rev.1.0 16.03.2015 S83300MG Description S83300MG is an infrared laser diode emitting at typically 830 nm with rated output power of 300 mW cw, in a standard 5.6 mm TO package with integrated monitor photodiode and flat window cap. Maximum Ratings (T CASE = 25°C) Parameter Symbol Values Max. 300 Min. Po Output power Unit mW LD Reverse Voltage VR 2 V PD Reverse Voltage VRPD 30 V Operating Temperature TCASE - 10 + 50 °C Storage Temperature TSTG - 40 + 85 °C Laser Characteristics (T CASE = Parameter 25°C, Po=300mW) Symbol λpeak Emission Wavelength Min. 820 Values Typ. 830 Max. 840 Unit nm Threshold Current Ith 115 130 mA Operating Current IF 410 450 mA Operating Voltage VF 1.85 2.0 V Parallel ӨII 9 14 deg Perpendicular Ө┴ 17 22 deg. Slope Efficiency (225mW – 75mW) η 1.0 PD Monitor Current Im Beam Divergence (FWHM) www.roithner-laser.com 0.1 0.5 mW/mA 1.0 mA 1 Performance Characteristics Optical Output Power vs Forward Current Forward Voltage vs. forward Current Peak Wavelength vs. Case Temperature www.roithner-laser.com 2 Far-Field Pattern Monitor Current vs. Optical Output Power Slope Efficiency vs. Case Temperature www.roithner-laser.com 3 Threshold Current vs. Case Temperature Drawing All dimensions in mm Electrical Connection Lead Pin 1 Pin 2 Pin 3 Description PD Anode LD Cathode LD Anode, PD Cathode, Ground www.roithner-laser.com 4 ESD Caution Always do handle laser diodes with extreme caution to prevent electrostatic discharge, the primary cause of unexpected diode failure. ESD failures can be prevented by always wearing wrist straps, only using a grounding workplace, and following strict anti-static guidelines when handling the laser diode Safety Advice This laser diode emits highly concentrated IR light which can be hazardous to the human eye and skin. This diode is classified as CLASS 3 laser product according to IEC 60825-1 and 21 CFR Part 1040.10 Safety Standards. Operating Considerations Operating the laser diode outside of its maximum ratings may cause failure or a safety hazard. The diode may be damaged by excessive drive currents or switching transients. If the diode is operated using a power supply, it is strongly recommended to connect the diode with the output voltage set to zero. The voltage should then be increased slowly and with great caution, while at the same time carefully monitoring the laser diodes output power and drive current. The laser diode will show accelerated degradation with increased temperature, and it is advised to keep the case temperature low therefor, by means of heat sinking the device. © All Rights Reserved The above specifications are for reference purpose only and subjected to change without prior notice www.roithner-laser.com 5