TABLE 1: ELECTRICAL SPECIFICATIONS AT 25 OC PARAMETER MIN. INDUCTANCE (4-2) VOLTAGE = 0.100Vrms FREQUENCY = 10 KHZ 2300 LEAKAGE INDUCTANCE (4-2) VOLTAGE = 0.100Vrms, TIE 9-7 FREQUENCY = 100 KHZ FIGURE 1: SCHEMATIC DIAGRAM SPEC LIMITS TYP. MAX. 2500 WHITE DOT DENOTES PIN #1 UNITS 2 µHY 2700 PRIMARY#1A 3 ------- ------- 40 µHY PRIMARY#1B 9 SECONDARY 7 4 TURN RATIO'S: SEC (9-7) : PRI (4-2) -------- 1 : 4.88 -------- + 2% HIPOT: PRI TO SEC 1850 -------- Vrms -------- NOTE1: A) ALL MATERIALS TO MEET UL, CSA & IEC SAFETY REQUIRMENTS B) ALL MATERIAL RATED 130 OC OR BETTER. C) TRIPLE INSULATION ON SECONDARY. D) VARNISH FINISHED ASSEMBLY. FIGURE 2: PHYSICAL DIMENSIONS mm (INCHES) 10 P M PIN #1 WHITE DOT 9 8 7 6 TSD-1801 YYWW 1 2 3 4 5 14.00 (.550) MAX 13.2 (.520) MAX 13.0 (.512) MAX 1 2 3 4 0.6 DIA. (.024) 5 2.5 (.098) MIN 2.5 (.098) 8.5 (.335) 10.0 (.394) REV. 10/22/02 11/22/02 12/16/02 09/11/03 UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MM DIMENSIONAL TOLERANCES ARE: DECIMALS ANGLES .X + .25 +0 O 30' .XX + .15 DO NOT SCALE DRAWING DESCRIPTION OF CHANGES ORIGINAL RELEASE NEW DESIGN UPDATED RELEASE ASSIGN THE SLOT FOR PRIMARY LEADS TRANSFORMER CONTROL DRAWING PREMIER P/N: TSD-1801 REVISION: 09/11/03 DRAWN BY: PETER PHAM REF: TNY266 SCALE: NONE SHEET: 1 OF 2 BY PP PP LL PP