Toggles Series JF Rockers General Specifications Electrical Capacity (Resistive Load) Pushbuttons Other Ratings Programmable Illuminated PB Keylocks Materials & Finishes Rotaries Actuator: Case: Seal: Base: Movable Contact: Stationary Contacts: Terminals: Environmental Data J 50mA @ 24V DC Contact Resistance: Insulation Resistance: Dielectric Strength: Mechanical Life: Electrical Life: Nominal Operating Force: Total Travel: Slides Tactiles Tilt Touch Low/Logic Level: Operating Temperature Range: Humidity: Vibration: Shock: PCB Processing 50 milliohms maximum 500 megohms minimum @ 250V DC 250V AC minimum for 1 minute minimum 500,000 operations minimum 500,000 operations minimum 1.96N for sculptured actuator 2.0N for piano actuator 3.0N for square & round flush actuators Flush Actuators .016” (0.4mm) Sculptured & Piano Actuators .031” (0.8mm) Polyamide Glass fiber reinforced polyamide Nitrile butadiene rubber Glass fiber reinforced polyester Phosphor bronze with silver plating Brass with silver plating Brass with silver plating –25°C through +85°C (–13°F through +185°F) 90 ~ 95% humidity for 96 hours @ 40°C (104°F) 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours 50G (490m/s2) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) Soldering: Cleaning: Wave Soldering Recommended. See Profile A in Supplement section. Manual Soldering: See Profile A in Supplement section. Automated cleaning. See Cleaning specifications in Supplement section. S tandards & Certifications The JF Series tactiles have not been tested for UL recognition or CSA certification. These switches are designed for use in a low-voltage, low-current, logic-level circuit. When used as intended in a logic-level circuit, the results do not produce hazardous energy. Supplement Accessories Indicators Ultra-Thin Process Sealed Tactiles J34 www.nkk.com Series JF Toggles Ultra-Thin Process Sealed Tactiles Rockers Distinctive Characteristics Pushbuttons Extremely low profile of 5mm from PCB to top of switch. Programmable Illuminated PB Rubber seal construction prevents contact contamination and allows automated soldering and cleaning. Minimal operating force and short stroke permit light touch operation. Dome contact gives crisp tactile and audible feedback to positively indicate circuit transfer and assures high reliability and long life. Keylocks Wide choice of body shapes and colors. Actual Size Rotaries Crimped terminals provide a spring type action to ensure secure mounting and prevent dislodging during wave soldering. Terminal spacing conforms to standard .100” (2.54mm) PCB grid. Common Bus Matrix X-Y Matrix These single pole, single throw switches can be used in a keyboard matrix and, using strapped terminals, achieve a common bus electrical configuration on a single-sided PC board. 7 8 9 3 11 8 A B 0 1 2 12 6 2 7 8 9 6 A B 0 7 = ON 5 7 Red = PCB Trace 4 Tilt 3 Black = Switch Circuit www.nkk.com Touch Indicators 6 4 5 4 P C Te r m i na t i ons 1 2 3 4 5 6 7 1 2 3 4 5 6 7 8 9 0 A B = ON Accessories 10 1 Supplement 6 1 2 3 4 5 6 7 8 9 0 A B 3 2 1 P C Te r m i n a t i o n s 1 2 3 4 5 6 7 8 9 10 11 12 13 Keys (Switches) 5 13 Keys (Switches) 3 2 4 These single pole, single throw switches can be arranged on a single-sided PC board matrix with strapped terminals to achieve an X-Y type electrical interconnection. 