Sensing and Control Ratiometric Linear Hall-Effect Sensor OHS3150U, OHS3151U Features: Ra ometric linear output capable of sinking and sourcing current 4.5 V to 6.0 V opera on Responds equally to posi ve and nega ve magne c fields Excellent temperature stability to operate in harsh environments Robust package capable of withstanding harsh environments Descrip on: Each ratiometric linear Hall-effect sensor contains a monolithic integrated circuit on a single chip. This circuit incorporates a quadratic Hall sensing element, which minimizes the effects of mechanical and thermal stress on the Hall element and temperature compensating circuitry to compensate for the inherent Hall element sensitivity change over temperature current. These ratiometric linear Hall-effect sensors provide an output voltage that varies in proportion to the applied magnetic field. The voltage output will increase in response to a south pole (positive) magnetic field applied perpendicular to the package symbolization face, and will decrease in response to a north pole (negative) magnetic field. These ratiometric linear Hall-effect sensors can be used as a non-contact sensor for rotary and linear position sensing and for current sensing. Ordering Information Applica ons: Non‐contact magne c sensing Assembly line automa on Machine automa on Machine safety Door sensor Where sensing is required in dirty environments Through Hole Temp. Range VOQ Threshold OHS3150U -40°C to +125°C VOQ Change over TA = ±35 Gauss OHS3151U -40°C to +125°C VOQ Change over TA = ±50 Gauss 1 Vcc Voltage Regulator Qual Hall Element Dual to Single Converter Vcc 3 Output 2 Gnd DIMENSIONS ARE IN: [MILLIMETERS] INCHES RoHS General Note TT Electronics reserves the right to make changes in product specifica on without no ce or liability. All informa on is subject to TT Electronics’ own data and is considered accurate at me of going to print. © TT electronics plc 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www. electronics.com Issue C 06/2015 Page 1 Sensing and Control Ratiometric Linear Hall-Effect Sensor OHS3150U, OHS3151U Absolute Maximum Ra ngs Supply Voltage, VCC 6 V Storage Temperature Range, TS ‐65°C to +150° C Opera ng Temperature Range, TA ‐40°C to +125° C Lead Soldering Temperature (1/8 inch [3.2 mm] from case for 5 seconds with soldering iron) 260° C(1) Power Dissipa on, PD 100 mW Output Current, IO 5 mA Magne c Flux Density, B Unlimited Electrical Characteris cs (Over Opera ng Temperature Range at VCC = 5 V, unless otherwise noted) SYMBOL PARAMETER MIN TYP MAX UNITS TEST CONDITIONS VCC Supply Voltage 4.5 5.0 6.00 V ICC Supply Current 5.5 10.00 mA 2.25 2.5 2.75 V B = OG, TA = 25° C 2.10 2.5 2.90 V B = OG, TA = ‐40°C to +125°C VOQ Quiescent Voltage Output Vcc = 6 V, IO = 0 mA, B = OG IO Sink Current 0.5 mA IO Source Current ‐1.0 mA SYMBOL PARAMETER TA OHS3150U MIN TYP MAX Opera ng Temperature Range ‐40 ‐ 125 Sens Sensi vity @ TA = 25° C over TA 2.25 2.0 2.5 ‐ ∆Sens(∆T) Sens Change @ TA > 25° C @ TA < 25° C ‐2 ‐10 ∆VOQ(∆T) VOQ Change over TA ometric Sense ∆Sens(∆V) Ra Change UNITS OHS3151U UNITS MIN TYP MAX ° C ‐40 ‐ 125 ° C 2.75 3.0 mV/G mV/G 2.25 2.0 2.5 ‐ 2.75 3.0 mV/G mV/G ‐ ‐ 8 0 % % ‐2 ‐10 ‐ ‐ 8 0 % % ‐ ‐ ±35 G ‐ ‐ ±50 G ‐ 100 ‐ % ‐ 100 ‐ % ∆VOQ(∆V) Ra ometric VOQ Change ‐ 100 ‐ % ‐ 100 ‐ % +Lin Posi ve Lin ≥ 25 < 25 99 99 ‐ ‐ 105 110 % 99 99 ‐ ‐ 105 110 % ‐Lin Nega ve Lin ≥ 25 < 25 95 90 ‐ ‐ 101 101 % 95 90 ‐ ‐ 101 101 % Sym Output Symmetry 95 100 105 % 95 100 105 % Note: (1) Nega ve current