C3D16065D VRRM = Silicon Carbide Schottky Diode IF (TC=135˚C) = 22 A** Z-Rec Rectifier ® Qc Features • • • • • • • = 42 nC** Package 650-Volt Schottky Rectifier Zero Reverse Recovery Current Zero Forward Recovery Voltage High-Frequency Operation Temperature-Independent Switching Behavior Extremely Fast Switching Positive Temperature Coefficient on VF TO-247-3 Benefits • • • • • 650 V Replace Bipolar with Unipolar Rectifiers Essentially No Switching Losses Higher Efficiency Reduction of Heat Sink Requirements Parallel Devices Without Thermal Runaway Applications • • • • • Switch Mode Power Supplies Power Factor Correction Solar Inverters Motor Drives Electric Vehicle Charger Part Number Package Marking C3D16065D TO-247-3 C3D16065 Maximum Ratings (TC=25°C unless otherwise specified) Symbol Parameter Unit Test Conditions VRRM Repetitive Peak Reverse Voltage 650 V VRSM Surge Peak Reverse Voltage 650 V VDC DC Blocking Voltage 650 V Continuous Forward Current (Per Leg/Device) 23/46 11/22 8/16 A TC=25˚C TC=135˚C TC=150˚C IFRM Repetitive Peak Forward Surge Current (Per Leg/Device) 57/114 36/72 A TC=25˚C, tP = 10 ms, Half Sine Wave, D=0.3 TC=110˚C, tP=10 ms, Half Sine Wave, D=0.3 IFSM Non-Repetitive Peak Forward Surge Current (Per Leg/Device) 80/160 60/120 A TC=25˚C, tp = 10 mS, Half Sine Wave, D=0.3 TC=110˚C, tP=10 ms, Half Sine Wave, D=0.3 IFSM Non-Repetitive Peak Forward Surge Current (Per Leg/Device) 220/440 A TC=25˚C, tP = 10 µs, Pulse Ptot Power Dissipation (Per Leg) 100 43 W TC=25˚C TC=110˚C -55 to +175 ˚C 1 8.8 Nm lbf-in IF TJ , Tstg Operating Junction and Storage Temperature TO-247 Mounting Torque * 1 Value Per Leg, ** Per Device C3D16065D Rev. A M3 Screw 6-32 Screw Note See Fig. 3 Electrical Characteristics (Per Leg) Symbol Parameter Typ. Max. Unit Test Conditions VF Forward Voltage 1.6 1.9 1.8 2.4 V IF = 8 A TJ=25°C IF = 8 A TJ=175°C IR Reverse Current 12 24 60 220 μA VR = 650 V TJ=25°C VR = 650 V TJ=175°C QC Total Capacitive Charge 21 nC VR = 650 V, IF = 8A di/dt = 500 A/μs TJ = 25°C C Total Capacitance 441 39 33 pF VR = 0 V, TJ = 25°C, f = 1 MHz VR = 200 V, TJ = 25˚C, f = 1 MHz VR = 400 V, TJ = 25˚C, f = 1 MHz Note Note: 1. This is a majority carrier diode, so there is no reverse recovery charge. Thermal Characteristics Symbol RθJC * Parameter Thermal Resistance from Junction to Case Per Leg, ** Typ. Unit 1.5 * 0.75 ** °C/W Per Device Typical Performance (Per Leg) Forward Characteristics 1010 TJ = 125°C TJ = 175°C 8080 IR Reverse Current (μA) IF Forward Current (A) 77 66 55 44 33 7070 6060 5050 4040 3030 22 2020 11 1010 00 0.0 0.5 1.0 1.5 2.0 2.5 0.0 0.5 1.0 1.5 2.0 2.5 VF ForwardVoltage Voltage (V)(V) VF Forward Figure 1. Forward Characteristics 2 9090 TJ = 75°C IF Forward Current (A) 88 100 100 TJ = 25°C IR Reverse Current (uA) 99 Reverse Characteristics C3D16065D Rev. A 00 TJ = 25°C TJ = 75°C TJ = 125°C TJ = 175°C 0 100 200 300 400 500 600 700 800 900 0 100 200 300 400 500 600 700 800 900 1000 1000 VR Reverse V ReverseVoltage Voltage (V) (V) R Figure 2. Reverse Characteristics Typical Performance (Per Leg) Capacitance vs. Reverse Voltage C3D08060 Current Derating 60 60 450 350 20% 30% 50% 70% DC 40 40 30 30 Duty Duty Duty Duty C Capacitance (pF) Current Forward IF(PEAK) Peak Forward Current (A) (A) IF(PEAK) Peak 400 50 50 20 20 300 250 200 150 100 10 10 50 0 0 0 25 25 1 1 50 75 100 125 150 175 50 75 100 125 150 175 Tc Case Temperature (°°C) (°C) TC Case Temperature 10 10 VR Figure 3. Current Derating 100 100 1000 1000 VR ReverseVoltage