ELECTRONIC POWER CONDITIONER for CW Millimeter Wave EIKs MODEL SERIES VPW2827 FEATURES CPI EPC, model VPW2827, is designed and tested to operate a wide variety of CPI CW Extended Interaction Klystrons and Oscillators. Beam Voltage Anode Voltage Collector Voltage Our EPC architecture provides optimum protection for the EIK and worry free operation for the user. EIK operating parameters are programmed into onboard memory then password protected. CPI Canada will integrate your EIK to the EPC. This service and support ensures long life and reliable operation in an easy to use package. Heater voltage Collector current Body Current Anode Current Heater current Total Power output External Interlock Prime Power Dimensions Remote EIK mounting box Fault Protection Cooling -4.0 to –12.0 kV +1.0 to +6.0 kV Virtual ground / 70% of beam voltage -5.0 to –7.0 V 0 to 130 mA 0 to 20 mA -0.1 to +1.0 mA 0 to 3.0 amps 1.2 kW Inhibits High Voltage 110/240 Vac, 50/60 Hz 1Ø 8.72x19x24.5 inches (Handles 1.5 inches) Attached by 3 meter HV lead. Size 7.7x9.7x9.7 inches Fully protected for operating designated CPI EIKs Forced air using integral blower. The values listed represent typical performance from testing. Formal controlled specifications, with minimum and maximum values, for use in equipment design, may be obtained from CPI. For more information please contact your local CPI sales office or CPI Canada, they may be found on our web site at: www.cpii.com EPC and remote mounting box shown with EIK (EIK is not included with the EPC) For information on this and other CPI products please contact CPI Canada, a field office or local representative they may be found on our web site at: www.cpii.com CPI Canada 45 River Drive, Georgetown, Ontario, Canada. L7G2J4 Telephone +1-905-877-0161 e-mail: [email protected]