File E116994 Vol. 1 Sec. 45 and Report Page 1 Issued: Revised: 1996-10-02 2005-04-06 D E S C R I P T I O N PRODUCT COVERED: Component - Switching Power Supplies, Medical and Dental, Models GPM41 followed by suffixes -5, -12, -15, -24 or -28, and Models MSP1579 and MSP1675. ELECTRICAL RATINGS: Input: Outputs: 100-240 V ac, 50/60 Hz, 1.3 A. GPM41-5 GPM41-12 GPM41-15 MSP1675 GPM41-24 GPM41-28 MSP1579 5 12 15 15 24 28 16.5 V, V, V, V, V, V, V, 6 A 3.3 2.7 2.7 1.7 1.4 2.4 A A A A A A ENGINEERING CONSIDERATIONS (NOT FOR FIELD REPRESENTATIVE'S USE): For use in product where the acceptability of the combination is determined by Underwriters Laboratories Inc. This product was evaluated to the First Edition of the Standard For Medical Electrical Equipment, Part 1: General Requirements for Safety, UL 60601-1 . An insulation diagram is provided as ILL. 1 and the manufacturer's installation instructions is provided as ILL. 4. Note: Model MSP1579 may not be provided with Installation Instructions. File E116994 Vol. 1 Sec. 45 and Report Page 2 Issued: Revised: 1996-10-02 2005-04-06 Condition of Acceptability - When installed in the end-use equipment, the following are among the considerations to be made: 1. This component has been judged on the basis of the required spacings in the First Edition of the Standards for Medical Electrical Equipment, Part 1: General Requirements for Safety, UL 60601-1, which covers the end use product for which the component is designed. 2. The component shall be installed in compliance with the enclosure, mounting, spacing, casualty markings and segregation requirements of the end-use application. 3. Consideration should be given to measuring the temperature on power electronic components and transformer windings when the power supply is installed in the end-use equipment. 4. The input/output connectors are not acceptable for field connections, they are only intended for connection to mating connectors of internal wiring inside the end-use machine. The output circuits have not been evaluated for direct patient connection (Type B, BF or CF). 5. The component should be properly bonded to ground in the end-use equipment. 6. The Temperature Test was performed in a raised ambient of 50°C. 7. The main isolation transformer, T2, complies with Class 155 limits. Certificate of Compliance Certificate: 1125259 (LR 46516C) Master Contract: 150684 Project: 1722945 Date Issued: 2005/10/21 Issued to: Condor D.C. Power Supplies Inc. 2311 Statham Pky Oxnard, CA 93033 USA Attention: Mr. Ross Sacolles The products listed below are eligible to bear the CSA Mark shown Issued by: Eugen Velea, MASc. E.Eng. Authorized by: Shane Stevenson, Product Group Manager PRODUCTS CLASS 5311 07 CLASS 5311 20 - POWER SUPPLIES - Component Type - (CSA 60950-1-03) - POWER SUPPLIES - Component Type - For Use in Medical Equipment !"#$%& % ' ( ) *+ ,%%%& %%% --# ... / ,%%% 0 ' ( ' #--$*"- 1& )-23- 45& #6 7 "- 8 0 . DQD 507 Rev. 2004-06-30 Certificate: 1125259 (LR 46516C) Master Contract: 150684 Project: 1722945 Date Issued: 2005/10/21 # 0 )- 9 * 0 : ( ; ' 4 .3 <& 6 ( $"- =+) 9 > $ $( !"#$%& % ' ( ) *+ ,%%%& %%% --# ... / ,%%% 0 ' ( ' #--$*"- 1& )-23- 45& #6 7 "- 8 0 #)?.& #--$*"-1& )-23- 45& #6 7 #3) 12*" #3?)& #--$*"-1& )-23- 45& #6 7 #) 12*? # 0 )- 9 * 0 : ( ; ' 4 .3 <& 6 ( $"- =+) 9 > $ $( " ( : / ) / @A1 ( ( 3 / ' ( "--- 1 / ( + ? @0 ' APPLICABLE REQUIREMENTS 2$*** 3-.)-$#$-6 /( @ & # ! ; 2$*** 3-## @ @ & # ! ; DQD 507 Rev. 2004-06-30