Voltage (V) Reverse (V) Figure 4. Capacitance vs. Reverse Voltage 1.0E+01 Zth (°C/W) 1.0E+00 1.0E-01 1.0E-02 1.0E-03 1.E-07 1.E-06 1.E-05 1.E-04 1.E-03 Tim e (s) Figure 5. Transient Thermal Impedance 3 C3D16065D Rev. A 1.E-02 1.E-01 1.E+00 Typical Performance (Per Leg) 110.0 110 100 100.0 Power Dissipation (W) (W) Dissipation(W) PowerDissipation Power 90 90.0 80.0 80 70.0 70 60 60.0 50 50.0 40.0 40 30 30.0 20 20.0 10.0 10 0 0.0 25 50 75 100 125 150 175 25 50 75 100 125 150 175 Tc Case Temperature (°C) TTCCCase Case Temperature Temperature ((°°CC) ) Figure 6. Power Derating Diode Model (Per Leg) Diode Model CSD10060 Vf Vf T T==VTV+T+If*R If*RT T V -3 -4) 0.93+(T * -9.3*10 VTT==0.92 + (Tj * J-1.35*10 ) -4 -3 R = 0.058+(T * 5.7*10 T J RT= 0.052 + (Tj * 0.29*10 ) ) Note: Tj = Diode Junction Temperature In Degrees Celsius, valid from 25°C to 175°C VT 4 C3D16065D Rev. A RT Package Dimensions POS PackageTO-247-3 X Z W Inches Min Y AA CC Min Max 16.130 A .605 .635 15.367 B .800 .831 20.320 21.10 C .780 .800 19.810 20.320 D .095 .133 2.413 3.380 E .046 .052 1.168 1.321 F .060 .095 1.524 2.410 G BB Millimeters Max .215TYP 5.460TYP H .175 .205 4.450 5.210 J .075 .085 1.910 2.160 K 6˚ 21˚ 6˚ 21˚ L 4˚ 6˚ 4˚ 6˚ M 2˚ 4˚ 2˚ 4˚ N 2˚ 4˚ 2˚ 4˚ P .090 .100 2.286 2.540 Q .020 .030 .508 .762 R 9˚ 11˚ 9˚ 11˚ S 9˚ 11˚ 9˚ 11˚ T 2˚ 8˚ 2˚ 8˚ U 2˚ 8˚ 2˚ 8˚ V .137 .144 3.487 3.658 W .210 .248 5.334 6.300 X .502 .557 12.751 14.150 Y .637 .695 16.180 17.653 Z .038 .052 0.964 1.321 AA .110 .140 2.794 3.556 BB .030 .046 0.766 1.168 CC .161 .176 4.100 4.472 Recommended Solder Pad Layout Part Number Package Marking C3D16065D TO-247-3 C3D16065 TO-247-3 Note: Recommended soldering profiles can be found in the applications note here: http://www.cree.com/~/media/Files/Cree/Power/Application%20Notes/CPWRAN04A.pdf 5 C3D16065D Rev. A Notes • RoHS Compliance The levels of RoHS restricted materials in this product are below the maximum concentration values (also referred to as the threshold limits) permitted for such substances, or are used in an exempted application, in accordance with EU Directive 2011/65/EC (RoHS2), as implemented January 2, 2013. RoHS Declarations for this product can be obtained from your Cree representative or from the Product Documentation sections of www.cree.com. • REACh Compliance REACh substances of high concern (SVHCs) information is available for this product. Since the European Chemical Agency (ECHA) has published notice of their intent to frequently revise the SVHC listing for the foreseeable future,please contact a Cree representative to insure you get the most up-to-date REACh SVHC Declaration. REACh banned substance information (REACh Article 67) is also available upon request. • This product has not been designed or tested for use in, and is not intended for use in, applications implanted into the human body nor in applications in which failure of the product could lead to death, personal injury or property damage, including but not limited to equipment used in the operation of nuclear facilities, life-support machines, cardiac defibrillators or similar emergency medical equipment, aircraft navigation or communication or control systems, or air traffic control systems. Copyright © 2014 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree, the Cree logo, and Zero Recovery are registered trademarks of Cree, Inc. 6 C3D16065D Rev. A Cree, Inc. 4600 Silicon Drive Durham, NC 27703 USA Tel: +1.919.313.5300 Fax: +1.919.313.5451 www.cree.com/power