF P10SG-0512EMLF P10SG-0515EMLF P10SG-0524EMLF P10SG-123R3EMLF P10SG-1205EMLF P10SG-1209EMLF P10SG-1212EMLF P10SG-1215EMLF P10SG-1224EMLF P10SG-243R3EMLF P10SG-2405EMLF P10SG-2409EMLF P10SG-2412EMLF P10SG-2415EMLF P10SG-2424EMLF DUAL OUTPUT P10SG-053R3ZMLF P10SG-0505ZMLF P10SG-0509ZMLF P10SG-0512ZMLF P10SG-0515ZMLF P10SG-0524ZMLF P10SG-123R3ZMLF P10SG-1205ZMLF P10SG-1209ZMLF P10SG-1212ZMLF P10SG-1215ZMLF P10SG-1224ZMLF P10SG-243R3ZMLF P10SG-2405ZMLF P10SG-2409ZMLF P10SG-2412ZMLF P10SG-2415ZMLF P10SG-2424ZMLF ) ) A) mA (mA ad (m ad ( ) o d L a C ) o ll L F)² D C Lo t Fu d (u (VD Full No e (V n ) a t t g e e o n n a r % g t rre y( rre lta or L Cur Vol ienc t Vo t Cu put Cu acit put put Inpu Inpu In Out Out Effic Cap 5 5 5 5 5 5 12 12 12 12 12 12 24 24 24 24 24 24 75 75 75 75 75 75 70 70 70 70 70 70 25 25 25 25 25 25 622 615 597 571 588 615 245 260 245 238 252 256 120 132 132 122 122 122 3.3 5 9 12 15 24 3.3 5 9 12 15 24 3.3 5 9 12 15 24 500 400 222 166 133 83.3 500 400 222 166 133 83.3 500 400 222 166 133 83.3 53 65 67 70 68 65 56 64 68 70 66 65 57 63 63 68 68 68 330 330 330 330 330 330 330 330 330 330 330 330 330 330 330 330 330 330 5 5 5 5 5 5 12 12 12 12 12 12 24 24 24 24 24 24 30 30 40 40 40 50 20 20 20 20 35 35 15 15 15 15 20 20 638 588 571 571 571 579 250 228 222 213 216 219 121 114 111 104 108 111 ± 3.3 ±5 ±9 ± 12 ± 15 24 ± 3.3 ±5 ±9 ± 12 ± 15 ± 24 ± 3.3 ±5 ±9 ± 12 ± 15 ± 24 ± 300 ± 200 ± 111 ± 83 ± 67 42 ± 300 ± 200 ± 111 ± 83 ± 67 ± 42 ± 300 ± 200 ± 111 ± 83 ± 67 ± 42 62 68 70 70 70 69 66 73 75 78 77 76 68 73 75 80 77 75 ± 1000 ± 1000 ± 470 ± 470 ± 470 220 ± 1000 ± 1000 ± 470 ± 470 ± 470 ± 220 ± 1000 ± 1000 ± 470 ± 470 ± 470 ± 220 If you need other specifications, please enquire. * For optional 3kV DC I/O Isolation, please add “H30” before MLF! Example: P10SG-1205ZH30MLF for 3kV PM5-Series – P10SG-xxxxE/Z(H30)MLF – Single and Dual Output – DIP24 - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 2/3 Package / Pinning / Derating 27.94 (1.10) 15.24 (0.60) 1 All dimensions are typical in millimeters (inches). - Pin diameter: 0.5 +/-0.05 (0.02 +/-0.002) - Pin pitch tolerance: +/-0.35 (+/-0.014) - Case tolerance +/-0.5 (+/-0.02) Standard Drawing For exact pinning please see connection table! Specification may change without notice. 12 Bottom View 24 13 2.54 (0.10) DIP24 – METAL CASE 2.00 (0.08) 10.20 (0.40) 20.30 (0.80) PEAK Modelcode Datecode 31.80 (1.25) 3.05 (0.12) # 1 2 3 10 11 12 13 14 15 22 23 24 SINGLE +Vin N.C. N.C. - Vout +Vout - Vin - Vin +Vout - Vout N.C. N.C. +Vin PIN CONNECTIONS SINGLE 3KV DUAL +Vin +Vin - Vout +Vin Common Omitted Common Omitted +Vout Omitted - Vin - Vout - Vin +Vout +Vout Omitted Common Omitted Common Omitted - Vout - Vin +Vin - Vin DUAL 3KV +Vin +Vin Omitted Common Common Omitted - Vout Omitted + Vout Omitted - Vin - Vin App Notes: ¹ = Measured Input reflected ripple current with a simulated source inductance of 12uH. ² = Tested by minimal Vin and constant resistive load. PM5-Series – P10SG-xxxxE/Z(H30)MLF – Single and Dual Output – DIP24 - Metal Case Specification can change without a notice – We accept no liability for any inaccuracy or printing errors. Page 3/3