THICK FILM CONVEX CHIP ARRAYS SMN SERIES Resistor Arrays ZMN SERIES Jumper Arrays RCD’s Series SMN resistor and ZMN jumper chip arrays not only enable significant pcb space savings, but a sizeable cost savings over the use of individual components. The savings in assembly cost, by placing a single chip instead of multiple chips, more than pays for the cost of these components. SMN/ZMN feature convex terminations, concave avaliable (see CN Series). 4 PIN: SMN0404, SMN0606 10 PIN: SMN2010, SMNN1206 (SMNN1206 avial. in Config. D only) ↓ ↑ W ↓ → P ← L W Config. A ↓ ↑ SMN0404 SMN0606 SMN0804 SMN1206 SMNN1206 SMN1506 SMN2010 SMN2010 SMN2012 SMN2012 A A A A D A A B A B** 1 Rated Pow er* 62mW 62mW 62mW 62mW 31mW 62mW*** 100mW 55mW 125mW 62mW Config. A Working Voltage 25V 50V 25V 50V 25V 25V 50V 50V 50V 50V 25 0 25 50 → P← Config. B TC (ppm/°C) 250ppm 200ppm 250ppm 200ppm 200ppm 200ppm 200ppm 200ppm 200ppm 200ppm L Res. Range Res. Range Res. Range 0.5% Tol 1% Tol 2 & 5% Tol ** ** 10Ω - 1M ** ** 1Ω - 10M ** ** 10Ω - 1M 22Ω-470K 1Ω - 10M 1Ω - 10M ** ** 10Ω - 1M ** ** 10Ω - 1M ** ** 10Ω - 1M ** ** 10Ω - 1M ** 22Ω - 1M 10Ω - 1M ** ** 10Ω - 1M SUGGESTED LAYOUT 123 12 PAD 123 123 123 123 123 123 123 ↑ D ↓ 123 123 ↑ 123 C 123 123 ↓ 75 100 125 150 175 200 70 AMBIENT TEMPERATURE (°C) 12 12 12 12 12 12 12 12 12 123 123 123 123 123 123 123 123 123 A← → → TYPICAL PERFORMANCE CHARACTERISTICS Operating Temp. Range -55°C to +150°C Short time Overload (2.5X rated W, 5 sec) ±2%+0.1Ω max. Resistance to Solder Heat (260°C, 10 sec) ±1%+0.1Ω max. Moisture Res. (90-95% RH, 40°C,100 hrs) ±3%+0.1Ω max. High Temp. Exposure (125°C, 100 hrs) ±1%+0.1Ω max. Load Life (1000 hrs at rated W) ±3%+0.1Ω max. Insulation Resistance 10,000 Megohm Dielectric Withstanding Voltage ↓ --- W ↓ L ±.01 [.25] .039 [1] .063 [1.6] .079 [2] .126 [3.2] .126 [3.2] .154 [3.9] .200 [5.08] .200 [5.08] .200 [5.08] .200 [5.08] 1 Config. A ↑ Config. B 1 Config. D T --1 → H← W±.008 [.2] .039 [1] .063 [1.6] .039 [1] .063 [1.6] .063 [1.6] .063 [1.6] .100 [2.54] .100 [2.54] .122 [3.10] .122 [3.10] Config. A P±.008 [.2] .025 [.65] .0315 [.8] .02 [.5] .0315 [.8] .025 [.64] .02 [.5] .040 [1.0] .040 [1.0] .050 [1.27] .050 [1.27] H±.006 [.15] .016 [.4] .022 [.55] .016 [.4] .022 [.55] .022 [.55] .018 [.45] .024 [.6] .024 [.6] .024[ .6] .024 [.6] T typ. .010 [.25] .012 [.3] .010 [.25] .010 [.25] .010 [.25] .012 [.3] .010 [.25] .010 [.25] .012 [.30] .012 [.30] ** Consult factory for availability *** SMN1506 package power rating is .25W ----------- % OF 70°C RATING 50 1 1 16 PIN: SMN1506 L DERATING 75 --- ↑ * Rated power is per resistor element at 70°C 100 T ↑ →H← T --- Config ↓ → P ← L 1 → H← RCD Type --- ↑ 8 PIN: SMN0804, SMN1206, SMN2012 --- N LIES Term.W is RoHS compliant & 260°C compatible RoHS Internationally popular convex termination pads Industry’s widest selection and lowest cost! 1Ω to 10MΩ, 0.5% to 5%, 8 sizes, 3 circuit schematics 2 to 9 resistors per array reduces mounting costs ZMN Series zero ohm jumpers are 1Amp, 50mΩ max Scalloped edge design available → P ← ↓ T --↑ ↑ W --↓ ← L→ → H← RESITO R S C A PACITORS CO LS I D E L AY 400V 123 123 123 123 123 123 123 123 123 B← 123 123 123 123 123 123 123 123 123 RCD Type SMN0404 (4-pin) SMN0606 (4-pin) SMN0804 (8-pin) SMN1206 (8-pin) SMNN1206 (10-pin) SMN1506 (16-pin) SMN2010 (10-pin) S MN2012 (8-pin) P/N DESIGNATION: A .014 [.36] .016 [.4] .012 [.3] .018 [.45] .014 [.36] .012 [.3] .022 [.55] .032 [.82] B C D .011 [.28] .020 [.5] .020 [.5] .016 [.4] .032 [.8] .036 [.9] .008 [.2] .020 [.5] .020 [.5] .014 [.36] .032 [.8] .036 [.9] .011 [.28] .032 [.8] .036 [.9] .008 [.2] .032 [.8] .039 [1] .018 [.45] .040 [1] .060[1.5] .018 [.45] .045 [1.1] .080 [2] SMN 2010 A - 102 - J T W Type (SMN, SMNN or ZMN) Chip Size Circuit Configuration: A, B, D Resis.Code 1%: 3 signif. figures & multiplier, e.g. 1R00=1Ω, 10R0=10Ω, 1000=100Ω, 1001=1KΩ, etc. Resis.Code 2%-5%: 2 signif. figures & multiplier, e.g. 1R0=1Ω, 100=10Ω, 101=100Ω, 102=1KΩ, etc. Leave blank on ZMN zero-ohm jumper arrays (.05Ω max) Tolerance Code: J=5%(std), G=2%, F=1%, D=0.5% Leave blank on ZMN zero-ohm jumper arrays Packaging: B = Bulk, T = Tape & Reel Termination: W= Lead-free (standard), Q= Tin/Lead (leave blank if either is acceptable) RCD Components Inc, 520 E.Industrial Park Dr, Manchester, NH, USA 03109 rcdcomponents.com Tel: 603-669-0054 Fax: 603-669-5455 Email:[email protected] FA075A Sale of this product is in accordance with GF-061. Specifications subject to change without notice. 32