MASWCC0010 GaAs SP4T Switch, Absorptive, Single Supply DC - 4.0 GHz Rev. V4 Features Operates DC - 4 GHz on Single Supply ASIC TTL / CMOS Driver Leadless 4 x 7 mm Chip Scale Plastic Package Low DC Power Consumption 50 Ohm Nominal Impedance Test Boards are Available Tape and Reel is Available Lead-Free CSP-2 Package 100% Matte Tin Plating over Copper Halogen-Free “Green” Mold Compound 260°C Reflow Compatible RoHS* Compliant Version of SW90-0003 Pin Configuration2, 3, 4 Pin No. Function Pin No. Function 1 CP2 19 GND 2 Vee 20 NC1 3 NC1 21 GND 4 C4 22 RFC 5 C3 23 GND 6 C2 24 NC1 7 C1 25 RF3 1 26 GND 9 1 NC 27 NC1 10 NC1 28 GND 11 1 29 RF4 1 8 Description M/A-COM's MASWCC0010 is a SP4T absorptive pHEMT switch with integral TTL driver. This device is in an MLP plastic surface mount package. This switch offers excellent broadband performance and repeatability from DC to 4 GHz, while maintaining low DC power dissipation. The MASWCC0010 is ideally suited for wireless infrastructure applications. Ordering Information Part Number Package MASWCC0010 Bulk Packaging MASWCC0010TR 1000 piece reel MASWCC0010-TB Sample Test Board 1. 2. 3. 4. NC NC 12 NC 30 GND 13 GND 31 NC1 14 RF1 32 Vee 15 GND 33 Vcc 16 NC1 34 NC1 17 GND 35 Vcc 18 RF2 36 CP1 NC = No Connection For single supply operation VEE is internally generated and must remain isolated from external power supplies. Generated noise is typical of switching DC-DC converters. Connections and external components shown in functional schematic are required. 0.1µF Capacitors need to be located near pins 32 & 33. The exposed pad centered on the package bottom must be connected to RF and DC ground. (For PQFN Packages) Note: Reference Application Note M513 for reel size information. * Restrictions on Hazardous Substances, European Union Directive 2002/95/EC. 1 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support MASWCC0010 GaAs SP4T Switch, Absorptive, Single Supply DC - 4.0 GHz Rev. V4 Electrical Specifications: TA = 25°C Parameter Test Conditions Frequency Units Min. Typ. Max. Insertion Loss RFC-RF1, 2, 3, 4 DC - 4.0 GHz Isolation — DC - 4.0 GHz dB — — 2.3 dB 38 — — VSWR On (RFC, RF1-RF4) Logic per Truth Table Off (RF1-RF4) Logic per Truth Table DC - 4.0 GHz Ratio — — 2.0:1 DC - 4.0 GHz Ratio — — 2.0:1 1 dB Compression — — 50 MHz 0.5 - 4.0 GHz dBm dBm — — +15 +27 — — Input IP3 Two-tone inputs up to +5 dBm 50 MHz 0.5-4.0 GHz dBm dBm — — 30 40 — — Switching Speed Ton (50% Control to 90% RF) — ns — 35 — Toff (50% Control to 10% RF) — ns — 20 — Trise (10% to 90% RF) — ns — 12 — Tfall (90% to 10% RF) — ns — 2 — Vcc — — V 4.5 5.0 5.5 VIL VIH LOW-level input voltage HIGH-level input voltage — — V V 0.0 2.0 — — 0.8 5.0 lin (Input Leakage Current) Vin = VCC or GND — uA -1.0 — 1.0 5,7 Vcc min to max, Logic “0” or “1” — mA — 5 8 8 Icc (Quiescent Supply Current) Vcntrl = VCC or GND uA — 250 400 Turn-on Current6 For guaranteed start-up — mA — — 125 ΔIcc (Additional Supply Current Per TTL Input Pin) VCC = Max, Vcntrl = VCC - 2.1 V — mA — — 1.0 Switching Noise Generated from DC-DC Converter with recommended capacitors 3.5 MHz dBm — -93 — Thermal Resistance θjc — — °C/W — 15 — Icc 5. 6. 7. 8. During turn-on, the device requires an initial start up current (Icc) specified as “Turn-on Current”. Once operational, Icc will drop to the specified levels. This is not applicable to dual supply operation. The DC-DC converter is guaranteed to start in 100 µs as long as the power supplies have the maximum turn-on current available for start-up. For single supply operation For dual supply operation 2 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support MASWCC0010 GaAs SP4T Switch, Absorptive, Single Supply DC - 4.0 GHz Rev. V4 Truth Table (Switch) Absolute Maximum Ratings9,10 Parameter Absolute Maximum Max. Input Power 0.05 GHz 0.5 - 4.0 GHz11 +27 dBm +34 dBm VCC7 -0.5V ≤ VCC ≤ +6.0V VCC8 -0.5V ≤ VCC ≤ +7.0V VEE 8 VCC - VEE -8.5V ≤ VEE ≤ +0.5V 8 -0.5V ≤ VCC - VEE ≤ 14.5V Vin12 -0.5V ≤ Vin ≤ VCC + 0.5V Operating Temperature -40ºC to +85ºC Storage Temperature -65ºC to +125ºC Exceeding any one or combination of these limits may cause permanent damage to this device. 