AN-OP3 APPLICATION NOTE 397 Route 281 Tully, New York 13159 Phone: 315 696-6676 Fax: 315 696 9923 Email: [email protected] www.acipower.com 01/28/14 DRIVING OPTREX PANELS WITH ACI I-DRIVE 5 LED DRIVERS 1. Identify the Optrex Panel P/N to be driven, from Table 1 below. 2. Use the ACI I-Drive 5 Driver specified in Table 1. 3. Connect the LED Driver to the Display per the connection diagram specified in Table 1. Verify if an output cable assembly is required, to connect the driver to the display, per Table 1. 4. Use Input Cable Assembly P/N 27-R0061, to interface with CON1 of LED Driver. LED Driver Specifications Optrex Panel P/N Size # of Channels Display Specifications Vf (V) Typ. (Max) 15.0 XGA (1024x768) T-55534D150J-LW-A-ABN T-55519D150J-LW-A-ABN 15.0” 15.0” 2x4 2x5 24 (33.2) 24 (33.4) 17.5 WXGA (1280x768) T-55621D175J-LW-A-AAN 17.5” 1x4 27 (37.3) ACI I-DRIVE 5 LED Driver P/N Output Cable Assembly (to connect driver to display) Connection Diagram 125 130 (1) ACI-E096250-1884 (2) ACI-E170130-1971 (2) ACI-E170130-1984* (1) 27-R0062 (2) 27-R0088 Fig. 1, Pg 2 Fig. 2, Pg 2 120 (1) ACI-E170130-1994 (1) 27-R0064 Fig. 3, Pg3 Current per Channel (mA) Typ. * Driver is configured for use with Digital View LCD Controller TABLE 1. – Driving Optrex Panels Page 1 of 3 AN-OP3 APPLICATION NOTE 397 Route 281 Tully, New York 13159 Phone: 315 696-6676 Fax: 315 696 9923 Email: [email protected] www.acipower.com 01/28/14 DRIVING OPTREX PANELS WITH ACI I-DRIVE 5 LED DRIVERS Output Cable Assembly 27-R0088 CON1 CON2 I-Drive 5 LED Driver 5 4 3 2 1 5 4 3 2 1 1 2 3 4 5 6 7 8 9 10 Optrex Display 1 2 3 4 5 6 7 8 9 10 Output Cable Assembly 27-R0088 CON1 CON2 I-Drive 5 LED Driver 5 4 3 2 1 5 4 3 2 1 1 2 3 4 5 6 7 8 9 10 1 2 3 4 5 6 7 8 9 10 FIGURE 2. Connection Diagram Page 2 of 3 AN-OP3 397 Route 281 Tully, New York 13159 Phone: 315 696-6676 Fax: 315 696 9923 Email: [email protected] www.acipower.com APPLICATION NOTE 01/28/14 DRIVING OPTREX PANELS WITH ACI I-DRIVE 5 LED DRIVERS Page 3 of 3