9 5 1 J Tactiles Slides Space saving body dimensions provide for compact, side-by-side mounting on a standard grid. J35 Series JF Toggles Ultra-Thin Process Sealed Tactiles Rockers TYPICAL SWITCH ORDERING EXAMPLE 15 S P 2 C Pushbuttons JF Terminals Programmable Illuminated PB Pole & Circuit 15 SPST OFF P (ON) Actuator Colors Straight PC ( ) = Momentary Actuator Types C Round (with round actuator only) 1 Square 2 Round S Square 3 Sculptured 4 Piano Red D Orange F Green G Blue H Gray Rotaries Keylocks Housing Shapes C JF15SP2C J Square Housing with Round Red Actuator SPST OFF-(ON) Circuit Straight PC Terminals Touch Tilt Tactiles Slides DESCRIPTION FOR TYPICAL ORDERING EXAMPLE Indicators POLE & CIRCUIT Actuator Position ( ) = Momentary Accessories Normal Pole Down Model JF15 SPST OFF (ON) Supplement SP Switch Throw & Schematic J36 www.nkk.com 1 3 2 4 Note: Terminal numbers are shown on the switch. Series JF Toggles Ultra-Thin Process Sealed Tactiles HOUSING SHAPES & ACTUATOR TYPES S C Round Actuator 2 D Red F Orange Sculptured Actuator 3 G Blue Green 4 Piano Actuator H Pushbuttons Actuator Colors Available: Square Actuator Programmable Illuminated PB 1 Gray Keylocks Round Actuator Rockers Square Housing Housing is Black Versatile panel arrangements can be made to fit individual design needs. Additional details in Typical Switch Dimensions 3 Slides Straight PC 1 (17.78) .700 (12.7) .500 4 2 (10.16) .400 (5.08) .200 (1.0) Dia Typ .039 (3.6) .142 (17.78) Typ .700 TYPICAL SWITCH DIMENSIONS Round Actuator 3 4 Indicators 1 (16.4) Dia .646 2 (3.0) .118 (0.3) .012 (8.68) .342 (0.3) Typ .012 (3.6) .142 (10.16) .400 www.nkk.com Accessories (12.7) .500 (0.8) Typ .031 Supplement (14.0) Dia .551 (17.7) Dia .697 J Tilt P Rotaries TERMINALS & PANEL DESIGN Tactiles 2 Round Housing Touch C JF15CP2C J37 Toggles Series JF Ultra-Thin Process Sealed Tactiles TYPICAL SWITCH DIMENSIONS Rockers Square Actuator 1 3 (3.0) .118 2 Pushbuttons 4 (12.7) .500 (16.4) Sq .646 (0.3) .012 Programmable Illuminated PB (14.0) Sq .551 (17.7) Sq .697 (0.3) Typ .012 (3.6) .142 (8.68) .342 (10.16) .400 JF15SP1C Round Actuator Rotaries Slides 3 4 (12.7) .500 (0.3) .012 (14.0) Dia .551 (17.7) Sq .697 1 (16.4) Sq .646 2 Keylocks (3.0) .118 (8.68) .342 (0.3) Typ .012 (3.6) .142 (10.16) .400 Sculptured Actuator 1 3 (3.0) .118 4 (12.7) .500 (16.4) Sq .646 2 Tactiles J (0.3) .012 Tilt (14.0) Sq .551 (17.7) Sq .697 (1.7) .067 (0.3) Typ .012 (3.6) .142 (8.68) .342 (10.16) .400 (0.8) Typ .031 JF15SP3C Piano Actuator 1 3 (3.0) .118 Indicators (12.7) .500 2 Accessories (16.4) Sq .646 4 Touch (0.8) Typ .031 JF15SP2C Supplement (0.8) Typ .031 (0.3) .012 (14.0) Sq .551 (17.7) Sq .697 J38 (1.9) .075 JF15SP4C www.nkk.com (8.68) .342 (0.3) Typ .012 (3.6) .142 (10.16) .400 (0.8) Typ .031 Series JF Toggles Ultra-Thin Process Sealed Tactiles LEGENDS Rockers NKK Switches can provide custom legends for caps. Contact factory for more information. FA (12.48) Sq .491 (14.0) Sq .551 (0.76) Typ .030 Keylocks (0.76) Typ .030 T R A ST N RU Rotaries (12.48) Dia .491 (14.0) Dia .551 (0.76) Typ .030 Programmable Illuminated PB N N O (8.03) .316 Slides (1.52) Typ .060 (4.98) .196 (0.76) Typ .030 (12.48) Sq .491 (14.0) Sq .551 J (0.76) Typ .030 Tilt (9.6) .378 (11.13) .438 Tactiles P U (12.48) Dia .491 (14.0) Dia .551 Pushbuttons Shaded Areas are Printable Areas Supplement Accessories Indicators Touch Recommended Print Methods: Screen Print or Pad Print. Epoxy based ink is recommended. www.nkk.com J39