SRS Valve Manifold mountable plastic switching solenoid valve FEATURES · 3-way, 2 position valve (NO, NC & Distributor) · Design incorporates thermoplastics and non-corrosive metals · Offers high-density manifold mounting with convenient manifold to PC board interface · Weighs only 7 g, perfect where low weight is critical to overall system PHYSICAL PROPERTIES MEDIA COMPATIBILITY Gases and select liquids Operating environment 0 to 70 °C Storage temperature WETTED MATERIALS -40 to 70 °C Length Body: PBT; LNP Thermocomp® 38 mm (1.5 in) Width 10 mm (0.394 in) Elastomers: FKM Height 15.5 mm (0.61 in) Non-corrosive metals: 302 series stainless steel; 430 FR series stainless steel; CMI-B core iron; electroless nickel plating Porting Manifold mount, (gasket and screws supplied) Weight 7 g (0.23 oz) Power Voltage 0.0267 cm3 Internal volume ELECTRICAL 0.5, 1.0 or 2.0 W 5, 12, 24 VDC ± 10% Filtration (recommended) Lubrication 40 µm None required Thermocomp® is a registered trademark of General Electric Company. E / 11261 / A 1/5 www.first-sensor.com www.sensortechnics.com SRS Valve Manifold mountable plastic switching solenoid valve PERFORMANCE CHARACTERISTICS Part no. Pressure SRS10... 0...35 psig SRS11... 0...85 psig SRS13... 0...20 psig SRS14... 0...50 psig SRS16... 0...10 psig SRS17... 0...20 psig Vacuum Orifice siz es/ Equivalent CV1 Leak rate2 R esp o n se ≤0.016 sccm (bubble tight) <30 msec cycling (2 Watts) 0.020" (0.510 mm)/ 0.0075 CV 0...27 "Hg (0...13 psi) 0.030" (0.762 mm)/ 0.017 CV 0.045" (1.143 mm)/ 0.027 CV FLOW CURVES (typical air flow)3 Notes: 1 The CV value is the volume flow in US gallons/min under specific flow conditions and describes the relative flow capacity of a valve. If several valves with the same nominal diameter are compared, the valve with the highest CV value has the best flow dynamics design. The equivalent european measure is the kV value expressed in m3/h (kV = 0.86 CV). 2 sccm denotes Standard Cubic Centimeters per Minute. It is a unit for the flow rate at standard conditions of temperature and pressure. 1000 sccm = 1 slpm. 3 slpm denotes Standard Liters per Minute. It is a unit for the flow rate at standard conditions of temperature and pressure. 1 slpm = 1000 sccm. E / 11261 / A 2/5 www.first-sensor.com www.sensortechnics.com SRS Valve Manifold mountable plastic switching solenoid valve OUTLINE DRAWING dimensions in inches (mm) E / 11261 / A 3/5 www.first-sensor.com www.sensortechnics.com SRS Valve Manifold mountable plastic switching solenoid valve VALVE TYPE Type 1 N.C. PRESSURE N.O. VACUUM N.O. PRESSURE N.C. VACUUM DISTRIBUTOR PRESSURE DISTRIBUTOR VACUUM Type 2 Type 3 E / 11261 / A 4/5 www.first-sensor.com www.sensortechnics.com SRS Valve Manifold mountable plastic switching solenoid valve ELECTRICAL INTERFACE OPTIONS SRS...F (Square pins, front) SRS...M (Square pins, manifold) SRS...L (Wire leads) ORDERING INFORMATION Model no. Series Max. pressure SR S 10: 0...35 psi Options Material S eal material Voltage V: 5: C oi l wattage Type 0.020" 0.5 W 1: 3-way NC 1W 2: 3-way NO 12: 12 V D C 0.5 W 3: distributor 24: 24 VDC M: 0.025" square pins, manifold interface P: PBT FK M (0.510 mm) 11: 0...85 psi 0.020" (0.510 mm) 13: 0...20 psi 0.030" (0.762 mm) 14: 0...50 psi 0.030" 1W (0.762 mm) 16: 0...10 psi Electrical connection Orifice size 0.045" 5 V DC F: 0.025" square pins, front 0.5 W (1.143 mm) 17: 0...20 psi 0.045" 1W L: insulated wire leads, 18", front (1.143 mm) Example: SRS 10 2 P V 12 M Note: Not all combinations might be available. Please contact First Sensor for further information. First Sensor reserves the right to make changes to any products herein. First Sensor does not assume any liability arising out of the application or use of any product or circuit described herein, neither does it convey any license under its patent rights nor the rights of others. E / 11261 / A 5/5 www.first-sensor.com www.sensortechnics.com