TABLE 1: ELECTRICAL SPECIFICATIONS AT 25 OC PARAMETER MIN. PRIMARY INDUCTANCE (9-11) VOLTAGE = 1Vrms FREQUENCY = 132 KHZ 594 SPEC LIMITS TYP. 660 FIGURE 1: SCHEMATIC DIAGRAM MAX. UNITS 726 HY WHITE DOT DENOTES PIN#1 8 SEC #4 TURN RATIO'S: BIAS : PRI SEC #1 : PRI SEC #2 : PRI SEC #3 : PRI SEC #4 : PRI 7 ------------------------------------ 1 : 9.55 1 : 14.33 1 : 14.33 1 : 7.16 1 : 7.16 ------------------------------------ + 3% + 3% + 3% + 3% + 3% LEAKAGE INDUCTANCE (9-11) V = 0.250Vrms, F= 100Khz TIE SEC'S -------- 24 -------- HY PRI - SEC CAPACITANCE (9-7) -------- -------- 10 pF HIPOT: PRIMARY TO SEC'S PRIMARY TO BIAS SEC#1, #2 & #3, #4 3000 1000 500 ---------------------- ---------------------- VRMS VRMS VRMS 9 6 PRIMARY SEC #3 11 5 4 14 SEC #2 BIAS 3 16 2 FIGURE 2: PHYSICAL DIMENSIONS INCHES (mm) 16 WHITE DOT PIN#1 I.D. 1 9 1 8 28.0 (1.102) MAX P M 3.0 (.120) typ SEC #1 TSD-2284 YYWW 2.54 (.100) 29.0 (1.142) MAX CORE TAPED 16.5 (.65) MAX 0.6. (.023) 15.24 (.600) 20.32 (.800) NOTE1: MINIMUM INSULATION SYSTEM REQUIREMENTS: A)ALL MATERIALS MEET "UL", "CSA" & "IEC" REQUIREMENTS B)ALL MATERIAL RATED 130 OC OR BETTER. C)VARNISH FINISHED ASSEMBLY. RoHS UNLESS OTHERW ISE SPECIFIED DIMENSIONS ARE IN INCHES DIMENSIONAL TOLERANCES ARE: DECIMALS ANGLES .XX + .02 +5O .XXX + .001 DO NOT SCALE DRAWING REV. DESCRIPTION OF CHANGES BY 10/25/06 11/09/06 ORIGINAL RELEASE UPDATE DRAWING, NEW TURNS PP PP 03/05/07 12/18/07 RENUMBER PINS PER CUSTOMER Rev e, changed secondary3 & 4 to 11 turns LL pp TRANSFOMER CONTROL DRAWING PREMIER P/N: TSD-2284 REVISION: 11/18/07 ENGR: PETER PHAM REF: TOP 234 SCALE: NONE SHEET: 1 OF 2