2015-2장 2015.1.20 03:35 PM 페이지42 태산아이인쇄그룹(국) 2261-2488 2400DPI 175LPI CONDUCTIVE POLYMER ALUMINUM ELECTROLYTIC CAPACITORS FT Chip type, Guaranteed at 125° C Series Hi-CAP ・The FT Series is very reliable, guaranteeing performance ・Suitable for use in smoothing circuits of vehicle-mounted equipment, industrial equipment, etc ・Complied to the RoHS directive Item Characteristics Operating temperature range Leakage current max. Capacitance tolerance Dissipation factor max. ESR -55 ~ +125° C Less than or equal to the value of Table1 ±20% at 120Hz, 20° C Less than or equal to the value of Table1 Less than or equal to the value of Table1 Z+125° C / Z+20° C 0.75 ~ 1.25 Z-55° C / Z+20° C 0.75 ~ 1.25 Temperature characteristics (Impedance ratio at 100kHz) Load life (after application of the rated voltage for 2000 hours at 125° C) Leakage current Capacitance change ESR tanδ Less than specified value Within ±20% of initial value Less than 200% of specified value Less than 200% of specified value Resistance to soldering heat (Refer to Page 37 for soldering recommendation) Leakage current Capacitance change tanδ Less than specified value Within ±10% of initial value Less than 130% of specified value In case of some problems for measured values, measure after applying rated voltage for 120 minutes at 125° C. Unit : mm ● DRAWING 0.3 max. C±0.2 A±0.2 E B±0.2 ※Voltage 6.3V is 6 ØD±0.5 10FT ＋ Lot No. － Negative Polarity － R L± 0.3 ● PART NUMBER SYSTEM (See Page 52) Size A±0.2 Series Code Positive 0.5 max. ＋ Plastic plateform Capacitance 6.3×5.9 ØD 6.3 L B C E 5.9 6.6 6.6 2.2 2.45 0.5~0.8 A R 8×6.9 8 6.9 8.3 8.3 3.2 2.9 0.5~0.8 8×11.9 8 11.9 8.3 8.3 3.2 2.9 0.8~1.1 10×7.9 10 7.9 10.3 10.3 4.6 3.2 0.8~1.1 10×12.6 10 12.6 10.3 10.3 4.6 3.2 0.8~1.1 Negative ● Table 1. FT(SMD type) Series Characteristics List WV μF ØD (mm) L(mm) ESR(mΩ)max. 100~300kHz 10 16 25 25 25 25 25 35 35 35 35 56 82 10 22 39 47 82 8.2 18 22 47 6.3 8 6.3 8 10 8 10 8 10 8 10 5.9 6.9 5.9 6.9 7.9 11.9 12.6 6.9 7.9 11.9 12.6 45 40 65 48 45 30 28 70 60 50 30 Ripple current Dissipation factor Leakage Current Ripple current (μA)(max.) (100kHz)(mA rms) (100kHz)(mA rms) 120Hz T×≦105° C 105° C≺T×≦125° C after 2 minutes 538 670 474 580 664 943 1202 400 550 700 1150 1700 2120 1500 1835 2100 2980 3800 1300 1800 2300 3650 112 262 50 110 195 235 410 57 126 154 329 0.12 0.12 0.10 0.10 0.10 0.12 0.12 0.10 0.10 0.12 0.12 ● FREQUENCY COEFFICIENT OF PERMISSIBLE RIPPLE CURRENT 42 Frequency 120Hz 1kHz 10kHz 100~500kHz Coefficient 0.05 0.3 0.7 1