SF0130BA02247T

130 MHz SAW Filter
18 MHz Bandwidth
Part Number: SF0130BA02247T
DESCRIPTION
•
•
•
130 MHz SAW filter with 18 MHz bandwidth.
22 x 12 mm DIP package.
RoHS compliant.
TYPICAL PERFORMANCE
Horizontal:
Vertical from Top:
Frequency :
Relative Magnitude :
Relative magnitude :
Phase :
Group Delay :
S11 (105 to 155 MHz)
5
10
1
5
50
MHz/div
dB/div
dB/div
deg/div
ns/div
S22 (105 to 155 MHz)
Spectrum Microwave
400 Nickerson Road, Marlborough, MA 01752, USA • Phone 1-508-251-6400 • Fax 1-508-251-6401
www.SpectrumMicrowave.com
DSSF0130BA02247T Rev A 22-Feb-2010
ECN 36650 Page 1 of 3
130 MHz SAW Filter
18 MHz Bandwidth
Part Number: SF0130BA02247T
SPECIFICATION
PARAMETER
Center Frequency (Fc) 1
Insertion Loss
Lower 1dB Band Edge
Upper 1dB Band Edge
Lower 40dB Band Edge
Upper 40dB Band Edge
Passband Amplitude Variation 2
Group Delay Variation 2,3
Rejection (75 MHz to 116.5 MHz)
Rejection (143.5 MHz to 210 MHz)
Source and Load Impedance
Ambient Temperature (Tref)
Notes:
1.
2.
3.
4.
Min
139.00
116.50
45
40
-
Typ
130.00
26.5
120.30
139.60
117.30
142.70
0.4
9
50
45
50
23
Max
30.0
121.00
143.50
0.8
15
-
Units
MHz
dB
MHz
MHz
MHz
MHz
dB p-p
ns p-p
dB
dB
Ω
°C
Average of the lower and upper 3 dB band edge frequencies.
Specification applies over a 121 to 139 MHz frequency span.
A smoothing aperture of 1% of span and averaging of 16 may be applied to this measurement.
Typical change of filter frequency response with temperature is ∆f = (T-Tref)*Tc*Fc, in ppm.
MAXIMUM RATINGS
Parameter
Storage Temperature Range
Temperature Coefficient of Frequency (Tc) 4
Input Power Level
Min
Typ
Max
Units
-40
-
40
-74
0
85
10
˚C
ppm/˚C
dBm
MATCHING CIRCUIT
1
8
Input
50 Ω
Single-ended
Output
50 Ω
Single-ended
14
Note:
7
External matching components are not required.
Spectrum Microwave
400 Nickerson Road, Marlborough, MA 01752, USA • Phone 1-508-251-6400 • Fax 1-508-251-6401
www.SpectrumMicrowave.com
DSSF0130BA02247T Rev A 22-Feb-2010
ECN 36650 Page 2 of 3
130 MHz SAW Filter
18 MHz Bandwidth
Part Number: SF0130BA02247T
PACKAGE OUTLINE
Units: mm
Dimensions are nominal in mm. All
tolerances are ±0.15 mm except
overall length and width unless
otherwise indicated.
Pin Configuration:
Input:
Input Return:
Output:
Output Return:
Ground:
1
14
8
7
2, 9
ISO 9001
Registered
All specifications are believed to be accurate and reliable. However, Spectrum Microwave reserves the right to make changes without notice.
© 2010 All rights reserved.
Spectrum Microwave
400 Nickerson Road, Marlborough, MA 01752, USA • Phone 1-508-251-6400 • Fax 1-508-251-6401
www.SpectrumMicrowave.com
DSSF0130BA02247T Rev A 22-Feb-2010
ECN 36650 Page 3 of 3