is defined as a coming out of (sourcing) the output. (2) See characteris cs defini ons for test condi ons and calcula on formulas. General Note TT Electronics reserves the right to make changes in product specifica on without no ce or liability. All informa on is subject to TT Electronics’ own data and is considered accurate at me of going to print. © TT electronics plc 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www. electronics.com Issue C 06/2015 Page 2 Sensing and Control Ratiometric Linear Hall-Effect Sensor OHS3150U, OHS3151U Characteris cs Defini ons Quiescent voltage Output: With no magne c field present the device in the quiescent state and the voltage output is approximately equal to one‐half the supply voltage (VOQ = VCC / 2) over the opera ng voltage and temperature range. The change in quiescent voltage output over temperature gives the device’s equivalent accuracy and is specified in gauss by the calcula on. VOQ (TA) ‐ VOQ (25°C) ΔVOQ (T) = ————————‐ Sens (25°C) Sensi vity: A magne c south pole at, and perpendicular to, the device’s symbolized package face will increase the voltage output above the quiescent value. Conversely a magne c north pole will decrease the voltage output below the quiescent value. This change in voltage output with applied magne c field is sensi vity and is specified in mV/G by the calcula on. VO (+500G) ‐ VO (‐500G) Sens = ————————————— 1000 The change is sensi vity over temperature is specified in percent by the calcula on Sens (TA) ‐ Sens (25°C) ΔSens (ΔT) = ———————————‐ X 100% Sens (25°C) Ra ometry: The quiescent voltage output and sensi vity of these ra ometric linear Hall‐effect devices are propor onal to the supply voltage. The change in quiescent voltage output with supply voltage is specified in percent by the calcula on VO (VCC) ‐ VO (5V) —————————— X 100% ΔVOQ (ΔV) = VCC / 5 V This change in sensi vity with supply voltage is also specified in percent by the calcula on VOQ (VCC) / VOQ (5V) ΔSens (ΔV) = —————————— X 100% VCC / 5 V Linearity & Symmetry: The ability of the voltage output to vary in constant propor on to the applied magne c field is linearity and is specified in percent by the calcula on VO (+500G) ‐ VOQ + Linearity = —————————— X 100% 2(VO (250G) ‐VOQ) VO (‐500G) ‐ VOQ ‐ Linearity = —————————— X 100% 2(VO (‐250G) ‐VOQ) The output is also specified in percent by the calcula on VO (500G) ‐ VOQ ‐ Linearity = —————————— X 100% VOQ ‐VOQ (‐500G) General Note TT Electronics reserves the right to make changes in product specifica on without no ce or liability. All informa on is subject to TT Electronics’ own data and is considered accurate at me of going to print. © TT electronics plc 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www. electronics.com Issue C 06/2015 Page 3 Sensing and Control Ratiometric Linear Hall-Effect Sensor OHS3150U, OHS3151U Output vs Gauss 1000 800 600 Typical Gauss 400 200 0 -200 -400 -600 -800 5.0 4.5 4.0 3.5 3.0 2.5 2.0 1.5 1.0 0.5 0.0 -1000 Typical Output (Volts) Icc vs Temperature 8.0 7.0 Typical Icc (mA) 6.0 5.0 4.0 3.0 2.0 1.0 0.0 -60 -40 -20 0 20 40 60 80 100 120 140 160 Temperature (°C) General Note TT Electronics reserves the right to make changes in product specifica on without no ce or liability. All informa on is subject to TT Electronics’ own data and is considered accurate at me of going to print. © TT electronics plc 1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200 www.optekinc.com | www. electronics.com Issue C 06/2015 Page 4