10. M/A-COM does not recommend sustained operation near these survivability limits. 11. When the RF input is applied to the terminated port, the absolute maximum power is +30 dBm. 12. Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply. C1 C2 C3 C4 RFCRF1 1 0 0 0 On Off Off Off 0 1 0 0 Off On Off Off 0 0 1 0 Off Off On Off 0 0 0 1 Off Off Off On “0” = TTL Low RFC- RFC- RFCRF2 RF3 RF4 “1” = TTL High Handling Procedures Please observe the following precautions to avoid damage: 9. Static Sensitivity Gallium Arsenide Integrated Circuits are sensitive to electrostatic discharge (ESD) and can be damaged by static electricity. Proper ESD control techniques should be used when handling these devices. Recommended PCB Configuration13 13. Application Note C2083 is available on line at www.macom.com 3 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support MASWCC0010 GaAs SP4T Switch, Absorptive, Single Supply DC - 4.0 GHz Rev. V4 Functional Schematic Typical Performance Curves Insertion Loss vs. Frequency - 4 0 °C + 2 5 °C Isolation (dB) vs. Frequency + 8 5 °C R F n- R F m 3.0 RFC-RFn 2.5 75 Isolation (dB) Insertion Loss (dB) 90 2.0 1.5 1.0 0.5 60 45 30 15 0.0 0 1000 2000 F re que nc y ( M H z) 3000 4000 0 0 1000 2000 3000 4000 F re que nc y ( M H z) 4 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support MASWCC0010 GaAs SP4T Switch, Absorptive, Single Supply DC - 4.0 GHz Rev. V4 Typical Performance Curves On VSWR vs. Frequency VSWR (Terminations) vs. Frequency R F OU T ( Of f ) RFC 2.00 1.80 1.80 VSWR VSWR R F O U T ( O n) 2.00 1.60 1.40 1.60 1.40 1.20 1.20 1.00 1.00 0 1000 2000 3000 4000 F re que nc y ( M H z) 0 1000 2000 3000 F requency (M H z) CSP-2, Lead-Free, 4 x 7 mm, 36-lead, PQFN† † 5 Reference Application Note M538 for lead-free solder reflow recommendations. M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support 4000 MASWCC0010 GaAs SP4T Switch, Absorptive, Single Supply DC - 4.0 GHz Rev. V4 M/A-COM Technology Solutions Inc. All rights reserved. Information in this document is provided in connection with M/A-COM Technology Solutions Inc ("MACOM") products. These materials are provided by MACOM as a service to its customers and may be used for informational purposes only. Except as provided in MACOM's Terms and Conditions of Sale for such products or in any separate agreement related to this document, MACOM assumes no liability whatsoever. MACOM assumes no responsibility for errors or omissions in these materials. MACOM may make changes to specifications and product descriptions at any time, without notice. MACOM makes no commitment to update the information and shall have no responsibility whatsoever for conflicts or incompatibilities arising from future changes to its specifications and product descriptions. No license, express or implied, by estoppels or otherwise, to any intellectual property rights is granted by this document. THESE MATERIALS ARE PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, RELATING TO SALE AND/OR USE OF MACOM PRODUCTS INCLUDING LIABILITY OR WARRANTIES RELATING TO FITNESS FOR A PARTICULAR PURPOSE, CONSEQUENTIAL OR INCIDENTAL DAMAGES, MERCHANTABILITY, OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. MACOM FURTHER DOES NOT WARRANT THE ACCURACY OR COMPLETENESS OF THE INFORMATION, TEXT, GRAPHICS OR OTHER ITEMS CONTAINED WITHIN THESE MATERIALS. MACOM SHALL NOT BE LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING WITHOUT LIMITATION, LOST REVENUES OR LOST PROFITS, WHICH MAY RESULT FROM THE USE OF THESE MATERIALS. 6 MACOM products are not intended for use in medical, lifesaving or life sustaining applications. MACOM customers using or selling MACOM products for use in such applications do so at their own risk and agree to fully indemnify MACOM for any damages resulting from such improper use or sale. M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support