DJM Series • T3/DS3/E3/STS-1 Dual Interface Transformers These miniature modules contain both transmit and receive transformers designed for use in in T3/DS3 applications using bit rates off 44.736Mbps, E3 interfaces at 34.368Mbps and STS-1 applications at 51.84 Mbps The transformers are typical for 75 ohm bandwidth applications requiring a very fast rise times. Features • low cost SMD for pick and place compatability while providing consistent and reliable coplanarity • low leakage inductance • manufactured in an ISO-9001:2000, TS-16949:2002 and ISO-14001:2004 certified Talema facility • fully RoHS compliant and meets lead free reflow level J-STD-020C Electrical Specifications Ratings@ 25°C ambient Minimum isolation voltage: 1500 Vrms Extended Operating Temperature Range: -40° to +85°C DJM Series • Dual SMD Wideband Interface Transformers Extended Operating Temperature Range -40°C to +85°C Turns Ratio Pri/Sec ±2% Part Number TX RX DJM-100A 1:1 1:1 DJM-100B 1ct:1ct 1:1 DJM-100C 1:2ct 1:1 OCL Primary (μH Min) LL (μH Max) CWW (pF Max) Primary Pins Isolation RX TX RX TX RX Voltage (Vrms Min) 40 40 0.10 0.10 10 10 1500 1-2 7-8 100 100 0.11 0.11 10 10 1500 6-8 16-15 B 40 100 0.11 0.11 12 10 1500 16-14 6-8 C TX TX Schematic RX A DJM-100D 1:2ct 1:1 100 100 0.12 0.11 12 10 1500 7-8 16-15 D DJM-100E 1:2ct 1:2ct 40 40 0.11 0.11 12 12 1500 16-14 11-9 E DJM Dimensions Schematics Suggested Pad Layout 0.378 0.346 (9.60) (8.80) 0.028 (0.70) 0.050 (1.27) TALEMA IN WK/YR Part Number B A C 1 16 1 2 15 2 15 3 14 7 10 6 11 6 11 7 10 8 9 8 9 8 9 16 0.394 (10.60) 0.236 0.189 (6.00) (4.80) 0.350 (8.89) 0.504 (12.80) 2 0° - 8° 0.077 (1.96) 0.079 (2.00) 16 1 0.350 (8.89) 0.016 x 0.016 (0.40 x 0.40) D Surface coplanarity will be 0.004 (0.01) maximum 1 E 16 1 16 2 2 15 3 14 7 11 6 11 10 7 9 8 8 9 Dimensions: Inches (Millimeters) Tolerance: ±0.010 (0.25) unless specified otherwise Germany: Int.+49 89 - 841 00-0 • Ireland: Int.+35 374 - 954 8666 • Czech Rep: Int.+420 377-338 351 • India: Int.+91 427 - 244 1325 http://www.talema-nuvotem.com (10-07)Communications\E1-T1\DJM