DC-DC CONVERTERS PBNH Series 80W MOBILE CONVERTERS FEATURES • • • • • • Easy to mount and terminate Input/output fully isolated Short circuit protected Thermal protected Low noise High surge currents SPECIFICATIONS MECHANICAL INPUT Input voltage 12VDC (10–16) 24VDC (18–32) 36VDC (30–48) 48VDC (40–64) 110VDC (72–140) Dimensions Input and output have 6.3mm push on spade terminals 135x119x46mm Weight 0.6kg STANDARDS AND APPROVALS OUTPUT See selection table C-Tick AS/NZS CISPR11 Group 1, Class A Output current See selection table EMC standards EN50082-1 Output voltage adjustment 10% internal pot EMI standards EN50081-1 Output power Typically 80W continuous, 110 intermittent Noise Below CISPR limit SELECTION TABLE Ripple & Noise Typically 10mV rms at nominal load and input voltage MODEL NUMBER Load regulation 5% at nominal input voltage PBNH-1212L 12V 13.2V 3.0A 4.0A Line regulation 5% over input range PBNH-1224L 12V 24V 1.7A 2.2A Output voltage OPERATING INPUT DC OUTPUT OUT I (PK) PBNH-1248L 12V 48V 0.7A 0.8A Input and output are electrically isolated from chassis and input is isolated from output Isolation voltage – 1000VDC PBNH-2412L 24V 13.2V 6.0A 10.0A PBNH-2424L 24V 24V 3.0A 4.0A Switching frequency Approx. 50kHz PBNH-2436L 24V 36V 2.5A 3.0A Efficiency Protection Typically 80%-85% Reverse input polarity Transorb diode at input Overvoltage protection Short circuit protection Thermal protection Unit will switch off automatically at input over- or undervoltage protection PBNH-2448L 24V 48V 1.5A 2.0A PBNH-3612L 36V 13.2V 6.0A 8.0A PBNH-3624L 36V 24V 3.0A 4.0A PBNH-4812L 48V 13.2V 6.0A 8.0A PBNH-4824L 48V 24V 3.0A 4.0A Isolation ENVIRONMENTAL Operating temperature 94 Terminals -20°C to 40°C at full load derate linearly to 60°C PBNH-4848L 48V 48V 1.5A 2.0A PBNH-8012L 110V 13.2V 6.0A 8.0A PBNH-8024L 110V 24V 3.0A 4.0A DOC. NO. PBC9 REV.C 28-4-11